wireguard-linux/drivers/pinctrl/qcom, branch davem/net

pinctrl: qcom: ipq5210: Publish the OF module alias

2026-09-18T17:00:35Z

The IPQ5210 TLMM platform driver can be a module and matches through ipq5210_tlmm_of_match. This table is not published for OF modalias matching. Publish the existing table, preserving arch_initcall ordering and the shared MSM pinctrl probe. Fixes: a549fe22376f ("pinctrl: qcom: Introduce IPQ5210 TLMM driver") Signed-off-by: hpp.iscas Reviewed-by: Konrad Dybcio Link: https://patch.msgid.link/20260905134340.67477-1-hppiscas@163.com Signed-off-by: Bartosz Golaszewski Signed-off-by: Linus Walleij

pinctrl: qcom: nord: Split QUP1 SE2/SE3 into lane-pair functions

2026-09-18T17:00:14Z

QUP1 SE2 and SE3 pack all four of their lanes pair-wise onto only two pins each: lanes 0/1 (I2C SDA/SCL) at mux value 2 and lanes 2/3 (UART TX/RX) at mux value 1, on gpio127/gpio128 and gpio129/gpio130 respectively. Both mux values were named "qup1_se2" (respectively "qup1_se3"), so the two distinct lane pairs became indistinguishable. msm_pinmux_set_mux() stops at the first entry matching the requested function, which means mux value 1 was always selected and the I2C lanes could never be muxed out. In practice i2c9 and i2c10 got the UART lanes and did not work, while uart9 and uart10 happened to be muxed correctly. Give each lane pair its own function, following the _01/_23 naming already used for the same hardware arrangement by the shikra, eliza, hawi and maili TLMM drivers. Both functions still cover the full pin pair, so a single pinctrl state per protocol remains sufficient. Drop gpio129/gpio130 from the SE2 group list, since those pins belong to SE3 and were never reachable through the SE2 function. Also rename QUP1 SE2/SE3 functions in the binding doc accordingly. While at it, add missing "gpio", "qup3_se0_mira" and "qup3_se0_mirb" to the binding function enum to get the list complete. Fixes: c24dd0826f06 ("pinctrl: qcom: add the TLMM driver for the Nord platforms") Cc: stable@vger.kernel.org Assisted-by: LLM Signed-off-by: Shawn Guo Reviewed-by: Konrad Dybcio Link: https://patch.msgid.link/20260830030201.135637-1-shengchao.guo@oss.qualcomm.com Signed-off-by: Bartosz Golaszewski Signed-off-by: Linus Walleij

Merge tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl

2026-08-24T15:46:03Z

Pull pin control updates from Linus Walleij: "Core changes: - Use the non-blocking mux_state_try_select() in the generic MUX pin control back-end - Free pin maps on pinctrl_generic_to_map() failure in the core helpers New hardware pin control: - Qualcomm Maili TLMM SoC, PMG1110 PMIC, and Eliza LPASS LPI TLMM SoC (this is for the low power audio, LPASS = Low Power Audio SubSystem portions) - Upboard support on top of the Intel pin controller - Apple T6030 and T6031 support (just compatible strings) - Samsung Exynos 8855 SoC - Mediatek MT6858 SoC - Rockchip RK3308B and RV1106 SoCs - Airoha EN7523 and AN7563 SoCs Improvements: - Qualcomm TLMM GPIOs are unconditionally marked as wakeup capable - Qualcomm improvements on top of the Qualcomm PDC (power domain controller) irqchip improvements from tglx:s tree - Qualcomm IPQ806x and IPQ9650 non-urgent pin grop fixups - The NPCM8xx driver has been put into shape fixing many pin and group definitions - Some non-urgent Tegra 264 pin assignments are fixed up - Some non-urgent fixups to Airoha AN7581 and AN7583 registers and pin assignments, missing features etc" * tag 'pinctrl-v7.3-1' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl: (130 commits) dt-bindings: pinctrl: Convert TI DA850 pupd to DT schema pinctrl: meson: sync some modify from A4 pinctrl: meson: a4: Add input enable pin configuration pinctrl: realtek: rtd1625: remove unused group name spdif_sel pinctrl: realtek: rtd1625: fix base_bit for VE4 GPIO 13 dt-bindings: pinctrl: microchip,pic32mzda-pinctrl: Convert to DT schema Revert "Merge branch 'ib-rsk7204' into devel" pinctrl: rockchip: Add RV1106 pinctrl support dt-bindings: pinctrl: rockchip: Add RV1106 compatible pinctrl: rockchip: Decode drive strength in the get function pinctrl: fix PINCTRL_GENERIC_MUX not always being selectable pinctrl: airoha: add support of an7563 SoC dt-bindings: pinctrl: airoha: add support of an7563 pin controller pinctrl: airoha: try to find chip scu node by phandle first pinctrl: airoha: add support of en7523 SoC dt-bindings: pinctrl: airoha: add support of en7523 pin controller pinctrl: airoha: an7583: add support for olt pinmux pinctrl: airoha: an7583: add support for pon_alt pinmux pinctrl: airoha: an7583: add support for npu_uart pinmux dt-bindings: pinctrl: airoha: an7583: add missed features ...

Merge tag 'pinctrl-qcom-updates-for-v7.3-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux into devel

2026-08-16T16:59:43Z

Qualcomm pinctrl updates for v7.3-rc1 New drivers: - add pinctrl drivers for Maili TLMM and Elize LPASS LPI TLMM controllers Driver updates: - acknowledge interrupts for the PDC interrupt controller in pinctrl-msm - implement irq_get/set_irqchip_state() for pinctrl-msm - add support for a new model to Qualcomm pinctrl-spmi-gpio - drop some dead code from qcom pinctrl modules Devicetree bindings: - document new TLMM controllers and the new model for the SPMI GPIO Signed-off-by: Linus Walleij

Merge tag 'pinctrl-qcom-fixes-for-v7.2' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux into devel

2026-08-16T16:59:23Z

Qualcomm pin control fixes for v7.2 - fix intr_target_width for summary interrupt routing in pinctrl-shikra Signed-off-by: Linus Walleij

pinctrl: Use IRQ trigger mask helpers

2026-08-06T21:40:54Z

Use IRQ_TYPE_LEVEL_MASK and IRQ_TYPE_EDGE_BOTH instead of open-coded trigger type combinations in irqchip callbacks. No functional change intended. Assisted-by: Claude:claude-sonnet-5 Signed-off-by: Maulik Shah Acked-by: Viresh Kumar Signed-off-by: Linus Walleij

Merge tag 'pinctrl-qcom-fixes-for-v7.2-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux into fixes

2026-08-03T07:54:28Z

Qualcomm pin control fixes for v7.2-rc6 - mark gpio and pci reset as a GPIO pin functions in pinctrl-ipq8064 - fix audio_sec_mclk_in1/out1 pin numbers in pinctrl-ipq9650 Signed-off-by: Linus Walleij

pinctrl: qcom: shikra: Fix intr_target_width for summary interrupt routing

2026-07-31T08:31:21Z

The intr_target_width field sets the mask width used when writing target processor into interrupt config register and deciding which processor receives summary interrupt for a given GPIO. Without it, pinctrl driver defaults to a 3-bit mask. On Shikra, this field is 4 bits wide, which could corrupt adjacent bits and mis-route interrupts. Set intr_target_width = 4 to match the hardware. Fixes: 9db68ec534c5 ("pinctrl: qcom: Add Shikra pinctrl driver") Signed-off-by: Komal Bajaj Reviewed-by: Konrad Dybcio Link: https://patch.msgid.link/20260728-shikra-pinctrl-intr-width-v1-1-46583734d808@oss.qualcomm.com Signed-off-by: Bartosz Golaszewski

pinctrl: qcom: ipq806x: mark pci reset as a GPIO pin function

2026-07-28T09:11:20Z

The qcom pinctrl core supports marking functions that represent GPIO mode via PINCTRL_GPIO_PINFUNCTION(), so that strict pinmuxing does not reject GPIO requests for pins that are muxed to the GPIO function. Mark PCIe reset as GPIO pin function This allows ipq806x to keep the PCIe-reset related configuration in DTS without tripping over strict pinmux ownership checks. Fixes: cc85cb96e2e4 ("pinctrl: qcom: make the pinmuxing strict") Signed-off-by: Hans Ulli Kroll Acked-by: Linus Walleij Reviewed-by: Dmitry Baryshkov Link: https://patch.msgid.link/20260719134548.8830-3-linux@ulli-kroll.de Signed-off-by: Bartosz Golaszewski

pinctrl: qcom: ipq806x: mark gpio as a GPIO pin function

2026-07-28T09:11:20Z

The qcom pinctrl core supports marking functions that represent GPIO mode via PINCTRL_GPIO_PINFUNCTION(), so that strict pinmuxing does not reject GPIO requests for pins that are muxed to the GPIO function. Add a IPQ_GPIO_PIN_FUNCTION() helper and use it for the ipq806x gpio function, matching how the msm-based qcom drivers handle this. This allows ipq806x to keep the GPIO-related configuration in DTS without tripping over strict pinmux ownership checks. Fixes: cc85cb96e2e4 ("pinctrl: qcom: make the pinmuxing strict") Signed-off-by: Hans Ulli Kroll Acked-by: Linus Walleij Reviewed-by: Dmitry Baryshkov Reviewed-by: Konrad Dybcio Link: https://patch.msgid.link/20260719134548.8830-2-linux@ulli-kroll.de Signed-off-by: Bartosz Golaszewski