aboutsummaryrefslogtreecommitdiffstats
path: root/tools/perf/scripts/python/call-graph-from-postgresql.py (unfollow)
AgeCommit message (Collapse)AuthorFilesLines
2015-12-23ASoC: rt5677: set PLL_CTRL2 non-volatileBard Liao1-2/+0
There is a status bit on RT5677_PLL1_CTRL2 and RT5677_PLL2_CTRL2. That's why those registers are set volatile. However, the status bit is currently not used by codec driver. So, it should be no problem if we set them non-volatile. The purpose of setting them non-volatile is to restore the setting after a syspend/resume cycle. Signed-off-by: Bard Liao <bardliao@realtek.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: ac97: Be sure to clamp return valueLinus Walleij1-1/+1
As we want gpio_chip .get() calls to be able to return negative error codes and propagate to drivers, we need to go over all drivers and make sure their return values are clamped to [0,1]. We do this by using the ret = !!(val) design pattern. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm8903: Be sure to clamp return valueLinus Walleij1-1/+1
As we want gpio_chip .get() calls to be able to return negative error codes and propagate to drivers, we need to go over all drivers and make sure their return values are clamped to [0,1]. We do this by using the ret = !!(val) design pattern. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm_adsp: Attach buffers and streams togetherCharles Keepax3-0/+64
The stream is created whilst the compressed stream is opened and a buffer is created when the DSP powers up. It is necessary at a point once both the DSP has powered up and the the stream has been opened to connect a stream to a buffer on the DSP. This is done in the trigger callback as this is after the DSP has been powered and obviously the stream must be open. Note that whilst the connect is currently trivial it is expected that this will get more complex when support for multiple buffers/streams per DSP is added. Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm_adsp: Add code to locate and initialise compressed bufferCharles Keepax2-0/+293
Add code that locates and initialises the buffer of compressed data on the DSP if the firmware supported compressed data capture. The buffer struct (wm_adsp_compr_buf) is kept separate from the stream struct (wm_adsp_compr) this will allow much easier support of multiple streams of data from the one DSP in the future, although support for this will not be added in this patch chain. Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm_adsp: Add support for opening a compressed streamCharles Keepax3-3/+227
Allow user-space to open a compressed stream, although no data will be passed yet, as part of this adding the ability to define supported capabilities per firmware and check these match the stream being opened. Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ALSA: compress: Add SND_AUDIOCODEC_BESPOKECharles Keepax1-2/+3
When working with the compressed framework occasionally vendors will use esoteric internal audio formats. For such formats it doesn't really make sense to add an new define to the kernel as their use is not sufficiently general. This patch adds a new define SND_AUDIOCODEC_BESPOKE that vendors can use in such situations. Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Acked-by: Vinod Koul <vinod.koul@intel.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm_adsp: Factor out finding the location of an algorithm regionCharles Keepax1-14/+21
Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: wm5110: Provide basic hookup for voice controlCharles Keepax3-2/+47
Register a platform driver for the CODEC and add DAIs that will be used to connect a compressed record path for the voice control functionality. Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Remove support for 32KHz PLL modeAdam Thomson2-10/+2
PLL mode based on 32KHz master clock not supported in AB silicon so remove support from the driver. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Add support for 1.6V micbias levelAdam Thomson3-2/+6
HW can provide 1.6V micbias level as well the existing levels already provided in the driver. This patch adds support for 1.6V to the DT binding. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Acked-by: Rob Herring <robh@kernel.org> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Remove internal LDO features of codecAdam Thomson4-68/+6
In AB silicon, the internal LDO is not supported so remove DT and driver references to this (digital voltage direct from 'VDD' supply) Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Acked-by: Rob Herring <robh@kernel.org> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Update REFERENCES reg default, in-line with HWAdam Thomson1-1/+1
In current AB silicon, BIAS_EN field is enabled by default in the REFERENCES register, so the regmap default value should reflect this. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Disable regulators on probe() failureAdam Thomson1-4/+15
If codec probe() function fails after supplies have been enabled it should really tidy up and disable them again. This patch updates the probe function to do just that. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: da7219: Fix Sidetone to work regardless of DAI captureAdam Thomson1-1/+2
Previously Sidetone would operate only when capture to DAI was in progress, due to DAPM path configuration. There is no reason why this should not operate without DAI capture, so this patch updates the DAPM path accordingly. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: fsl-asoc-card: use different route map for AC'97 modeMaciej S. Szmigiero1-1/+9
fsl_ssi uses different stream names ("AC97 Playback" / "AC97 Capture") in AC'97 mode so in this case fsl-asoc-card route map should also be using them. Signed-off-by: Maciej S. Szmigiero <mail@maciej.szmigiero.name> Acked-by: Nicolin Chen <nicoleotsuka@gmail.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: fsl_asrc: add support for 8-30kHz output sample rateZidan Wang1-16/+23
Add 8kHz, 11.025kHz, 16kHz, 22.05kHz output sample rate support. According referance menual, "Limited support for the case when output sampling rates is between 8kHz and 30kHz. The limitation is the supported ratio (Fsin/Fsout) range as between 1/24 to 8." Signed-off-by: Zidan Wang <zidan.wang@freescale.com> Acked-by: Nicolin Chen <nicoleotsuka@gmail.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: atmel_wm8904: add snd_soc_pm_opsSongjun Wu1-0/+1
Sometimes the audio play can not be resumed after it is suspended. Add snd_soc_pm_ops to execute power management operations, then this issue is fixed. Signed-off-by: Songjun Wu <songjun.wu@atmel.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: rt5616: rename some alsa control namesBard Liao1-3/+3
Rename some alsa control name as what they should be. Signed-off-by: Bard Liao <bardliao@realtek.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: Intel: add NULL testJulia Lawall1-0/+2
Add NULL test on call to devm_kzalloc. The semantic match that finds this problem is as follows: (http://coccinelle.lip6.fr/) // <smpl> @@ expression x; identifier fld; @@ * x = devm_kzalloc(...); ... when != x == NULL x->fld // </smpl> Signed-off-by: Julia Lawall <Julia.Lawall@lip6.fr> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: omap-hdmi-audio: add NULL testJulia Lawall1-0/+2
Add NULL test on call to devm_kzalloc. The semantic match that finds this problem is as follows: (http://coccinelle.lip6.fr/) // <smpl> @@ expression x; identifier fld; @@ * x = devm_kzalloc(...); ... when != x == NULL x->fld // </smpl> Signed-off-by: Julia Lawall <Julia.Lawall@lip6.fr> Acked-by: Peter Ujfalusi <peter.ujfalusi@ti.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-23ASoC: imx-pcm-dma: add NULL testJulia Lawall1-0/+2
Add NULL test on call to devm_kzalloc. The semantic match that finds this problem is as follows: (http://coccinelle.lip6.fr/) // <smpl> @@ expression x; @@ * x = devm_kzalloc(...); ... when != x == NULL *x // </smpl> Signed-off-by: Julia Lawall <Julia.Lawall@lip6.fr> Acked-by: Nicolin Chen <nicoleotsuka@gmail.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-22ASoC: ssm2518: Use a signed return type for ssm2518_lookup_mcs()Markus Elfring1-1/+1
The return type "unsigned int" was used by the ssm2518_lookup_mcs() function even though it will eventually return a negative error code. Improve this implementation detail by deletion of the type modifier then. This issue was detected by using the Coccinelle software. Signed-off-by: Markus Elfring <elfring@users.sourceforge.net> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-22ASoC: rsnd: add Multi channel supportKuninori Morimoto6-17/+194
This patch adds Multi channel support on Renesas R-Car sound. This patch is tested on Salvator-X board, but it can't use Multi channel, because supported format is different between codec chip and R-Car. Thus, it was tested on board which doesn't mount codec chip, with oscilloscope. Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com> Acked-by: Rob Herring <robh@kernel.org> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-22ASoC: da7218: Enable mic level detection reporting to user-spaceAdam Thomson1-5/+14
This patch adds support to the codec driver to handle mic level detect related IRQs, and report these to user-space using a uevent variable. The uevent variable string "EVENT=MIC_LEVEL_DETECT" is sent to user-space, if the mic level detect feature is enabled, and the audio captured at the chosen mic(s) is above a certain threshold. User-space can then handle the event accordingly (e.g. process audio capture stream). This method was chosen over ALSA control notification for a couple of reasons: 1) There's no requirement here for a control to read state from. The event is the only thing that's required and of interest. 2) tinyalsa support for control notifications does not exist so on platforms using this over alsa-lib there is a need to add code to support this event handling. Another possible option would be to use the standard Jack reporting framework but this really does not fit for this kind of event. Finally, use of the input device framework is not being encouraged, due to difficulties in enabling apps to access input devices, so this has also been avoided. Signed-off-by: Adam Thomson <Adam.Thomson.Opensource@diasemi.com> Signed-off-by: Mark Brown <broonie@kernel.org>
2015-12-22ASoC: sun4i-codec: Use proper output for external amp routesHans de Goede1-1/+2
An external amp (if any) is connected to the external outputs of the SoC of course, rather then directly to the internal amp. Signed-off-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Mark Brown <broonie@kernel.org>