iio: st_sensors: support active-low interrupts

Most ST MEMS Sensors that support interrupts can also handle sending
an active low interrupt, i.e. going from high to low on data ready
(or other interrupt) and thus triggering on a falling edge to the
interrupt controller.

Set up logic to inspect the interrupt line we get for a sensor: if
it is triggering on rising edge, leave everything alone, but if it
triggers on falling edges, set up active low, and if unsupported
configurations appear: warn with errors and reconfigure the interrupt
to a rising edge, which all interrupt generating sensors support.

Create a local header for st_sensors_core.h to share functions
between the sensor core and the trigger setup code.

Cc: Giuseppe Barba <giuseppe.barba@st.com>
Cc: Denis Ciocca <denis.ciocca@st.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>

1 files changed, 4 insertions, 0 deletions

diff --git a/include/linux/iio/common/st_sensors.h b/include/linux/iio/common/st_sensors.h
index 2fe939c73cd2..6670c3d25c58 100644
--- a/include/linux/iio/common/st_sensors.h
+++ b/include/linux/iio/common/st_sensors.h
@@ -119,6 +119,8 @@ struct st_sensor_bdu {
  * @addr: address of the register.
  * @mask_int1: mask to enable/disable IRQ on INT1 pin.
  * @mask_int2: mask to enable/disable IRQ on INT2 pin.
+ * @addr_ihl: address to enable/disable active low on the INT lines.
+ * @mask_ihl: mask to enable/disable active low on the INT lines.
  * struct ig1 - represents the Interrupt Generator 1 of sensors.
  * @en_addr: address of the enable ig1 register.
  * @en_mask: mask to write the on/off value for enable.
@@ -127,6 +129,8 @@ struct st_sensor_data_ready_irq {
 	u8 addr;
 	u8 mask_int1;
 	u8 mask_int2;
+	u8 addr_ihl;
+	u8 mask_ihl;
 	struct {
 		u8 en_addr;
 		u8 en_mask;