From 2cd451792db174382aaca96c75bc3bf47a6065fe Mon Sep 17 00:00:00 2001 From: Daniel Mack Date: Wed, 14 Nov 2012 11:14:26 +0800 Subject: spi/omap: fix D0/D1 direction confusion 0384e90b8 ("spi/mcspi: allow configuration of pin directions") did what it claimed to do the wrong way around. D0/D1 is configured as output by *clearing* the bits in the conf registers, hence also breaking the former default behaviour. Fix this before that change is merged to mainline. Signed-off-by: Daniel Mack Signed-off-by: Mark Brown --- drivers/spi/spi-omap2-mcspi.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'drivers/spi') diff --git a/drivers/spi/spi-omap2-mcspi.c b/drivers/spi/spi-omap2-mcspi.c index 51046332677c..89f73c425c3d 100644 --- a/drivers/spi/spi-omap2-mcspi.c +++ b/drivers/spi/spi-omap2-mcspi.c @@ -766,7 +766,7 @@ static int omap2_mcspi_setup_transfer(struct spi_device *spi, /* standard 4-wire master mode: SCK, MOSI/out, MISO/in, nCS * REVISIT: this controller could support SPI_3WIRE mode. */ - if (mcspi->pin_dir == MCSPI_PINDIR_D0_OUT_D1_IN) { + if (mcspi->pin_dir == MCSPI_PINDIR_D0_IN_D1_OUT) { l &= ~OMAP2_MCSPI_CHCONF_IS; l &= ~OMAP2_MCSPI_CHCONF_DPE1; l |= OMAP2_MCSPI_CHCONF_DPE0; @@ -1188,8 +1188,8 @@ static int __devinit omap2_mcspi_probe(struct platform_device *pdev) of_property_read_u32(node, "ti,spi-num-cs", &num_cs); master->num_chipselect = num_cs; master->bus_num = bus_num++; - if (of_get_property(node, "ti,pindir-d0-in-d1-out", NULL)) - mcspi->pin_dir = MCSPI_PINDIR_D0_IN_D1_OUT; + if (of_get_property(node, "ti,pindir-d0-out-d1-in", NULL)) + mcspi->pin_dir = MCSPI_PINDIR_D0_OUT_D1_IN; } else { pdata = pdev->dev.platform_data; master->num_chipselect = pdata->num_cs; -- cgit v1.2.3-59-g8ed1b