From 3ec0a0f10ceb77c78f540ded1d13bf0cf7f89a07 Mon Sep 17 00:00:00 2001 From: Harini Katakam Date: Mon, 27 Jun 2016 13:09:59 +0530 Subject: net: marvell: Add separate config ANEG function for Marvell 88E1111 Marvell 88E1111 currently uses the generic marvell config ANEG function. This function has a sequence accessing Page 5 and Register 31, both of which are not defined or reserved for this PHY. Hence this patch adds a new config ANEG function for Marvell 88E1111 without these erroneous accesses. Signed-off-by: Harini Katakam Signed-off-by: David S. Miller --- drivers/net/phy/marvell.c | 44 +++++++++++++++++++++++++++++++++++++++++++- 1 file changed, 43 insertions(+), 1 deletion(-) (limited to 'drivers/net/phy') diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c index 79ccc11facc3..ec2c1eee6405 100644 --- a/drivers/net/phy/marvell.c +++ b/drivers/net/phy/marvell.c @@ -285,6 +285,48 @@ static int marvell_config_aneg(struct phy_device *phydev) return 0; } +static int m88e1111_config_aneg(struct phy_device *phydev) +{ + int err; + + /* The Marvell PHY has an errata which requires + * that certain registers get written in order + * to restart autonegotiation + */ + err = phy_write(phydev, MII_BMCR, BMCR_RESET); + + err = marvell_set_polarity(phydev, phydev->mdix); + if (err < 0) + return err; + + err = phy_write(phydev, MII_M1111_PHY_LED_CONTROL, + MII_M1111_PHY_LED_DIRECT); + if (err < 0) + return err; + + err = genphy_config_aneg(phydev); + if (err < 0) + return err; + + if (phydev->autoneg != AUTONEG_ENABLE) { + int bmcr; + + /* A write to speed/duplex bits (that is performed by + * genphy_config_aneg() call above) must be followed by + * a software reset. Otherwise, the write has no effect. + */ + bmcr = phy_read(phydev, MII_BMCR); + if (bmcr < 0) + return bmcr; + + err = phy_write(phydev, MII_BMCR, bmcr | BMCR_RESET); + if (err < 0) + return err; + } + + return 0; +} + #ifdef CONFIG_OF_MDIO /* * Set and/or override some configuration registers based on the @@ -1175,7 +1217,7 @@ static struct phy_driver marvell_drivers[] = { .flags = PHY_HAS_INTERRUPT, .probe = marvell_probe, .config_init = &m88e1111_config_init, - .config_aneg = &marvell_config_aneg, + .config_aneg = &m88e1111_config_aneg, .read_status = &marvell_read_status, .ack_interrupt = &marvell_ack_interrupt, .config_intr = &marvell_config_intr, -- cgit v1.2.3-59-g8ed1b