diff options
Diffstat (limited to 'arch/arm/mach-pxa/cm-x255.c')
| -rw-r--r-- | arch/arm/mach-pxa/cm-x255.c | 240 |
1 files changed, 0 insertions, 240 deletions
diff --git a/arch/arm/mach-pxa/cm-x255.c b/arch/arm/mach-pxa/cm-x255.c deleted file mode 100644 index ea1e85775759..000000000000 --- a/arch/arm/mach-pxa/cm-x255.c +++ /dev/null @@ -1,240 +0,0 @@ -// SPDX-License-Identifier: GPL-2.0-only -/* - * linux/arch/arm/mach-pxa/cm-x255.c - * - * Copyright (C) 2007, 2008 CompuLab, Ltd. - * Mike Rapoport <mike@compulab.co.il> - */ - -#include <linux/platform_device.h> -#include <linux/irq.h> -#include <linux/mtd/partitions.h> -#include <linux/mtd/physmap.h> -#include <linux/mtd/nand-gpio.h> -#include <linux/gpio/machine.h> -#include <linux/spi/spi.h> -#include <linux/spi/pxa2xx_spi.h> - -#include <asm/mach/arch.h> -#include <asm/mach-types.h> -#include <asm/mach/map.h> - -#include "pxa25x.h" - -#include "generic.h" - -#define GPIO_NAND_CS (5) -#define GPIO_NAND_ALE (4) -#define GPIO_NAND_CLE (3) -#define GPIO_NAND_RB (10) - -static unsigned long cmx255_pin_config[] = { - /* AC'97 */ - GPIO28_AC97_BITCLK, - GPIO29_AC97_SDATA_IN_0, - GPIO30_AC97_SDATA_OUT, - GPIO31_AC97_SYNC, - - /* BTUART */ - GPIO42_BTUART_RXD, - GPIO43_BTUART_TXD, - GPIO44_BTUART_CTS, - GPIO45_BTUART_RTS, - - /* STUART */ - GPIO46_STUART_RXD, - GPIO47_STUART_TXD, - - /* LCD */ - GPIOxx_LCD_TFT_16BPP, - - /* SSP1 */ - GPIO23_SSP1_SCLK, - GPIO24_SSP1_SFRM, - GPIO25_SSP1_TXD, - GPIO26_SSP1_RXD, - - /* SSP2 */ - GPIO81_SSP2_CLK_OUT, - GPIO82_SSP2_FRM_OUT, - GPIO83_SSP2_TXD, - GPIO84_SSP2_RXD, - - /* PC Card */ - GPIO48_nPOE, - GPIO49_nPWE, - GPIO50_nPIOR, - GPIO51_nPIOW, - GPIO52_nPCE_1, - GPIO53_nPCE_2, - GPIO54_nPSKTSEL, - GPIO55_nPREG, - GPIO56_nPWAIT, - GPIO57_nIOIS16, - - /* SDRAM and local bus */ - GPIO15_nCS_1, - GPIO78_nCS_2, - GPIO79_nCS_3, - GPIO80_nCS_4, - GPIO33_nCS_5, - GPIO18_RDY, - - /* GPIO */ - GPIO0_GPIO | WAKEUP_ON_EDGE_BOTH, - GPIO9_GPIO, /* PC card reset */ - - /* NAND controls */ - GPIO5_GPIO | MFP_LPM_DRIVE_HIGH, /* NAND CE# */ - GPIO4_GPIO | MFP_LPM_DRIVE_LOW, /* NAND ALE */ - GPIO3_GPIO | MFP_LPM_DRIVE_LOW, /* NAND CLE */ - GPIO10_GPIO, /* NAND Ready/Busy */ - - /* interrupts */ - GPIO22_GPIO, /* DM9000 interrupt */ -}; - -#if defined(CONFIG_SPI_PXA2XX) -static struct pxa2xx_spi_controller pxa_ssp_master_info = { - .num_chipselect = 1, -}; - -static struct spi_board_info spi_board_info[] __initdata = { - [0] = { - .modalias = "rtc-max6902", - .max_speed_hz = 1000000, - .bus_num = 1, - .chip_select = 0, - }, -}; - -static void __init cmx255_init_rtc(void) -{ - pxa2xx_set_spi_info(1, &pxa_ssp_master_info); - spi_register_board_info(ARRAY_AND_SIZE(spi_board_info)); -} -#else -static inline void cmx255_init_rtc(void) {} -#endif - -#if defined(CONFIG_MTD_PHYSMAP) || defined(CONFIG_MTD_PHYSMAP_MODULE) -static struct mtd_partition cmx255_nor_partitions[] = { - { - .name = "ARMmon", - .size = 0x00030000, - .offset = 0, - .mask_flags = MTD_WRITEABLE /* force read-only */ - } , { - .name = "ARMmon setup block", - .size = 0x00010000, - .offset = MTDPART_OFS_APPEND, - .mask_flags = MTD_WRITEABLE /* force read-only */ - } , { - .name = "kernel", - .size = 0x00160000, - .offset = MTDPART_OFS_APPEND, - } , { - .name = "ramdisk", - .size = MTDPART_SIZ_FULL, - .offset = MTDPART_OFS_APPEND - } -}; - -static struct physmap_flash_data cmx255_nor_flash_data[] = { - { - .width = 2, /* bankwidth in bytes */ - .parts = cmx255_nor_partitions, - .nr_parts = ARRAY_SIZE(cmx255_nor_partitions) - } -}; - -static struct resource cmx255_nor_resource = { - .start = PXA_CS0_PHYS, - .end = PXA_CS0_PHYS + SZ_8M - 1, - .flags = IORESOURCE_MEM, -}; - -static struct platform_device cmx255_nor = { - .name = "physmap-flash", - .id = -1, - .dev = { - .platform_data = cmx255_nor_flash_data, - }, - .resource = &cmx255_nor_resource, - .num_resources = 1, -}; - -static void __init cmx255_init_nor(void) -{ - platform_device_register(&cmx255_nor); -} -#else -static inline void cmx255_init_nor(void) {} -#endif - -#if defined(CONFIG_MTD_NAND_GPIO) || defined(CONFIG_MTD_NAND_GPIO_MODULE) - -static struct gpiod_lookup_table cmx255_nand_gpiod_table = { - .dev_id = "gpio-nand", - .table = { - GPIO_LOOKUP("gpio-pxa", GPIO_NAND_CS, "nce", GPIO_ACTIVE_HIGH), - GPIO_LOOKUP("gpio-pxa", GPIO_NAND_CLE, "cle", GPIO_ACTIVE_HIGH), - GPIO_LOOKUP("gpio-pxa", GPIO_NAND_ALE, "ale", GPIO_ACTIVE_HIGH), - GPIO_LOOKUP("gpio-pxa", GPIO_NAND_RB, "rdy", GPIO_ACTIVE_HIGH), - }, -}; - -static struct resource cmx255_nand_resource[] = { - [0] = { - .start = PXA_CS1_PHYS, - .end = PXA_CS1_PHYS + 11, - .flags = IORESOURCE_MEM, - }, - [1] = { - .start = PXA_CS5_PHYS, - .end = PXA_CS5_PHYS + 3, - .flags = IORESOURCE_MEM, - }, -}; - -static struct mtd_partition cmx255_nand_parts[] = { - [0] = { - .name = "cmx255-nand", - .size = MTDPART_SIZ_FULL, - .offset = 0, - }, -}; - -static struct gpio_nand_platdata cmx255_nand_platdata = { - .parts = cmx255_nand_parts, - .num_parts = ARRAY_SIZE(cmx255_nand_parts), - .chip_delay = 25, -}; - -static struct platform_device cmx255_nand = { - .name = "gpio-nand", - .num_resources = ARRAY_SIZE(cmx255_nand_resource), - .resource = cmx255_nand_resource, - .id = -1, - .dev = { - .platform_data = &cmx255_nand_platdata, - } -}; - -static void __init cmx255_init_nand(void) -{ - gpiod_add_lookup_table(&cmx255_nand_gpiod_table); - platform_device_register(&cmx255_nand); -} -#else -static inline void cmx255_init_nand(void) {} -#endif - -void __init cmx255_init(void) -{ - pxa2xx_mfp_config(ARRAY_AND_SIZE(cmx255_pin_config)); - - cmx255_init_rtc(); - cmx255_init_nor(); - cmx255_init_nand(); -} |