From 6d608f06e390d803c1d0e604cae280f1e708bf68 Mon Sep 17 00:00:00 2001 From: Steffen Klassert Date: Fri, 21 Feb 2014 08:41:09 +0100 Subject: ip_tunnel: Make vti work with i_key set Vti uses the o_key to mark packets that were transmitted or received by a vti interface. Unfortunately we can't apply different marks to in and outbound packets with only one key availabe. Vti interfaces typically use wildcard selectors for vti IPsec policies. On forwarding, the same output policy will match for both directions. This generates a loop between the IPsec gateways until the ttl of the packet is exceeded. The gre i_key/o_key are usually there to find the right gre tunnel during a lookup. When vti uses the i_key to mark packets, the tunnel lookup does not work any more because vti does not use the gre keys as a hash key for the lookup. This patch workarounds this my not including the i_key when comupting the hash for the tunnel lookup in case of vti tunnels. With this we have separate keys available for the transmitting and receiving side of the vti interface. Signed-off-by: Steffen Klassert --- net/ipv4/ip_tunnel.c | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-) (limited to 'net/ipv4/ip_tunnel.c') diff --git a/net/ipv4/ip_tunnel.c b/net/ipv4/ip_tunnel.c index 6d430ff2ba29..4fff64418fb2 100644 --- a/net/ipv4/ip_tunnel.c +++ b/net/ipv4/ip_tunnel.c @@ -280,13 +280,17 @@ static struct hlist_head *ip_bucket(struct ip_tunnel_net *itn, { unsigned int h; __be32 remote; + __be32 i_key = parms->i_key; if (parms->iph.daddr && !ipv4_is_multicast(parms->iph.daddr)) remote = parms->iph.daddr; else remote = 0; - h = ip_tunnel_hash(parms->i_key, remote); + if (!(parms->i_flags & TUNNEL_KEY) && (parms->i_flags & VTI_ISVTI)) + i_key = 0; + + h = ip_tunnel_hash(i_key, remote); return &itn->tunnels[h]; } -- cgit v1.2.3-59-g8ed1b