diff options
Diffstat (limited to 'arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi')
| -rw-r--r-- | arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi | 64 |
1 files changed, 48 insertions, 16 deletions
diff --git a/arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi b/arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi index f3e3418f7edc..ae08556b2ef2 100644 --- a/arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi +++ b/arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi @@ -7,6 +7,7 @@ #include "dt-bindings/input/input.h" #include <dt-bindings/interrupt-controller/irq.h> +#include <dt-bindings/leds/common.h> #include "dt-bindings/pwm/pwm.h" #include "dt-bindings/usb/pd.h" #include "imx8mq.dtsi" @@ -37,18 +38,45 @@ pinctrl-names = "default"; pinctrl-0 = <&pinctrl_keys>; - vol-down { + key-vol-down { label = "VOL_DOWN"; gpios = <&gpio1 17 GPIO_ACTIVE_LOW>; linux,code = <KEY_VOLUMEDOWN>; debounce-interval = <50>; + wakeup-source; }; - vol-up { + key-vol-up { label = "VOL_UP"; gpios = <&gpio1 16 GPIO_ACTIVE_LOW>; linux,code = <KEY_VOLUMEUP>; debounce-interval = <50>; + wakeup-source; + }; + }; + + led-controller { + compatible = "pwm-leds"; + + led-0 { + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_BLUE>; + max-brightness = <248>; + pwms = <&pwm2 0 50000 0>; + }; + + led-1 { + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_GREEN>; + max-brightness = <248>; + pwms = <&pwm4 0 50000 0>; + }; + + led-2 { + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_RED>; + max-brightness = <248>; + pwms = <&pwm3 0 50000 0>; }; }; @@ -278,6 +306,7 @@ &ddrc { operating-points-v2 = <&ddrc_opp_table>; + status = "okay"; ddrc_opp_table: opp-table { compatible = "operating-points-v2"; @@ -322,15 +351,10 @@ }; partition@30000 { - label = "protected1"; - reg = <0x30000 0x10000>; + label = "firmware"; + reg = <0x30000 0x1d0000>; read-only; }; - - partition@40000 { - label = "rw"; - reg = <0x40000 0x1C0000>; - }; }; }; @@ -386,8 +410,6 @@ fsl,pins = < /* CHRG_INT */ MX8MQ_IOMUXC_NAND_CE2_B_GPIO3_IO3 0x80 - /* CHG_STATUS_B */ - MX8MQ_IOMUXC_NAND_ALE_GPIO3_IO0 0x80 >; }; @@ -751,6 +773,10 @@ interrupt-names = "irq"; connector { + compatible = "usb-c-connector"; + label = "USB-C"; + data-role = "dual"; + ports { #address-cells = <1>; #size-cells = <0>; @@ -1074,6 +1100,12 @@ pinctrl-0 = <&pinctrl_i2c4>; status = "okay"; + vcm@c { + compatible = "dongwoon,dw9714"; + reg = <0x0c>; + vcc-supply = <®_csi_1v8>; + }; + bat: fuel-gauge@36 { compatible = "maxim,max17055"; reg = <0x36>; @@ -1081,6 +1113,7 @@ interrupts = <20 IRQ_TYPE_LEVEL_LOW>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_gauge>; + power-supplies = <&bq25895>; maxim,over-heat-temp = <700>; maxim,over-volt = <4500>; maxim,rsns-microohm = <5000>; @@ -1097,7 +1130,7 @@ ti,precharge-current = <130000>; /* uA */ ti,minimum-sys-voltage = <3700000>; /* uV */ ti,boost-voltage = <5000000>; /* uV */ - ti,boost-max-current = <500000>; /* uA */ + ti,boost-max-current = <1500000>; /* uA */ ti,use-vinmin-threshold = <1>; /* enable VINDPM */ ti,vinmin-threshold = <3900000>; /* uV */ monitored-battery = <&bat>; @@ -1110,13 +1143,11 @@ }; &mipi_csi1 { - #address-cells = <1>; - #size-cells = <0>; status = "okay"; ports { - port@1 { - reg = <1>; + port@0 { + reg = <0>; mipi1_sensor_ep: endpoint { remote-endpoint = <&camera1_ep>; @@ -1269,6 +1300,7 @@ #size-cells = <0>; dr_mode = "otg"; snps,dis_u3_susphy_quirk; + usb-role-switch; status = "okay"; port@0 { |