From 828e66c0edf97bcb79b59b1ddd803a50629b3937 Mon Sep 17 00:00:00 2001 From: Jan Luebbe Date: Wed, 8 Jul 2015 16:35:27 +0200 Subject: i2c: omap: fix bus recovery setup At least on the AM335x, enabling OMAP_I2C_SYSTEST_ST_EN is not enough to allow direct access to the SCL and SDA pins. In addition to ST_EN, we need to set the TMODE to 0b11 (Loop back & SDA/SCL IO mode select). Also, as the reset values of SCL_O and SDA_O are 0 (which means "drive low level"), we need to set them to 1 (which means "high-impedance") to avoid unwanted changes on the pins. As a precaution, reset all these bits to their default values after recovery is complete. Signed-off-by: Jan Luebbe Tested-by: Alexander Sverdlin Reviewed-by: Grygorii Strashko Signed-off-by: Wolfram Sang --- drivers/i2c/busses/i2c-omap.c | 11 +++++++++++ 1 file changed, 11 insertions(+) (limited to 'drivers') diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c index d1c22e3fdd14..fc9bf7f30e35 100644 --- a/drivers/i2c/busses/i2c-omap.c +++ b/drivers/i2c/busses/i2c-omap.c @@ -1247,7 +1247,14 @@ static void omap_i2c_prepare_recovery(struct i2c_adapter *adap) u32 reg; reg = omap_i2c_read_reg(dev, OMAP_I2C_SYSTEST_REG); + /* enable test mode */ reg |= OMAP_I2C_SYSTEST_ST_EN; + /* select SDA/SCL IO mode */ + reg |= 3 << OMAP_I2C_SYSTEST_TMODE_SHIFT; + /* set SCL to high-impedance state (reset value is 0) */ + reg |= OMAP_I2C_SYSTEST_SCL_O; + /* set SDA to high-impedance state (reset value is 0) */ + reg |= OMAP_I2C_SYSTEST_SDA_O; omap_i2c_write_reg(dev, OMAP_I2C_SYSTEST_REG, reg); } @@ -1257,7 +1264,11 @@ static void omap_i2c_unprepare_recovery(struct i2c_adapter *adap) u32 reg; reg = omap_i2c_read_reg(dev, OMAP_I2C_SYSTEST_REG); + /* restore reset values */ reg &= ~OMAP_I2C_SYSTEST_ST_EN; + reg &= ~OMAP_I2C_SYSTEST_TMODE_MASK; + reg &= ~OMAP_I2C_SYSTEST_SCL_O; + reg &= ~OMAP_I2C_SYSTEST_SDA_O; omap_i2c_write_reg(dev, OMAP_I2C_SYSTEST_REG, reg); } -- cgit v1.2.3-59-g8ed1b