| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
Make the PMC driver resistent to variable depth interrupt hierarchy,
which we are about to introduce.
Signed-off-by: Marc Zyngier <maz@kernel.org>
|
|
Make the tegra186 GPIO driver resistent to variable depth
interrupt hierarchy, which we are about to introduce.
No functionnal change yet.
Signed-off-by: Marc Zyngier <maz@kernel.org>
|
|
It appears that some HW is ugly enough that not all the interrupts
connected to a particular interrupt controller end up with the same
hierarchy depth (some of them are terminated early). This leaves
the irqchip hacker with only two choices, both equally bad:
- create discrete domain chains, one for each "hierarchy depth",
which is very hard to maintain
- create fake hierarchy levels for the shallow paths, leading
to all kind of problems (what are the safe hwirq values for these
fake levels?)
Implement the ability to cut short a single interrupt hierarchy
from a level marked as being disconnected by using the new
irq_domain_disconnect_hierarchy() helper.
The irqdomain allocation code will then perform the trimming
Signed-off-by: Marc Zyngier <maz@kernel.org>
|
|
Kexec can directly boot into a new kernel without going to complete
reboot. This can leave the previous kernel's configuration for PDC
interrupts as is.
Clear previous kernel's configuration during init by setting interrupts
in enable bank to zero. The IRQs specified in qcom,pdc-ranges property
are the only ones that can be used by the new kernel so clear only those
IRQs. The remaining ones may be in use by a different kernel and should
not be set by new kernel.
Suggested-by: Stephen Boyd <swboyd@chromium.org>
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/1601267524-20199-7-git-send-email-mkshah@codeaurora.org
|
|
Set IRQCHIP_ENABLE_WAKEUP_ON_SUSPEND flag to enable/unmask the
wakeirqs during suspend entry.
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/1601267524-20199-6-git-send-email-mkshah@codeaurora.org
|
|
Set IRQCHIP_ENABLE_WAKEUP_ON_SUSPEND flag to enable/unmask the
wakeirqs during suspend entry.
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/1601267524-20199-5-git-send-email-mkshah@codeaurora.org
|
|
An interrupt that is disabled/masked but set for wakeup may still need to
be able to wake up the system from sleep states like "suspend to RAM".
To that effect, introduce the IRQCHIP_ENABLE_WAKEUP_ON_SUSPEND flag.
If the irqchip have this flag set, the irq PM code will enable/unmask
the irqs that are marked for wakeup, but that are in a disabled state.
On resume, such irqs will be restored back to their disabled state.
Suggested-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
[maz: commit message fix-up]
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Link: https://lore.kernel.org/r/1601267524-20199-4-git-send-email-mkshah@codeaurora.org
|
|
msmgpio irqchip was not using return value of irq_set_irq_wake() callback
since previously GIC-v3 irqchip neither had IRQCHIP_SKIP_SET_WAKE flag nor
it implemented .irq_set_wake callback. This lead to irq_set_irq_wake()
return error -ENXIO.
However from 'commit 4110b5cbb014 ("irqchip/gic-v3: Allow interrupt to be
configured as wake-up sources")' GIC irqchip has IRQCHIP_SKIP_SET_WAKE
flag.
Use return value from irq_set_irq_wake() and irq_chip_set_wake_parent()
instead of always returning success.
Fixes: e35a6ae0eb3a ("pinctrl/msm: Setup GPIO chip in hierarchy")
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Stephen Boyd <swboyd@chromium.org>
Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/1601267524-20199-3-git-send-email-mkshah@codeaurora.org
|
|
Both IRQCHIP_SET_TYPE_MASKED and IRQCHIP_MASK_ON_SUSPEND flags are already
set for msmgpio's parent PDC irqchip but GPIO interrupts do not get masked
during suspend or during setting irq type since genirq checks irqchip flag
of msmgpio irqchip which forwards these calls to its parent PDC irqchip.
Add irqchip specific flags for msmgpio irqchip to mask non wakeirqs during
suspend and mask before setting irq type. Masking before changing type make
sures any spurious interrupt is not detected during this operation.
Fixes: e35a6ae0eb3a ("pinctrl/msm: Setup GPIO chip in hierarchy")
Signed-off-by: Maulik Shah <mkshah@codeaurora.org>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Tested-by: Stephen Boyd <swboyd@chromium.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/1601267524-20199-2-git-send-email-mkshah@codeaurora.org
|
|
As SMP-on-UP is a valid configuration on 32bit ARM, do not assume that
IPIs are populated in show_ipi_list().
Reported-by: Guillaume Tucker <guillaume.tucker@collabora.com>
Reported-by: kernelci.org bot <bot@kernelci.org>
Tested-by: Guillaume Tucker <guillaume.tucker@collabora.com>
Signed-off-by: Marc Zyngier <maz@kernel.org>
|
|
Add entries for Actions Semi Owl SIRQ controller binding and driver.
Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@gmail.com>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Link: https://lore.kernel.org/r/174084658e46824a02edf41beae134214d858d46.1600114378.git.cristian.ciocaltea@gmail.com
|
|
This interrupt controller is found in the Actions Semi Owl SoCs (S500,
S700 and S900) and provides support for handling up to 3 external
interrupt lines.
Each line can be independently configured as interrupt and triggers on
either of the edges or either of the levels. Additionally, each line
can also be masked individually.
Co-developed-by: Parthiban Nallathambi <pn@denx.de>
Co-developed-by: Saravanan Sekar <sravanhome@gmail.com>
Signed-off-by: Parthiban Nallathambi <pn@denx.de>
Signed-off-by: Saravanan Sekar <sravanhome@gmail.com>
Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@gmail.com>
Signed-off-by: Marc Zyngier <maz@kernel.org>
Link: https://lore.kernel.org/r/1a010ef0eb78831b5657d74a0fcdef7a8efb2ec4.1600114378.git.cristian.ciocaltea@gmail.com
|
Marc Zyngier
Maulik Shah
Cristian Ciocaltea