1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
|
/*
* Cobalt Qube/Raq PCI support
*
* This file is subject to the terms and conditions of the GNU General Public
* License. See the file "COPYING" in the main directory of this archive
* for more details.
*
* Copyright (C) 1995, 1996, 1997, 2002, 2003 by Ralf Baechle
* Copyright (C) 2001, 2002, 2003 by Liam Davies (ldavies@agile.tv)
*/
#include <linux/types.h>
#include <linux/pci.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <asm/pci.h>
#include <asm/io.h>
#include <asm/gt64120.h>
#include <cobalt.h>
#include <irq.h>
/*
* PCI slot numbers
*/
#define COBALT_PCICONF_CPU 0x06
#define COBALT_PCICONF_ETH0 0x07
#define COBALT_PCICONF_RAQSCSI 0x08
#define COBALT_PCICONF_VIA 0x09
#define COBALT_PCICONF_PCISLOT 0x0A
#define COBALT_PCICONF_ETH1 0x0C
/*
* The Cobalt board ID information. The boards have an ID number wired
* into the VIA that is available in the high nibble of register 94.
*/
#define VIA_COBALT_BRD_ID_REG 0x94
#define VIA_COBALT_BRD_REG_to_ID(reg) ((unsigned char)(reg) >> 4)
static void qube_raq_galileo_early_fixup(struct pci_dev *dev)
{
if (dev->devfn == PCI_DEVFN(0, 0) &&
(dev->class >> 8) == PCI_CLASS_MEMORY_OTHER) {
dev->class = (PCI_CLASS_BRIDGE_HOST << 8) | (dev->class & 0xff);
printk(KERN_INFO "Galileo: fixed bridge class\n");
}
}
DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_MARVELL, PCI_DEVICE_ID_MARVELL_GT64111,
qube_raq_galileo_early_fixup);
static void qube_raq_via_bmIDE_fixup(struct pci_dev *dev)
{
unsigned short cfgword;
unsigned char lt;
/* Enable Bus Mastering and fast back to back. */
pci_read_config_word(dev, PCI_COMMAND, &cfgword);
cfgword |= (PCI_COMMAND_FAST_BACK | PCI_COMMAND_MASTER);
pci_write_config_word(dev, PCI_COMMAND, cfgword);
/* Enable both ide interfaces. ROM only enables primary one. */
pci_write_config_byte(dev, 0x40, 0xb);
/* Set latency timer to reasonable value. */
pci_read_config_byte(dev, PCI_LATENCY_TIMER, <);
if (lt < 64)
pci_write_config_byte(dev, PCI_LATENCY_TIMER, 64);
pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 8);
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_1,
qube_raq_via_bmIDE_fixup);
static void qube_raq_galileo_fixup(struct pci_dev *dev)
{
if (dev->devfn != PCI_DEVFN(0, 0))
return;
/* Fix PCI latency-timer and cache-line-size values in Galileo
* host bridge.
*/
pci_write_config_byte(dev, PCI_LATENCY_TIMER, 64);
pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 8);
/*
* The code described by the comment below has been removed
* as it causes bus mastering by the Ethernet controllers
* to break under any kind of network load. We always set
* the retry timeouts to their maximum.
*
* --x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--
*
* On all machines prior to Q2, we had the STOP line disconnected
* from Galileo to VIA on PCI. The new Galileo does not function
* correctly unless we have it connected.
*
* Therefore we must set the disconnect/retry cycle values to
* something sensible when using the new Galileo.
*/
printk(KERN_INFO "Galileo: revision %u\n", dev->revision);
#if 0
if (dev->revision >= 0x10) {
/* New Galileo, assumes PCI stop line to VIA is connected. */
GT_WRITE(GT_PCI0_TOR_OFS, 0x4020);
} else if (dev->revision == 0x1 || dev->revision == 0x2)
#endif
{
signed int timeo;
/* XXX WE MUST DO THIS ELSE GALILEO LOCKS UP! -DaveM */
timeo = GT_READ(GT_PCI0_TOR_OFS);
/* Old Galileo, assumes PCI STOP line to VIA is disconnected. */
GT_WRITE(GT_PCI0_TOR_OFS,
(0xff << 16) | /* retry count */
(0xff << 8) | /* timeout 1 */
0xff); /* timeout 0 */
/* enable PCI retry exceeded interrupt */
GT_WRITE(GT_INTRMASK_OFS, GT_INTR_RETRYCTR0_MSK | GT_READ(GT_INTRMASK_OFS));
}
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_MARVELL, PCI_DEVICE_ID_MARVELL_GT64111,
qube_raq_galileo_fixup);
int cobalt_board_id;
static void qube_raq_via_board_id_fixup(struct pci_dev *dev)
{
u8 id;
int retval;
retval = pci_read_config_byte(dev, VIA_COBALT_BRD_ID_REG, &id);
if (retval) {
panic("Cannot read board ID");
return;
}
cobalt_board_id = VIA_COBALT_BRD_REG_to_ID(id);
printk(KERN_INFO "Cobalt board ID: %d\n", cobalt_board_id);
}
DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_0,
qube_raq_via_board_id_fixup);
static char irq_tab_qube1[] __initdata = {
[COBALT_PCICONF_CPU] = 0,
[COBALT_PCICONF_ETH0] = QUBE1_ETH0_IRQ,
[COBALT_PCICONF_RAQSCSI] = SCSI_IRQ,
[COBALT_PCICONF_VIA] = 0,
[COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
[COBALT_PCICONF_ETH1] = 0
};
static char irq_tab_cobalt[] __initdata = {
[COBALT_PCICONF_CPU] = 0,
[COBALT_PCICONF_ETH0] = ETH0_IRQ,
[COBALT_PCICONF_RAQSCSI] = SCSI_IRQ,
[COBALT_PCICONF_VIA] = 0,
[COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
[COBALT_PCICONF_ETH1] = ETH1_IRQ
};
static char irq_tab_raq2[] __initdata = {
[COBALT_PCICONF_CPU] = 0,
[COBALT_PCICONF_ETH0] = ETH0_IRQ,
[COBALT_PCICONF_RAQSCSI] = RAQ2_SCSI_IRQ,
[COBALT_PCICONF_VIA] = 0,
[COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
[COBALT_PCICONF_ETH1] = ETH1_IRQ
};
int __init pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
{
if (cobalt_board_id < COBALT_BRD_ID_QUBE2)
return irq_tab_qube1[slot];
if (cobalt_board_id == COBALT_BRD_ID_RAQ2)
return irq_tab_raq2[slot];
return irq_tab_cobalt[slot];
}
/* Do platform specific device initialization at pci_enable_device() time */
int pcibios_plat_dev_init(struct pci_dev *dev)
{
return 0;
}
|
