wireguard-linux/Documentation/devicetree/bindings/net/wireless, branch jd/unified-crypt-queue

Merge ath-next from git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git

2020-03-16T05:29:55Z

ath.git patches for v5.7. Major changes: ath10k * support for getting btcoex settings from Device Tree * support QCA9377 SDIO device ath11k * add HE rate accounting * add thermal sensor and cooling devices

dt-bindings: net: wireless: mt76: document bindings for MT7622

2020-02-14T09:06:06Z

MT7622 is a SoC that includes a 2.4 GHz 4x4 802.11n WMAC. Its feature set is comparable to a MT7615 chip, but limited to 2.4 GHz. Reviewed-by: Rob Herring Signed-off-by: Felix Fietkau

dt-bindings: net: wireless: mt76: introduce big-endian property

2020-02-14T09:06:00Z

Introduce big-endian property to specify mtd radio partition endianness Signed-off-by: Lorenzo Bianconi Acked-by: Rob Herring Signed-off-by: Felix Fietkau

DTS: bindings: wl1251: mark ti,power-gpio as optional

2020-02-12T16:15:52Z

It is now only useful for SPI interface. Power control of SDIO mode is done through mmc core. Suggested by: Ulf Hansson Signed-off-by: H. Nikolaus Schaller Signed-off-by: Kalle Valo

dt-bindings: ath10k: Add new dt entries to identify coex support

2020-02-11T14:22:37Z

This adds new dt entries qcom,coexist-support and qcom,coexist-gpio-pin which will be used by ath10k driver to identify coex support of a hardware and notify wifi firmware the gpio pin number. This pin number information is needed for the hardware QCA4019. Signed-off-by: Tamizh Chelvam Reviewed-by: Rob Herring Signed-off-by: Kalle Valo

dt: bindings: add dt entry flag to skip SCM call for msa region

2020-01-26T10:36:01Z

Add boolean context flag to disable SCM call for statically mapped msa region. Signed-off-by: Govind Singh Acked-by: Rob Herring Signed-off-by: Kalle Valo

ath10k: Add optional qdss clk

2020-01-26T10:24:47Z

The WiFi firmware found on sm8150 requires that the QDSS clock is ticking in order to operate, so add an optional clock to the binding to allow this to be specified in the sm8150 dts and add the clock to the list of clocks in the driver. Signed-off-by: Bjorn Andersson Acked-by: Rob Herring Signed-off-by: Kalle Valo

Merge ath-next from git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git

2019-12-10T09:34:30Z

ath.git patches for v5.6. Major changes: ath11k * a new driver for Qualcomm Wi-Fi 6 (IEEE 802.11ax) devices ath10k * significant improvements on receive throughput and firmware download with SDIO bus * report signal strength for each chain also on SDIO * set max mtu to 1500 on SDIO devices

Merge tag 'mmc-v5.5' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc

2019-11-27T18:03:52Z

Pull MMC updates from Ulf Hansson: "These are the updates for MMC and MEMSTICK for v5.5. Note that this also contains quite some additional changes reaching beyond both the MMC and MEMSTICK subsystems. This is primarily because of fixing an old regression for a WiFi driver based on the SDIO interface on an OMAP openpandora board MMC core: - Add CMD13 polling for MMC IOCTLS with R1B response. - Add common DT properties for clk-phase-delays for various speed modes. - Fix size overflow for mmc gp-partitions. - Re-work HW reset for SDIO cards, which also includes a re-work for Marvell's WiFi mwifiex SDIO func driver. MMC host: - jz4740: Add support for X1000 and JZ4760. - jz4740: Add support for 8-bit bus and for low power mode. - mmci: Add support for HW busy timeout for the stm32_sdmmc variant. - owl-mmc: Add driver for Actions Semi Owl SoCs SD/MMC controller. - renesas_sdhi: Add support for r8a774b1. - sdhci_am654: Add support for Command Queuing Engine for J721E. - sdhci-milbeaut: Add driver for the Milbeaut SD controller. - sdhci-of-arasan: Add support for ZynqMP tap-delays. - sdhci-of-arasan: Add support for clk-phase-delays for SD cards. - sdhci-of-arasan: Add support for Intel LGM SDXC. - sdhci-of-aspeed: Allow inversion of the internal card detect signal. - sdhci-of-esdhc: Fixup workaround for erratum A-008171 for tunings. - sdhci-of-at91: Improve support for calibration. - sdhci-pci: Add support for Intel JSL. - sdhci-pci: Add quirk for AMD SDHC Device 0x7906. - tmio: Enable support for erase/discard/trim requests. MMC/OMAP/pandora/wl1251: The TI wl1251 WiFi driver for SDIO on the OMAP openpandora board has been broken since v4.7. To fix the problems, changes have been made cross subsystems, but also to OMAP2 machine code and to openpandora DTS files, as summarized below. Relevant changes have been tagged for stable. - mmc/wl1251: Re-introduce lost SDIO quirks and vendor-id for wl1251 - omap/omap_hsmmc: Remove redundant platform config for openpandora - omap_hsmmc: Initialize non-std SDIO card for wl1251 for pandora - omap/dts/pandora: Specify wl1251 through a child node of mmc3 - wl1251: Add devicetree support for TI wl1251 SDIO" * tag 'mmc-v5.5' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (73 commits) dt-bindings: mmc: Correct the type of the clk phase properties Revert "mmc: tmio: remove workaround for NON_REMOVABLE" memstick: Fix Kconfig indentation mmc: sdhci-of-arasan: Add support for ZynqMP Platform Tap Delays Setup dt-bindings: mmc: arasan: Document 'xlnx,zynqmp-8.9a' controller firmware: xilinx: Add SDIO Tap Delay nodes mmc: sdhci-of-arasan: Add support to set clock phase delays for SD dt-bindings: mmc: Add optional generic properties for mmc mmc: sdhci-of-arasan: Add sampling clock for a phy to use dt-bindings: mmc: arasan: Update Documentation for the input clock mmc: sdhci-of-arasan: Separate out clk related data to another structure mmc: sdhci: Fix grammar in warning message mmc: sdhci-of-aspeed: add inversion signal presence mmc: sdhci-of-aspeed: enable CONFIG_MMC_SDHCI_IO_ACCESSORS mmc: sdhci_am654: Add Support for Command Queuing Engine to J721E mmc: core: Fix size overflow for mmc partitions mmc: tmio: Add MMC_CAP_ERASE to allow erase/discard/trim requests net: wireless: ti: remove local VENDOR_ID and DEVICE_ID definitions net: wireless: ti: wl1251 use new SDIO_VENDOR_ID_TI_WL1251 definition mmc: core: fix wl1251 sdio quirks ...

dt: bindings: net: add qcom,ath11k.yaml

2019-11-25T12:15:52Z

ath11k is a driver for Qualcomm IEEE 802.11ax devices. Add a bindings document for the driver, first documenting IPQ8074 which is the only device ath11k currently supports. Signed-off-by: Anilkumar Kolli Reviewed-by: Rob Herring Signed-off-by: Kalle Valo