Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1674 commits)
  qlcnic: adding co maintainer
  ixgbe: add support for active DA cables
  ixgbe: dcb, do not tag tc_prio_control frames
  ixgbe: fix ixgbe_tx_is_paused logic
  ixgbe: always enable vlan strip/insert when DCB is enabled
  ixgbe: remove some redundant code in setting FCoE FIP filter
  ixgbe: fix wrong offset to fc_frame_header in ixgbe_fcoe_ddp
  ixgbe: fix header len when unsplit packet overflows to data buffer
  ipv6: Never schedule DAD timer on dead address
  ipv6: Use POSTDAD state
  ipv6: Use state_lock to protect ifa state
  ipv6: Replace inet6_ifaddr->dead with state
  cxgb4: notify upper drivers if the device is already up when they load
  cxgb4: keep interrupts available when the ports are brought down
  cxgb4: fix initial addition of MAC address
  cnic: Return SPQ credit to bnx2x after ring setup and shutdown.
  cnic: Convert cnic_local_flags to atomic ops.
  can: Fix SJA1000 command register writes on SMP systems
  bridge: fix build for CONFIG_SYSFS disabled
  ARCNET: Limit com20020 PCI ID matches for SOHARD cards
  ...

Fix up various conflicts with pcmcia tree drivers/net/
{pcmcia/3c589_cs.c, wireless/orinoco/orinoco_cs.c and
wireless/orinoco/spectrum_cs.c} and feature removal
(Documentation/feature-removal-schedule.txt).

Also fix a non-content conflict due to pm_qos_requirement getting
renamed in the PM tree (now pm_qos_request) in net/mac80211/scan.c

1 files changed, 8 insertions, 1 deletions

diff --git a/drivers/net/wireless/iwmc3200wifi/Kconfig b/drivers/net/wireless/iwmc3200wifi/Kconfig
index b9d34a766964..03f998d098c5 100644
--- a/drivers/net/wireless/iwmc3200wifi/Kconfig
+++ b/drivers/net/wireless/iwmc3200wifi/Kconfig
@@ -17,7 +17,7 @@ config IWM
 config IWM_DEBUG
 	bool "Enable full debugging output in iwmc3200wifi"
 	depends on IWM && DEBUG_FS
-	---help---
+	help
 	  This option will enable debug tracing and setting for iwm
 
 	  You can set the debug level and module through debugfs. By
@@ -30,3 +30,10 @@ config IWM_DEBUG
 	  Or, if you want the full debug, for all modules:
 	  echo 0xff > /sys/kernel/debug/iwm/phyN/debug/level
 	  echo 0xff > /sys/kernel/debug/iwm/phyN/debug/modules
+
+config IWM_TRACING
+	bool "Enable event tracing for iwmc3200wifi"
+	depends on IWM && EVENT_TRACING
+	help
+	  Say Y here to trace all the commands and responses between
+	  the driver and firmware (including TX/RX frames) with ftrace.