From 12a40a57f762f569f58a393437d8c13864db390a Mon Sep 17 00:00:00 2001 From: Huang Shijie Date: Mon, 27 Sep 2010 10:43:53 +0800 Subject: mtd: add init_size hook for NAND driver Not all the NAND devices have all the information in additional id bytes. So add a hook in the nand_chip{} is a good method to calculate the right value of oobsize, erasesize and so on. Without the hook,you will get the wrong value, and you have to hack in the ->scan_bbt() to change the wrong value which make the code mess. Signed-off-by: Huang Shijie Signed-off-by: David Woodhouse --- include/linux/mtd/nand.h | 6 ++++++ 1 file changed, 6 insertions(+) (limited to 'include/linux') diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h index 7666c42235c7..0f744547a48c 100644 --- a/include/linux/mtd/nand.h +++ b/include/linux/mtd/nand.h @@ -396,6 +396,10 @@ struct nand_buffers { * @block_markbad: [REPLACEABLE] mark the block bad * @cmd_ctrl: [BOARDSPECIFIC] hardwarespecific funtion for controlling * ALE/CLE/nCE. Also used to write command and address + * @init_size: [BOARDSPECIFIC] hardwarespecific funtion for setting + * mtd->oobsize, mtd->writesize and so on. + * @id_data contains the 8 bytes values of NAND_CMD_READID. + * Return with the bus width. * @dev_ready: [BOARDSPECIFIC] hardwarespecific function for accesing device ready/busy line * If set to NULL no access to ready/busy is available and the ready/busy information * is read from the chip status register @@ -452,6 +456,8 @@ struct nand_chip { int (*block_markbad)(struct mtd_info *mtd, loff_t ofs); void (*cmd_ctrl)(struct mtd_info *mtd, int dat, unsigned int ctrl); + int (*init_size)(struct mtd_info *mtd, + struct nand_chip *this, u8 *id_data); int (*dev_ready)(struct mtd_info *mtd); void (*cmdfunc)(struct mtd_info *mtd, unsigned command, int column, int page_addr); int (*waitfunc)(struct mtd_info *mtd, struct nand_chip *this); -- cgit v1.2.3-59-g8ed1b