# # HISILICON device configuration # config NET_VENDOR_HISILICON bool "Hisilicon devices" default y depends on (OF || ACPI) && HAS_DMA depends on ARM || ARM64 || COMPILE_TEST ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Hisilicon devices. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_HISILICON config HIX5HD2_GMAC tristate "Hisilicon HIX5HD2 Family Network Device Support" select PHYLIB help This selects the hix5hd2 mac family network device. config HISI_FEMAC tristate "Hisilicon Fast Ethernet MAC device support" depends on HAS_IOMEM select PHYLIB select RESET_CONTROLLER help This selects the Hisilicon Fast Ethernet MAC device(FEMAC). The FEMAC receives and transmits data over Ethernet ports at 10/100 Mbps in full-duplex or half-duplex mode. The FEMAC exchanges data with the CPU, and supports the energy efficient Ethernet (EEE). config HIP04_ETH tristate "HISILICON P04 Ethernet support" depends on HAS_IOMEM # For MFD_SYSCON select MARVELL_PHY select MFD_SYSCON select HNS_MDIO ---help--- If you wish to compile a kernel for a hardware with hisilicon p04 SoC and want to use the internal ethernet then you should answer Y to this. config HNS_MDIO tristate select PHYLIB ---help--- This selects the HNS MDIO support. It is needed by HNS_DSAF to access the PHY config HNS tristate "Hisilicon Network Subsystem Support (Framework)" ---help--- This selects the framework support for Hisilicon Network Subsystem. It is needed by any driver which provides HNS acceleration engine or make use of the engine config HNS_DSAF tristate "Hisilicon HNS DSAF device Support" select HNS select HNS_MDIO ---help--- This selects the DSAF (Distributed System Area Frabric) network acceleration engine support. The engine is used in Hisilicon hip05, Hi1610 and further ICT SoC config HNS_ENET tristate "Hisilicon HNS Ethernet Device Support" select PHYLIB select HNS ---help--- This selects the general ethernet driver for HNS. This module make use of any HNS AE driver, such as HNS_DSAF endif # NET_VENDOR_HISILICON