diff options
Diffstat (limited to 'Documentation/admin-guide/kernel-parameters.txt')
| -rw-r--r-- | Documentation/admin-guide/kernel-parameters.txt | 33 |
1 files changed, 30 insertions, 3 deletions
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt index 6d380890e075..b90fe3b6bc6c 100644 --- a/Documentation/admin-guide/kernel-parameters.txt +++ b/Documentation/admin-guide/kernel-parameters.txt @@ -1759,12 +1759,24 @@ nobypass [PPC/POWERNV] Disable IOMMU bypass, using IOMMU for PCI devices. + iommu.strict= [ARM64] Configure TLB invalidation behaviour + Format: { "0" | "1" } + 0 - Lazy mode. + Request that DMA unmap operations use deferred + invalidation of hardware TLBs, for increased + throughput at the cost of reduced device isolation. + Will fall back to strict mode if not supported by + the relevant IOMMU driver. + 1 - Strict mode (default). + DMA unmap operations invalidate IOMMU hardware TLBs + synchronously. + iommu.passthrough= [ARM64] Configure DMA to bypass the IOMMU by default. Format: { "0" | "1" } 0 - Use IOMMU translation for DMA. 1 - Bypass the IOMMU for DMA. - unset - Use IOMMU translation for DMA. + unset - Use value of CONFIG_IOMMU_DEFAULT_PASSTHROUGH. io7= [HW] IO7 for Marvel based alpha systems See comment before marvel_specify_io7 in @@ -2284,6 +2296,8 @@ ltpc= [NET] Format: <io>,<irq>,<dma> + lsm.debug [SECURITY] Enable LSM initialization debugging output. + machvec= [IA-64] Force the use of a particular machine-vector (machvec) in a generic kernel. Example: machvec=hpzx1_swiotlb @@ -2414,7 +2428,7 @@ seconds. Use this parameter to check at some other rate. 0 disables periodic checking. - memtest= [KNL,X86,ARM] Enable memtest + memtest= [KNL,X86,ARM,PPC] Enable memtest Format: <integer> default : 0 <disable> Specifies the number of memtest passes to be @@ -4621,7 +4635,8 @@ usbcore.old_scheme_first= [USB] Start with the old device initialization - scheme (default 0 = off). + scheme, applies only to low and full-speed devices + (default 0 = off). usbcore.usbfs_memory_mb= [USB] Memory limit (in MB) for buffers allocated by @@ -4836,6 +4851,18 @@ This is actually a boot loader parameter; the value is passed to the kernel using a special protocol. + vm_debug[=options] [KNL] Available with CONFIG_DEBUG_VM=y. + May slow down system boot speed, especially when + enabled on systems with a large amount of memory. + All options are enabled by default, and this + interface is meant to allow for selectively + enabling or disabling specific virtual memory + debugging features. + + Available options are: + P Enable page structure init time poisoning + - Disable all of the above options + vmalloc=nn[KMG] [KNL,BOOT] Forces the vmalloc area to have an exact size of <nn>. This can be used to increase the minimum size (128MB on x86). It can also be used to |