From 39b0c705195e9409dc8a40cc82b11d81405a4a4b Mon Sep 17 00:00:00 2001 From: Andrew Lunn Date: Mon, 31 Aug 2015 15:56:49 +0200 Subject: net: dsa: Allow configuration of CPU & DSA port speeds/duplex By default, DSA and CPU ports are configured to the maximum speed the switch supports. However there can be use cases where the peer devices port is slower. Allow a fixed-link property to be used with the DSA and CPU port in the device tree, and use this information to configure the port. Signed-off-by: Andrew Lunn Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller --- net/dsa/dsa.c | 37 +++++++++++++++++++++++++++++++++++++ 1 file changed, 37 insertions(+) (limited to 'net/dsa') diff --git a/net/dsa/dsa.c b/net/dsa/dsa.c index 053eb2b8e682..afff17341b73 100644 --- a/net/dsa/dsa.c +++ b/net/dsa/dsa.c @@ -176,6 +176,35 @@ __ATTRIBUTE_GROUPS(dsa_hwmon); #endif /* CONFIG_NET_DSA_HWMON */ /* basic switch operations **************************************************/ +static int dsa_cpu_dsa_setup(struct dsa_switch *ds, struct net_device *master) +{ + struct dsa_chip_data *cd = ds->pd; + struct device_node *port_dn; + struct phy_device *phydev; + int ret, port; + + for (port = 0; port < DSA_MAX_PORTS; port++) { + if (!(dsa_is_cpu_port(ds, port) || dsa_is_dsa_port(ds, port))) + continue; + + port_dn = cd->port_dn[port]; + if (of_phy_is_fixed_link(port_dn)) { + ret = of_phy_register_fixed_link(port_dn); + if (ret) { + netdev_err(master, + "failed to register fixed PHY\n"); + return ret; + } + phydev = of_phy_find_device(port_dn); + genphy_config_init(phydev); + genphy_read_status(phydev); + if (ds->drv->adjust_link) + ds->drv->adjust_link(ds, port, phydev); + } + } + return 0; +} + static int dsa_switch_setup_one(struct dsa_switch *ds, struct device *parent) { struct dsa_switch_driver *drv = ds->drv; @@ -297,6 +326,14 @@ static int dsa_switch_setup_one(struct dsa_switch *ds, struct device *parent) } } + /* Perform configuration of the CPU and DSA ports */ + ret = dsa_cpu_dsa_setup(ds, dst->master_netdev); + if (ret < 0) { + netdev_err(dst->master_netdev, "[%d] : can't configure CPU and DSA ports\n", + index); + ret = 0; + } + #ifdef CONFIG_NET_DSA_HWMON /* If the switch provides a temperature sensor, * register with hardware monitoring subsystem. -- cgit v1.2.3-59-g8ed1b