#ifndef __LINUX_ATMEL_MCI_H #define __LINUX_ATMEL_MCI_H #define ATMEL_MCI_MAX_NR_SLOTS 2 /** * struct mci_slot_pdata - board-specific per-slot configuration * @bus_width: Number of data lines wired up the slot * @detect_pin: GPIO pin wired to the card detect switch * @wp_pin: GPIO pin wired to the write protect sensor * @detect_is_active_high: The state of the detect pin when it is active * * If a given slot is not present on the board, @bus_width should be * set to 0. The other fields are ignored in this case. * * Any pins that aren't available should be set to a negative value. * * Note that support for multiple slots is experimental -- some cards * might get upset if we don't get the clock management exactly right. * But in most cases, it should work just fine. */ struct mci_slot_pdata { unsigned int bus_width; int detect_pin; int wp_pin; bool detect_is_active_high; }; /** * struct mci_platform_data - board-specific MMC/SDcard configuration * @dma_slave: DMA slave interface to use in data transfers. * @slot: Per-slot configuration data. */ struct mci_platform_data { struct mci_dma_data *dma_slave; struct mci_slot_pdata slot[ATMEL_MCI_MAX_NR_SLOTS]; }; #endif /* __LINUX_ATMEL_MCI_H */