From 9f0b8516198e8b0919774a1874fab064a2ea3ae8 Mon Sep 17 00:00:00 2001 From: Matthew Vick Date: Tue, 16 Oct 2012 07:44:45 +0000 Subject: igb: Enable auto-crossover during forced operation on 82580 and above. Newer devices supported by igb can support auto-crossover detection in forced operation modes. Enable this in the driver, rather than clobbering this functionality in forced operation. Signed-off-by: Matthew Vick Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/igb/e1000_phy.c | 29 +++++++++++++++++------------ 1 file changed, 17 insertions(+), 12 deletions(-) (limited to 'drivers/net/ethernet/intel/igb/e1000_phy.c') diff --git a/drivers/net/ethernet/intel/igb/e1000_phy.c b/drivers/net/ethernet/intel/igb/e1000_phy.c index c62a4c388194..fe76004aca4e 100644 --- a/drivers/net/ethernet/intel/igb/e1000_phy.c +++ b/drivers/net/ethernet/intel/igb/e1000_phy.c @@ -1207,20 +1207,25 @@ s32 igb_phy_force_speed_duplex_m88(struct e1000_hw *hw) u16 phy_data; bool link; - /* - * Clear Auto-Crossover to force MDI manually. M88E1000 requires MDI - * forced whenever speed and duplex are forced. - */ - ret_val = phy->ops.read_reg(hw, M88E1000_PHY_SPEC_CTRL, &phy_data); - if (ret_val) - goto out; + /* I210 and I211 devices support Auto-Crossover in forced operation. */ + if (phy->type != e1000_phy_i210) { + /* + * Clear Auto-Crossover to force MDI manually. M88E1000 + * requires MDI forced whenever speed and duplex are forced. + */ + ret_val = phy->ops.read_reg(hw, M88E1000_PHY_SPEC_CTRL, + &phy_data); + if (ret_val) + goto out; - phy_data &= ~M88E1000_PSCR_AUTO_X_MODE; - ret_val = phy->ops.write_reg(hw, M88E1000_PHY_SPEC_CTRL, phy_data); - if (ret_val) - goto out; + phy_data &= ~M88E1000_PSCR_AUTO_X_MODE; + ret_val = phy->ops.write_reg(hw, M88E1000_PHY_SPEC_CTRL, + phy_data); + if (ret_val) + goto out; - hw_dbg("M88E1000 PSCR: %X\n", phy_data); + hw_dbg("M88E1000 PSCR: %X\n", phy_data); + } ret_val = phy->ops.read_reg(hw, PHY_CONTROL, &phy_data); if (ret_val) -- cgit v1.2.3-59-g8ed1b