diff options
Diffstat (limited to 'Documentation/admin-guide/kernel-parameters.txt')
| -rw-r--r-- | Documentation/admin-guide/kernel-parameters.txt | 30 |
1 files changed, 28 insertions, 2 deletions
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt index 45d95614ec44..500cfa776225 100644 --- a/Documentation/admin-guide/kernel-parameters.txt +++ b/Documentation/admin-guide/kernel-parameters.txt @@ -788,6 +788,25 @@ Documentation/networking/netconsole.rst for an alternative. + <DEVNAME>:<n>.<n>[,options] + Use the specified serial port on the serial core bus. + The addressing uses DEVNAME of the physical serial port + device, followed by the serial core controller instance, + and the serial port instance. The options are the same + as documented for the ttyS addressing above. + + The mapping of the serial ports to the tty instances + can be viewed with: + + $ ls -d /sys/bus/serial-base/devices/*:*.*/tty/* + /sys/bus/serial-base/devices/00:04:0.0/tty/ttyS0 + + In the above example, the console can be addressed with + console=00:04:0.0. Note that a console addressed this + way will only get added when the related device driver + is ready. The use of an earlycon parameter in addition to + the console may be desired for console output early on. + uart[8250],io,<addr>[,options] uart[8250],mmio,<addr>[,options] uart[8250],mmio16,<addr>[,options] @@ -2151,6 +2170,12 @@ Format: 0 | 1 Default set by CONFIG_INIT_ON_FREE_DEFAULT_ON. + init_mlocked_on_free= [MM] Fill freed userspace memory with zeroes if + it was mlock'ed and not explicitly munlock'ed + afterwards. + Format: 0 | 1 + Default set by CONFIG_INIT_MLOCKED_ON_FREE_DEFAULT_ON + init_pkru= [X86] Specify the default memory protection keys rights register contents for all processes. 0x55555554 by default (disallow access to all but pkey 0). Can @@ -3781,10 +3806,12 @@ Format: [state][,regs][,debounce][,die] nmi_watchdog= [KNL,BUGS=X86] Debugging features for SMP kernels - Format: [panic,][nopanic,][num] + Format: [panic,][nopanic,][rNNN,][num] Valid num: 0 or 1 0 - turn hardlockup detector in nmi_watchdog off 1 - turn hardlockup detector in nmi_watchdog on + rNNN - configure the watchdog with raw perf event 0xNNN + When panic is specified, panic when an NMI watchdog timeout occurs (or 'nopanic' to not panic on an NMI watchdog, if CONFIG_BOOTPARAM_HARDLOCKUP_PANIC is set) @@ -7501,4 +7528,3 @@ memory, and other data can't be written using xmon commands. off xmon is disabled. - |