From 60081dcc4fce385ade26d3145b2479789df0b7e5 Mon Sep 17 00:00:00 2001 From: Jian Shen Date: Tue, 14 Aug 2018 17:13:15 +0100 Subject: net: hns3: Fix for phy link issue when using marvell phy driver For marvell phy m88e1510, bit SUPPORTED_FIBRE of phydev->supported is default on. Both phy_resume() and phy_suspend() will check the SUPPORTED_FIBRE bit and write register of fibre page. Currently in hns3 driver, the SUPPORTED_FIBRE bit will be cleared after phy_connect_direct() finished. Because phy_resume() is called in phy_connect_direct(), and phy_suspend() is called when disconnect phy device, so the operation for fibre page register is not symmetrical. It will cause phy link issue when reload hns3 driver. This patch fixes it by disable the SUPPORTED_FIBRE before connecting phy. Fixes: 256727da7395 ("net: hns3: Add MDIO support to HNS3 Ethernet driver for hip08 SoC") Signed-off-by: Jian Shen Signed-off-by: Peng Li Signed-off-by: Salil Mehta Signed-off-by: David S. Miller --- drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c | 2 ++ 1 file changed, 2 insertions(+) (limited to 'drivers/net/ethernet/hisilicon/hns3') diff --git a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c index 85a123d40e8b..398971a062f4 100644 --- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c +++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c @@ -202,6 +202,8 @@ int hclge_mac_connect_phy(struct hclge_dev *hdev) if (!phydev) return 0; + phydev->supported &= ~SUPPORTED_FIBRE; + ret = phy_connect_direct(netdev, phydev, hclge_mac_adjust_link, PHY_INTERFACE_MODE_SGMII); -- cgit v1.2.3-59-g8ed1b