From 249a32b7eeb3edb6897dd38f89651a62163ac4ed Mon Sep 17 00:00:00 2001 From: Bin Liu Date: Thu, 19 Jul 2018 14:39:37 -0500 Subject: usb: core: handle hub C_PORT_OVER_CURRENT condition Based on USB2.0 Spec Section 11.12.5, "If a hub has per-port power switching and per-port current limiting, an over-current on one port may still cause the power on another port to fall below specific minimums. In this case, the affected port is placed in the Power-Off state and C_PORT_OVER_CURRENT is set for the port, but PORT_OVER_CURRENT is not set." so let's check C_PORT_OVER_CURRENT too for over current condition. Fixes: 08d1dec6f405 ("usb:hub set hub->change_bits when over-current happens") Cc: Tested-by: Alessandro Antenucci Signed-off-by: Bin Liu Acked-by: Alan Stern Signed-off-by: Greg Kroah-Hartman --- drivers/usb/core/hub.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) (limited to 'drivers/usb') diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c index fcae521df29b..1fb266809966 100644 --- a/drivers/usb/core/hub.c +++ b/drivers/usb/core/hub.c @@ -1142,10 +1142,14 @@ static void hub_activate(struct usb_hub *hub, enum hub_activation_type type) if (!udev || udev->state == USB_STATE_NOTATTACHED) { /* Tell hub_wq to disconnect the device or - * check for a new connection + * check for a new connection or over current condition. + * Based on USB2.0 Spec Section 11.12.5, + * C_PORT_OVER_CURRENT could be set while + * PORT_OVER_CURRENT is not. So check for any of them. */ if (udev || (portstatus & USB_PORT_STAT_CONNECTION) || - (portstatus & USB_PORT_STAT_OVERCURRENT)) + (portstatus & USB_PORT_STAT_OVERCURRENT) || + (portchange & USB_PORT_STAT_C_OVERCURRENT)) set_bit(port1, hub->change_bits); } else if (portstatus & USB_PORT_STAT_ENABLE) { -- cgit v1.2.3-59-g8ed1b