Merge 4.17-rc3 into tty-next

We want the tty and serial driver fixes in here as well.

Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

5 files changed, 29 insertions, 9 deletions

diff --git a/drivers/tty/serial/earlycon.c b/drivers/tty/serial/earlycon.c
index eb1f84258c44..149d0d0da65e 100644
--- a/drivers/tty/serial/earlycon.c
+++ b/drivers/tty/serial/earlycon.c
@@ -169,7 +169,7 @@ static int __init register_earlycon(char *buf, const struct earlycon_id *match)
  */
 int __init setup_earlycon(char *buf)
 {
-	const struct earlycon_id *match;
+	const struct earlycon_id **p_match;
 
 	if (!buf || !buf[0])
 		return -EINVAL;
@@ -177,7 +177,9 @@ int __init setup_earlycon(char *buf)
 	if (early_con.flags & CON_ENABLED)
 		return -EALREADY;
 
-	for (match = __earlycon_table; match < __earlycon_table_end; match++) {
+	for (p_match = __earlycon_table; p_match < __earlycon_table_end;
+	     p_match++) {
+		const struct earlycon_id *match = *p_match;
 		size_t len = strlen(match->name);
 
 		if (strncmp(buf, match->name, len))
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index f370c1cf4f27..dd573d8ce087 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -316,7 +316,7 @@ static u32 imx_uart_readl(struct imx_port *sport, u32 offset)
 		 * differ from the value that was last written. As it only
 		 * clears after being set, reread conditionally.
 		 */
-		if (sport->ucr2 & UCR2_SRST)
+		if (!(sport->ucr2 & UCR2_SRST))
 			sport->ucr2 = readl(sport->port.membase + offset);
 		return sport->ucr2;
 		break;
@@ -1833,6 +1833,11 @@ static int imx_uart_rs485_config(struct uart_port *port,
 		rs485conf->flags &= ~SER_RS485_ENABLED;
 
 	if (rs485conf->flags & SER_RS485_ENABLED) {
+		/* Enable receiver if low-active RTS signal is requested */
+		if (sport->have_rtscts &&  !sport->have_rtsgpio &&
+		    !(rs485conf->flags & SER_RS485_RTS_ON_SEND))
+			rs485conf->flags |= SER_RS485_RX_DURING_TX;
+
 		/* disable transmitter */
 		ucr2 = imx_uart_readl(sport, UCR2);
 		if (rs485conf->flags & SER_RS485_RTS_AFTER_SEND)
@@ -2265,6 +2270,18 @@ static int imx_uart_probe(struct platform_device *pdev)
 	    (!sport->have_rtscts && !sport->have_rtsgpio))
 		dev_err(&pdev->dev, "no RTS control, disabling rs485\n");
 
+	/*
+	 * If using the i.MX UART RTS/CTS control then the RTS (CTS_B)
+	 * signal cannot be set low during transmission in case the
+	 * receiver is off (limitation of the i.MX UART IP).
+	 */
+	if (sport->port.rs485.flags & SER_RS485_ENABLED &&
+	    sport->have_rtscts && !sport->have_rtsgpio &&
+	    (!(sport->port.rs485.flags & SER_RS485_RTS_ON_SEND) &&
+	     !(sport->port.rs485.flags & SER_RS485_RX_DURING_TX)))
+		dev_err(&pdev->dev,
+			"low-active RTS not possible when receiver is off, enabling receiver\n");
+
 	imx_uart_rs485_config(&sport->port, &sport->port.rs485);
 
 	/* Disable interrupts before requesting them */
diff --git a/drivers/tty/serial/mvebu-uart.c b/drivers/tty/serial/mvebu-uart.c
index 013b86a1044f..d04b5eeea3c6 100644
--- a/drivers/tty/serial/mvebu-uart.c
+++ b/drivers/tty/serial/mvebu-uart.c
@@ -511,7 +511,6 @@ static void mvebu_uart_set_termios(struct uart_port *port,
 		termios->c_iflag |= old->c_iflag & ~(INPCK | IGNPAR);
 		termios->c_cflag &= CREAD | CBAUD;
 		termios->c_cflag |= old->c_cflag & ~(CREAD | CBAUD);
-		termios->c_lflag = old->c_lflag;
 	}
 
 	spin_unlock_irqrestore(&port->lock, flags);
diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 66558d42d980..c3eb87c028a6 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -1022,6 +1022,7 @@ static int qcom_geni_serial_probe(struct platform_device *pdev)
 	struct qcom_geni_serial_port *port;
 	struct uart_port *uport;
 	struct resource *res;
+	int irq;
 
 	if (pdev->dev.of_node)
 		line = of_alias_get_id(pdev->dev.of_node, "serial");
@@ -1061,11 +1062,12 @@ static int qcom_geni_serial_probe(struct platform_device *pdev)
 	port->rx_fifo_depth = DEF_FIFO_DEPTH_WORDS;
 	port->tx_fifo_width = DEF_FIFO_WIDTH_BITS;
 
-	uport->irq = platform_get_irq(pdev, 0);
-	if (uport->irq < 0) {
-		dev_err(&pdev->dev, "Failed to get IRQ %d\n", uport->irq);
-		return uport->irq;
+	irq = platform_get_irq(pdev, 0);
+	if (irq < 0) {
+		dev_err(&pdev->dev, "Failed to get IRQ %d\n", irq);
+		return irq;
 	}
+	uport->irq = irq;
 
 	uport->private_data = &qcom_geni_console_driver;
 	platform_set_drvdata(pdev, port);
diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c
index 3e68d6302614..8a3e34234e98 100644
--- a/drivers/tty/serial/xilinx_uartps.c
+++ b/drivers/tty/serial/xilinx_uartps.c
@@ -1142,7 +1142,7 @@ static int __init cdns_early_console_setup(struct earlycon_device *device,
 	/* only set baud if specified on command line - otherwise
 	 * assume it has been initialized by a boot loader.
 	 */
-	if (device->baud) {
+	if (port->uartclk && device->baud) {
 		u32 cd = 0, bdiv = 0;
 		u32 mr;
 		int div8;