diff options
Diffstat (limited to 'Documentation/devicetree')
9 files changed, 53 insertions, 14 deletions
diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt index 5fa691e6f638..cee9d5055fa2 100644 --- a/Documentation/devicetree/bindings/i2c/i2c.txt +++ b/Documentation/devicetree/bindings/i2c/i2c.txt @@ -62,6 +62,9 @@ wants to support one of the below features, it should adapt the bindings below. "irq" and "wakeup" names are recognized by I2C core, other names are left to individual drivers. +- host-notify + device uses SMBus host notify protocol instead of interrupt line. + - multi-master states that there is another master active on this bus. The OS can use this information to adapt power management to keep the arbitration awake @@ -81,6 +84,11 @@ Binding may contain optional "interrupts" property, describing interrupts used by the device. I2C core will assign "irq" interrupt (or the very first interrupt if not using interrupt names) as primary interrupt for the slave. +Alternatively, devices supporting SMbus Host Notify, and connected to +adapters that support this feature, may use "host-notify" property. I2C +core will create a virtual interrupt for Host Notify and assign it as +primary interrupt for the slave. + Also, if device is marked as a wakeup source, I2C core will set up "wakeup" interrupt for the device. If "wakeup" interrupt name is not present in the binding, then primary interrupt will be used as wakeup interrupt. diff --git a/Documentation/devicetree/bindings/interrupt-controller/snps,archs-idu-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/snps,archs-idu-intc.txt index 0dcb7c7d3e40..944657684d73 100644 --- a/Documentation/devicetree/bindings/interrupt-controller/snps,archs-idu-intc.txt +++ b/Documentation/devicetree/bindings/interrupt-controller/snps,archs-idu-intc.txt @@ -15,6 +15,9 @@ Properties: Second cell specifies the irq distribution mode to cores 0=Round Robin; 1=cpu0, 2=cpu1, 4=cpu2, 8=cpu3 + The second cell in interrupts property is deprecated and may be ignored by + the kernel. + intc accessed via the special ARC AUX register interface, hence "reg" property is not specified. diff --git a/Documentation/devicetree/bindings/mtd/tango-nand.txt b/Documentation/devicetree/bindings/mtd/tango-nand.txt index ad5a02f2ac8c..cd1bf2ac9055 100644 --- a/Documentation/devicetree/bindings/mtd/tango-nand.txt +++ b/Documentation/devicetree/bindings/mtd/tango-nand.txt @@ -5,7 +5,7 @@ Required properties: - compatible: "sigma,smp8758-nand" - reg: address/size of nfc_reg, nfc_mem, and pbus_reg - dmas: reference to the DMA channel used by the controller -- dma-names: "nfc_sbox" +- dma-names: "rxtx" - clocks: reference to the system clock - #address-cells: <1> - #size-cells: <0> @@ -17,9 +17,9 @@ Example: nandc: nand-controller@2c000 { compatible = "sigma,smp8758-nand"; - reg = <0x2c000 0x30 0x2d000 0x800 0x20000 0x1000>; + reg = <0x2c000 0x30>, <0x2d000 0x800>, <0x20000 0x1000>; dmas = <&dma0 3>; - dma-names = "nfc_sbox"; + dma-names = "rxtx"; clocks = <&clkgen SYS_CLK>; #address-cells = <1>; #size-cells = <0>; diff --git a/Documentation/devicetree/bindings/net/mediatek-net.txt b/Documentation/devicetree/bindings/net/mediatek-net.txt index c010fafc66a8..c7194e87d5f4 100644 --- a/Documentation/devicetree/bindings/net/mediatek-net.txt +++ b/Documentation/devicetree/bindings/net/mediatek-net.txt @@ -7,7 +7,7 @@ have dual GMAC each represented by a child node.. * Ethernet controller node Required properties: -- compatible: Should be "mediatek,mt7623-eth" +- compatible: Should be "mediatek,mt2701-eth" - reg: Address and length of the register set for the device - interrupts: Should contain the three frame engines interrupts in numeric order. These are fe_int0, fe_int1 and fe_int2. diff --git a/Documentation/devicetree/bindings/net/phy.txt b/Documentation/devicetree/bindings/net/phy.txt index ff1bc4b1bb3b..fb5056b22685 100644 --- a/Documentation/devicetree/bindings/net/phy.txt +++ b/Documentation/devicetree/bindings/net/phy.txt @@ -19,8 +19,9 @@ Optional Properties: specifications. If neither of these are specified, the default is to assume clause 22. - If the phy's identifier is known then the list may contain an entry - of the form: "ethernet-phy-idAAAA.BBBB" where + If the PHY reports an incorrect ID (or none at all) then the + "compatible" list may contain an entry with the correct PHY ID in the + form: "ethernet-phy-idAAAA.BBBB" where AAAA - The value of the 16 bit Phy Identifier 1 register as 4 hex digits. This is the chip vendor OUI bits 3:18 BBBB - The value of the 16 bit Phy Identifier 2 register as diff --git a/Documentation/devicetree/bindings/net/ti,dp83867.txt b/Documentation/devicetree/bindings/net/ti,dp83867.txt index 85bf945b898f..afe9630a5e7d 100644 --- a/Documentation/devicetree/bindings/net/ti,dp83867.txt +++ b/Documentation/devicetree/bindings/net/ti,dp83867.txt @@ -3,9 +3,11 @@ Required properties: - reg - The ID number for the phy, usually a small integer - ti,rx-internal-delay - RGMII Receive Clock Delay - see dt-bindings/net/ti-dp83867.h - for applicable values + for applicable values. Required only if interface type is + PHY_INTERFACE_MODE_RGMII_ID or PHY_INTERFACE_MODE_RGMII_RXID - ti,tx-internal-delay - RGMII Transmit Clock Delay - see dt-bindings/net/ti-dp83867.h - for applicable values + for applicable values. Required only if interface type is + PHY_INTERFACE_MODE_RGMII_ID or PHY_INTERFACE_MODE_RGMII_TXID - ti,fifo-depth - Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h for applicable values diff --git a/Documentation/devicetree/bindings/sound/mt2701-afe-pcm.txt b/Documentation/devicetree/bindings/sound/mt2701-afe-pcm.txt index 3e623a724e55..9800a560e0c2 100644 --- a/Documentation/devicetree/bindings/sound/mt2701-afe-pcm.txt +++ b/Documentation/devicetree/bindings/sound/mt2701-afe-pcm.txt @@ -4,6 +4,7 @@ Required properties: - compatible = "mediatek,mt2701-audio"; - reg: register location and size - interrupts: Should contain AFE interrupt +- power-domains: should define the power domain - clock-names: should have these clock names: "infra_sys_audio_clk", "top_audio_mux1_sel", @@ -58,6 +59,7 @@ Example: <0 0x112A0000 0 0x20000>; interrupts = <GIC_SPI 104 IRQ_TYPE_LEVEL_LOW>, <GIC_SPI 132 IRQ_TYPE_LEVEL_LOW>; + power-domains = <&scpsys MT2701_POWER_DOMAIN_IFR_MSC>; clocks = <&infracfg CLK_INFRA_AUDIO>, <&topckgen CLK_TOP_AUD_MUX1_SEL>, <&topckgen CLK_TOP_AUD_MUX2_SEL>, diff --git a/Documentation/devicetree/bindings/sound/nau8540.txt b/Documentation/devicetree/bindings/sound/nau8540.txt new file mode 100644 index 000000000000..307a76528320 --- /dev/null +++ b/Documentation/devicetree/bindings/sound/nau8540.txt @@ -0,0 +1,16 @@ +NAU85L40 audio CODEC + +This device supports I2C only. + +Required properties: + + - compatible : "nuvoton,nau8540" + + - reg : the I2C address of the device. + +Example: + +codec: nau8540@1c { + compatible = "nuvoton,nau8540"; + reg = <0x1c>; +}; diff --git a/Documentation/devicetree/bindings/spi/sh-msiof.txt b/Documentation/devicetree/bindings/spi/sh-msiof.txt index da6614c63796..dc975064fa27 100644 --- a/Documentation/devicetree/bindings/spi/sh-msiof.txt +++ b/Documentation/devicetree/bindings/spi/sh-msiof.txt @@ -1,17 +1,23 @@ Renesas MSIOF spi controller Required properties: -- compatible : "renesas,msiof-<soctype>" for SoCs, - "renesas,sh-msiof" for SuperH, or - "renesas,sh-mobile-msiof" for SH Mobile series. - Examples with soctypes are: - "renesas,msiof-r8a7790" (R-Car H2) +- compatible : "renesas,msiof-r8a7790" (R-Car H2) "renesas,msiof-r8a7791" (R-Car M2-W) "renesas,msiof-r8a7792" (R-Car V2H) "renesas,msiof-r8a7793" (R-Car M2-N) "renesas,msiof-r8a7794" (R-Car E2) "renesas,msiof-r8a7796" (R-Car M3-W) "renesas,msiof-sh73a0" (SH-Mobile AG5) + "renesas,sh-mobile-msiof" (generic SH-Mobile compatibile device) + "renesas,rcar-gen2-msiof" (generic R-Car Gen2 compatible device) + "renesas,rcar-gen3-msiof" (generic R-Car Gen3 compatible device) + "renesas,sh-msiof" (deprecated) + + When compatible with the generic version, nodes + must list the SoC-specific version corresponding + to the platform first followed by the generic + version. + - reg : A list of offsets and lengths of the register sets for the device. If only one register set is present, it is to be used @@ -61,7 +67,8 @@ Documentation/devicetree/bindings/pinctrl/renesas,*. Example: msiof0: spi@e6e20000 { - compatible = "renesas,msiof-r8a7791"; + compatible = "renesas,msiof-r8a7791", + "renesas,rcar-gen2-msiof"; reg = <0 0xe6e20000 0 0x0064>; interrupts = <0 156 IRQ_TYPE_LEVEL_HIGH>; clocks = <&mstp0_clks R8A7791_CLK_MSIOF0>; |