diff options
Diffstat (limited to 'Documentation/spi')
| -rw-r--r-- | Documentation/spi/pxa2xx.rst | 6 |
1 files changed, 0 insertions, 6 deletions
diff --git a/Documentation/spi/pxa2xx.rst b/Documentation/spi/pxa2xx.rst index dfc7673ed15d..6347580826be 100644 --- a/Documentation/spi/pxa2xx.rst +++ b/Documentation/spi/pxa2xx.rst @@ -101,7 +101,6 @@ device. All fields are optional. u8 rx_threshold; u8 dma_burst_size; u32 timeout; - u8 enable_loopback; int gpio_cs; }; @@ -128,11 +127,6 @@ dependent on the SPI bus speed ("spi_board_info.max_speed_hz") and the specific slave device. Please note that the PXA2xx SSP 1 does not support trailing byte timeouts and must busy-wait any trailing bytes. -The "pxa2xx_spi_chip.enable_loopback" field is used to place the SSP porting -into internal loopback mode. In this mode the SSP controller internally -connects the SSPTX pin to the SSPRX pin. This is useful for initial setup -testing. - NOTE: the SPI driver cannot control the chip select if SSPFRM is used, so the chipselect is dropped after each spi_transfer. Most devices need chip select asserted around the complete message. Use SSPFRM as a GPIO (through a descriptor) |