Say you've got a big slow raid 6, and an ssd or three. Wouldn't it be nice if you could use them as cache... Hence bcache. Wiki and git repositories are at: http://bcache.evilpiepirate.org http://evilpiepirate.org/git/linux-bcache.git http://evilpiepirate.org/git/bcache-tools.git It's designed around the performance characteristics of SSDs - it only allocates in erase block sized buckets, and it uses a hybrid btree/log to track cached extents (which can be anywhere from a single sector to the bucket size). It's designed to avoid random writes at all costs; it fills up an erase block sequentially, then issues a discard before reusing it. Both writethrough and writeback caching are supported. Writeback defaults to off, but can be switched on and off arbitrarily at runtime. Bcache goes to great lengths to protect your data - it reliably handles unclean shutdown. (It doesn't even have a notion of a clean shutdown; bcache simply doesn't return writes as completed until they're on stable storage). Writeback caching can use most of the cache for buffering writes - writing dirty data to the backing device is always done sequentially, scanning from the start to the end of the index. Since random IO is what SSDs excel at, there generally won't be much benefit to caching large sequential IO. Bcache detects sequential IO and skips it; it also keeps a rolling average of the IO sizes per task, and as long as the average is above the cutoff it will skip all IO from that task - instead of caching the first 512k after every seek. Backups and large file copies should thus entirely bypass the cache. In the event of a data IO error on the flash it will try to recover by reading from disk or invalidating cache entries. For unrecoverable errors (meta data or dirty data), caching is automatically disabled; if dirty data was present in the cache it first disables writeback caching and waits for all dirty data to be flushed. Getting started: You'll need make-bcache from the bcache-tools repository. Both the cache device and backing device must be formatted before use. make-bcache -B /dev/sdb make-bcache -C /dev/sdc make-bcache has the ability to format multiple devices at the same time - if you format your backing devices and cache device at the same time, you won't have to manually attach: make-bcache -B /dev/sda /dev/sdb -C /dev/sdc bcache-tools now ships udev rules, and bcache devices are known to the kernel immediately. Without udev, you can manually register devices like this: echo /dev/sdb > /sys/fs/bcache/register echo /dev/sdc > /sys/fs/bcache/register Registering the backing device makes the bcache device show up in /dev; you can now format it and use it as normal. But the first time using a new bcache device, it'll be running in passthrough mode until you attach it to a cache. If you are thinking about using bcache later, it is recommended to setup all your slow devices as bcache backing devices without a cache, and you can choose to add a caching device later. See 'ATTACHING' section below. The devices show up as: /dev/bcache As well as (with udev): /dev/bcache/by-uuid/ /dev/bcache/by-label/