diff options
Diffstat (limited to 'arch/arm64/kernel/head.S')
| -rw-r--r-- | arch/arm64/kernel/head.S | 39 |
1 files changed, 31 insertions, 8 deletions
diff --git a/arch/arm64/kernel/head.S b/arch/arm64/kernel/head.S index 61035d6814cb..0fd565000772 100644 --- a/arch/arm64/kernel/head.S +++ b/arch/arm64/kernel/head.S @@ -26,6 +26,7 @@ #include <asm/assembler.h> #include <asm/ptrace.h> #include <asm/asm-offsets.h> +#include <asm/cache.h> #include <asm/cputype.h> #include <asm/memory.h> #include <asm/thread_info.h> @@ -229,7 +230,11 @@ ENTRY(set_cpu_boot_mode_flag) cmp w20, #BOOT_CPU_MODE_EL2 b.ne 1f add x1, x1, #4 -1: str w20, [x1] // This CPU has booted in EL1 +1: dc cvac, x1 // Clean potentially dirty cache line + dsb sy + str w20, [x1] // This CPU has booted in EL1 + dc civac, x1 // Clean&invalidate potentially stale cache line + dsb sy ret ENDPROC(set_cpu_boot_mode_flag) @@ -240,8 +245,9 @@ ENDPROC(set_cpu_boot_mode_flag) * This is not in .bss, because we set it sufficiently early that the boot-time * zeroing of .bss would clobber it. */ - .pushsection .data + .pushsection .data..cacheline_aligned ENTRY(__boot_cpu_mode) + .align L1_CACHE_SHIFT .long BOOT_CPU_MODE_EL2 .long 0 .popsection @@ -404,10 +410,19 @@ ENDPROC(__calc_phys_offset) * - identity mapping to enable the MMU (low address, TTBR0) * - first few MB of the kernel linear mapping to jump to once the MMU has * been enabled, including the FDT blob (TTBR1) - * - UART mapping if CONFIG_EARLY_PRINTK is enabled (TTBR1) + * - pgd entry for fixed mappings (TTBR1) */ __create_page_tables: pgtbl x25, x26, x24 // idmap_pg_dir and swapper_pg_dir addresses + mov x27, lr + + /* + * Invalidate the idmap and swapper page tables to avoid potential + * dirty cache lines being evicted. + */ + mov x0, x25 + add x1, x26, #SWAPPER_DIR_SIZE + bl __inval_cache_range /* * Clear the idmap and swapper page tables. @@ -461,15 +476,23 @@ __create_page_tables: sub x6, x6, #1 // inclusive range create_block_map x0, x7, x3, x5, x6 1: -#ifdef CONFIG_EARLY_PRINTK /* - * Create the pgd entry for the UART mapping. The full mapping is done - * later based earlyprintk kernel parameter. + * Create the pgd entry for the fixed mappings. */ - ldr x5, =EARLYCON_IOBASE // UART virtual address + ldr x5, =FIXADDR_TOP // Fixed mapping virtual address add x0, x26, #2 * PAGE_SIZE // section table address create_pgd_entry x26, x0, x5, x6, x7 -#endif + + /* + * Since the page tables have been populated with non-cacheable + * accesses (MMU disabled), invalidate the idmap and swapper page + * tables again to remove any speculatively loaded cache lines. + */ + mov x0, x25 + add x1, x26, #SWAPPER_DIR_SIZE + bl __inval_cache_range + + mov lr, x27 ret ENDPROC(__create_page_tables) .ltorg |