xhci: Add adaptive interrupt rate for isoch TRBs with XHCI_AVOID_BEI quirk

Save a bit of power by not interrupting so often by default if
XHCI_AVOID_BEI quirk is set.

In normal cases the xhci driver will only generate an interrupt on the last
isochronous TRB of an URB. In a common UVC webcam usecase there are 32 TRBs
per URB.

if AVOID_BEI flag is set then xhci driver will force an interrupt every 8th
isoc TRB to make sure the event ring doesn't get too full.

This is however way too frequent in common single webcam use cases, causing
1000 interrupts/sec and thus poor powermanagement performance.

Instead start with interrupting every 32 isoc TRB, and halve it in case
event ring becomes half-full. Stop halving when reaching a rate of every
8th trb.

This is a one way solution. If interrupt rate is increased it will stay
high until driver is reloaded. The highest rate is the same as the old
default rate.

Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Link: https://lore.kernel.org/r/20210617150354.1512157-3-mathias.nyman@linux.intel.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

1 files changed, 2 insertions, 0 deletions

diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c
index f66815fe8482..2f6da35e7977 100644
--- a/drivers/usb/host/xhci-mem.c
+++ b/drivers/usb/host/xhci-mem.c
@@ -2547,6 +2547,8 @@ int xhci_mem_init(struct xhci_hcd *xhci, gfp_t flags)
 	xhci_dbg_trace(xhci, trace_xhci_dbg_init,
 			"Wrote ERST address to ir_set 0.");
 
+	xhci->isoc_bei_interval = AVOID_BEI_INTERVAL_MAX;
+
 	/*
 	 * XXX: Might need to set the Interrupter Moderation Register to
 	 * something other than the default (~1ms minimum between interrupts).