From 899a3cbbf77a2a3d6d53d67ff6f10ad59eb03605 Mon Sep 17 00:00:00 2001 From: Heiner Kallweit Date: Sat, 10 Nov 2018 23:40:50 +0100 Subject: net: phy: remove states PHY_STARTING and PHY_PENDING Both states aren't used. Most likely they result from an idea that never materialized. So remove them. Signed-off-by: Heiner Kallweit Signed-off-by: David S. Miller --- include/linux/phy.h | 22 ++-------------------- 1 file changed, 2 insertions(+), 20 deletions(-) (limited to 'include/linux/phy.h') diff --git a/include/linux/phy.h b/include/linux/phy.h index 03005c65e02d..a5bcb4aaa48e 100644 --- a/include/linux/phy.h +++ b/include/linux/phy.h @@ -270,29 +270,13 @@ struct phy_device *mdiobus_scan(struct mii_bus *bus, int addr); * DOWN: PHY device and driver are not ready for anything. probe * should be called if and only if the PHY is in this state, * given that the PHY device exists. - * - PHY driver probe function will, depending on the PHY, set - * the state to STARTING or READY - * - * STARTING: PHY device is coming up, and the ethernet driver is - * not ready. PHY drivers may set this in the probe function. - * If they do, they are responsible for making sure the state is - * eventually set to indicate whether the PHY is UP or READY, - * depending on the state when the PHY is done starting up. - * - PHY driver will set the state to READY - * - start will set the state to PENDING + * - PHY driver probe function will set the state to READY * * READY: PHY is ready to send and receive packets, but the * controller is not. By default, PHYs which do not implement - * probe will be set to this state by phy_probe(). If the PHY - * driver knows the PHY is ready, and the PHY state is STARTING, - * then it sets this STATE. + * probe will be set to this state by phy_probe(). * - start will set the state to UP * - * PENDING: PHY device is coming up, but the ethernet driver is - * ready. phy_start will set this state if the PHY state is - * STARTING. - * - PHY driver will set the state to UP when the PHY is ready - * * UP: The PHY and attached device are ready to do work. * Interrupts should be started here. * - timer moves to NOLINK or RUNNING @@ -329,9 +313,7 @@ struct phy_device *mdiobus_scan(struct mii_bus *bus, int addr); */ enum phy_state { PHY_DOWN = 0, - PHY_STARTING, PHY_READY, - PHY_PENDING, PHY_UP, PHY_RUNNING, PHY_NOLINK, -- cgit v1.2.3-59-g8ed1b