mmc: Fixes for Dual Data Rate (DDR) support

The DDR support patch needs the following fixes:

- The block driver does not need to know about DDR, any more
  than it needs to know about bus width.
- Not only the card must be switched to DDR mode.  The host
  controller must also be configured, which is done through
  the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
  is successful.
- Setting block length is not supported in DDR mode.  Make that
  a core function and change the other place it is used (mmc_test)
  also.

Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

1 files changed, 1 insertions, 0 deletions

diff --git a/drivers/mmc/core/core.h b/drivers/mmc/core/core.h
index a2ca770ca89b..13240d128a69 100644
--- a/drivers/mmc/core/core.h
+++ b/drivers/mmc/core/core.h
@@ -35,6 +35,7 @@ void mmc_set_chip_select(struct mmc_host *host, int mode);
 void mmc_set_clock(struct mmc_host *host, unsigned int hz);
 void mmc_set_bus_mode(struct mmc_host *host, unsigned int mode);
 void mmc_set_bus_width(struct mmc_host *host, unsigned int width);
+void mmc_set_bus_width_ddr(struct mmc_host *host, unsigned int width, int ddr);
 u32 mmc_select_voltage(struct mmc_host *host, u32 ocr);
 void mmc_set_timing(struct mmc_host *host, unsigned int timing);