diff options
Diffstat (limited to 'arch/arm/boot/dts/dra7-evm.dts')
| -rw-r--r-- | arch/arm/boot/dts/dra7-evm.dts | 39 |
1 files changed, 35 insertions, 4 deletions
diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts index d9b87236019d..d272cf140197 100644 --- a/arch/arm/boot/dts/dra7-evm.dts +++ b/arch/arm/boot/dts/dra7-evm.dts @@ -33,6 +33,7 @@ evm_3v3_sw: fixedregulator-evm_3v3_sw { compatible = "regulator-fixed"; regulator-name = "evm_3v3_sw"; + vin-supply = <&sysen1>; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; }; @@ -64,10 +65,11 @@ regulator-always-on; regulator-boot-on; enable-active-high; + vin-supply = <&sysen2>; gpio = <&gpio7 11 GPIO_ACTIVE_HIGH>; }; - sound0: sound@0 { + sound0: sound0 { compatible = "simple-audio-card"; simple-audio-card,name = "DRA7xx-EVM"; simple-audio-card,widgets = @@ -254,8 +256,9 @@ nand_flash_x16: nand_flash_x16 { /* On DRA7 EVM, GPMC_WPN and NAND_BOOTn comes from DIP switch * So NAND flash requires following switch settings: - * SW5.9 (GPMC_WPN) = LOW - * SW5.1 (NAND_BOOTn) = HIGH */ + * SW5.1 (NAND_BOOTn) = ON (LOW) + * SW5.9 (GPMC_WPN) = OFF (HIGH) + */ pinctrl-single,pins = < DRA7XX_CORE_IOPAD(0x3400, PIN_INPUT | MUX_MODE0) /* gpmc_ad0 */ DRA7XX_CORE_IOPAD(0x3404, PIN_INPUT | MUX_MODE0) /* gpmc_ad1 */ @@ -523,6 +526,31 @@ regulator-max-microvolt = <3300000>; regulator-boot-on; }; + + /* REGEN1 is unused */ + + regen2: regen2 { + /* Needed for PMIC internal resources */ + regulator-name = "regen2"; + regulator-boot-on; + regulator-always-on; + }; + + /* REGEN3 is unused */ + + sysen1: sysen1 { + /* PMIC_REGEN_3V3 */ + regulator-name = "sysen1"; + regulator-boot-on; + regulator-always-on; + }; + + sysen2: sysen2 { + /* PMIC_REGEN_DDR */ + regulator-name = "sysen2"; + regulator-boot-on; + regulator-always-on; + }; }; }; }; @@ -539,7 +567,7 @@ }; pcf_gpio_21: gpio@21 { - compatible = "ti,pcf8575"; + compatible = "nxp,pcf8575"; reg = <0x21>; lines-initial-states = <0x1408>; gpio-controller; @@ -748,6 +776,7 @@ interrupt-parent = <&gpmc>; interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */ <1 IRQ_TYPE_NONE>; /* termcount */ + rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 pin */ ti,nand-ecc-opt = "bch8"; ti,elm-id = <&elm>; nand-bus-width = <16>; @@ -904,6 +933,8 @@ serial-dir = < /* 0: INACTIVE, 1: TX, 2: RX */ 1 2 0 0 >; + tx-num-evt = <32>; + rx-num-evt = <32>; }; &mailbox5 { |