diff options
Diffstat (limited to 'Documentation/networking/vxlan.rst')
| -rw-r--r-- | Documentation/networking/vxlan.rst | 60 |
1 files changed, 60 insertions, 0 deletions
diff --git a/Documentation/networking/vxlan.rst b/Documentation/networking/vxlan.rst new file mode 100644 index 000000000000..ce239fa01848 --- /dev/null +++ b/Documentation/networking/vxlan.rst @@ -0,0 +1,60 @@ +.. SPDX-License-Identifier: GPL-2.0 + +====================================================== +Virtual eXtensible Local Area Networking documentation +====================================================== + +The VXLAN protocol is a tunnelling protocol designed to solve the +problem of limited VLAN IDs (4096) in IEEE 802.1q. With VXLAN the +size of the identifier is expanded to 24 bits (16777216). + +VXLAN is described by IETF RFC 7348, and has been implemented by a +number of vendors. The protocol runs over UDP using a single +destination port. This document describes the Linux kernel tunnel +device, there is also a separate implementation of VXLAN for +Openvswitch. + +Unlike most tunnels, a VXLAN is a 1 to N network, not just point to +point. A VXLAN device can learn the IP address of the other endpoint +either dynamically in a manner similar to a learning bridge, or make +use of statically-configured forwarding entries. + +The management of vxlan is done in a manner similar to its two closest +neighbors GRE and VLAN. Configuring VXLAN requires the version of +iproute2 that matches the kernel release where VXLAN was first merged +upstream. + +1. Create vxlan device:: + + # ip link add vxlan0 type vxlan id 42 group 239.1.1.1 dev eth1 dstport 4789 + +This creates a new device named vxlan0. The device uses the multicast +group 239.1.1.1 over eth1 to handle traffic for which there is no +entry in the forwarding table. The destination port number is set to +the IANA-assigned value of 4789. The Linux implementation of VXLAN +pre-dates the IANA's selection of a standard destination port number +and uses the Linux-selected value by default to maintain backwards +compatibility. + +2. Delete vxlan device:: + + # ip link delete vxlan0 + +3. Show vxlan info:: + + # ip -d link show vxlan0 + +It is possible to create, destroy and display the vxlan +forwarding table using the new bridge command. + +1. Create forwarding table entry:: + + # bridge fdb add to 00:17:42:8a:b4:05 dst 192.19.0.2 dev vxlan0 + +2. Delete forwarding table entry:: + + # bridge fdb delete 00:17:42:8a:b4:05 dev vxlan0 + +3. Show forwarding table:: + + # bridge fdb show dev vxlan0 |