diff options
Diffstat (limited to 'arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts')
| -rw-r--r-- | arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts | 141 |
1 files changed, 137 insertions, 4 deletions
diff --git a/arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts b/arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts index d4af9e0dad87..30c94fd4fe61 100644 --- a/arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts +++ b/arch/arm64/boot/dts/qcom/sm7225-fairphone-fp4.dts @@ -10,7 +10,9 @@ #include <dt-bindings/pinctrl/qcom,pmic-gpio.h> #include <dt-bindings/regulator/qcom,rpmh-regulator.h> #include "sm7225.dtsi" +#include "pm6150l.dtsi" #include "pm6350.dtsi" +#include "pm7250b.dtsi" / { model = "Fairphone 4"; @@ -22,7 +24,7 @@ qcom,board-id = <8 32>; aliases { - serial0 = &uart2; + serial0 = &uart9; }; chosen { @@ -47,7 +49,7 @@ pinctrl-names = "default"; pinctrl-0 = <&gpio_keys_pin>; - volume-up { + key-volume-up { label = "volume_up"; linux,code = <KEY_VOLUMEUP>; gpios = <&pm6350_gpios 2 GPIO_ACTIVE_LOW>; @@ -69,6 +71,36 @@ qcom,vmid = <15>; }; }; + + thermal-zones { + chg-skin-thermal { + polling-delay-passive = <0>; + polling-delay = <0>; + thermal-sensors = <&pm7250b_adc_tm 0>; + + trips { + active-config0 { + temperature = <125000>; + hysteresis = <1000>; + type = "passive"; + }; + }; + }; + + conn-thermal { + polling-delay-passive = <0>; + polling-delay = <0>; + thermal-sensors = <&pm7250b_adc_tm 1>; + + trips { + active-config0 { + temperature = <125000>; + hysteresis = <1000>; + type = "passive"; + }; + }; + }; + }; }; &adsp { @@ -295,13 +327,50 @@ firmware-name = "qcom/sm7225/fairphone4/cdsp.mdt"; }; +&i2c10 { + status = "okay"; + clock-frequency = <400000>; + + haptics@5a { + compatible = "awinic,aw8695"; + reg = <0x5a>; + interrupts-extended = <&tlmm 85 IRQ_TYPE_EDGE_FALLING>; + reset-gpios = <&tlmm 90 GPIO_ACTIVE_HIGH>; + + awinic,f0-preset = <2350>; + awinic,f0-coefficient = <260>; + awinic,f0-calibration-percent = <7>; + awinic,drive-level = <125>; + + awinic,f0-detection-play-time = <5>; + awinic,f0-detection-wait-time = <3>; + awinic,f0-detection-repeat = <2>; + awinic,f0-detection-trace = <15>; + + awinic,boost-debug = /bits/ 8 <0x30 0xeb 0xd4>; + awinic,tset = /bits/ 8 <0x12>; + awinic,r-spare = /bits/ 8 <0x68>; + + awinic,bemf-upper-threshold = <4104>; + awinic,bemf-lower-threshold = <1016>; + }; +}; + &mpss { status = "okay"; firmware-name = "qcom/sm7225/fairphone4/modem.mdt"; }; +&pm6150l_wled { + status = "okay"; + + qcom,switching-freq = <800>; + qcom,current-limit-microamp = <20000>; + qcom,num-strings = <2>; +}; + &pm6350_gpios { - gpio_keys_pin: gpio-keys-pin { + gpio_keys_pin: gpio-keys-state { pins = "gpio2"; function = PMIC_GPIO_FUNC_NORMAL; bias-pull-up; @@ -315,6 +384,42 @@ linux,code = <KEY_VOLUMEDOWN>; }; +&pm7250b_adc { + adc-chan@4d { + reg = <ADC5_AMUX_THM1_100K_PU>; + qcom,ratiometric; + qcom,hw-settle-time = <200>; + qcom,pre-scaling = <1 1>; + label = "charger_skin_therm"; + }; + + adc-chan@4f { + reg = <ADC5_AMUX_THM3_100K_PU>; + qcom,ratiometric; + qcom,hw-settle-time = <200>; + qcom,pre-scaling = <1 1>; + label = "conn_therm"; + }; +}; + +&pm7250b_adc_tm { + status = "okay"; + + charger-skin-therm@0 { + reg = <0>; + io-channels = <&pm7250b_adc ADC5_AMUX_THM1_100K_PU>; + qcom,ratiometric; + qcom,hw-settle-time-us = <200>; + }; + + conn-therm@1 { + reg = <1>; + io-channels = <&pm7250b_adc ADC5_AMUX_THM3_100K_PU>; + qcom,ratiometric; + qcom,hw-settle-time-us = <200>; + }; +}; + &qupv3_id_1 { status = "okay"; }; @@ -323,8 +428,26 @@ gpio-reserved-ranges = <13 4>, <56 2>; }; -&uart2 { +&uart9 { + status = "okay"; +}; + +&ufs_mem_hc { + status = "okay"; + + reset-gpios = <&tlmm 156 GPIO_ACTIVE_LOW>; + + vcc-supply = <&vreg_l7e>; + vcc-max-microamp = <800000>; + vccq2-supply = <&vreg_l12a>; + vccq2-max-microamp = <800000>; +}; + +&ufs_mem_phy { status = "okay"; + + vdda-phy-supply = <&vreg_l18a>; + vdda-pll-supply = <&vreg_l22a>; }; &usb_1 { @@ -350,3 +473,13 @@ vdda-phy-supply = <&vreg_l22a>; vdda-pll-supply = <&vreg_l16a>; }; + +&wifi { + status = "okay"; + + vdd-0.8-cx-mx-supply = <&vreg_l4a>; + vdd-1.8-xo-supply = <&vreg_l7a>; + vdd-1.3-rfa-supply = <&vreg_l2e>; + vdd-3.3-ch0-supply = <&vreg_l10e>; + vdd-3.3-ch1-supply = <&vreg_l11e>; +}; |