diff options
Diffstat (limited to 'arch/ppc/platforms/85xx/mpc85xx_cds_common.c')
| -rw-r--r-- | arch/ppc/platforms/85xx/mpc85xx_cds_common.c | 143 |
1 files changed, 141 insertions, 2 deletions
diff --git a/arch/ppc/platforms/85xx/mpc85xx_cds_common.c b/arch/ppc/platforms/85xx/mpc85xx_cds_common.c index 6c020d67ad70..e7cfa498568c 100644 --- a/arch/ppc/platforms/85xx/mpc85xx_cds_common.c +++ b/arch/ppc/platforms/85xx/mpc85xx_cds_common.c @@ -44,6 +44,7 @@ #include <asm/machdep.h> #include <asm/prom.h> #include <asm/open_pic.h> +#include <asm/i8259.h> #include <asm/bootinfo.h> #include <asm/pci-bridge.h> #include <asm/mpc85xx.h> @@ -181,6 +182,7 @@ void __init mpc85xx_cds_init_IRQ(void) { bd_t *binfo = (bd_t *) __res; + int i; /* Determine the Physical Address of the OpenPIC regs */ phys_addr_t OpenPIC_PAddr = binfo->bi_immr_base + MPC85xx_OPENPIC_OFFSET; @@ -198,6 +200,15 @@ mpc85xx_cds_init_IRQ(void) */ openpic_init(MPC85xx_OPENPIC_IRQ_OFFSET); +#ifdef CONFIG_PCI + openpic_hookup_cascade(PIRQ0A, "82c59 cascade", i8259_irq); + + for (i = 0; i < NUM_8259_INTERRUPTS; i++) + irq_desc[i].handler = &i8259_pic; + + i8259_init(0); +#endif + #ifdef CONFIG_CPM2 /* Setup CPM2 PIC */ cpm2_init_IRQ(); @@ -231,7 +242,7 @@ mpc85xx_map_irq(struct pci_dev *dev, unsigned char idsel, unsigned char pin) * interrupt on slot */ { { 0, 1, 2, 3 }, /* 16 - PMC */ - { 3, 0, 0, 0 }, /* 17 P2P (Tsi320) */ + { 0, 1, 2, 3 }, /* 17 P2P (Tsi320) */ { 0, 1, 2, 3 }, /* 18 - Slot 1 */ { 1, 2, 3, 0 }, /* 19 - Slot 2 */ { 2, 3, 0, 1 }, /* 20 - Slot 3 */ @@ -280,13 +291,135 @@ mpc85xx_exclude_device(u_char bus, u_char devfn) return PCIBIOS_DEVICE_NOT_FOUND; #endif /* We explicitly do not go past the Tundra 320 Bridge */ - if (bus == 1) + if ((bus == 1) && (PCI_SLOT(devfn) == ARCADIA_2ND_BRIDGE_IDSEL)) return PCIBIOS_DEVICE_NOT_FOUND; if ((bus == 0) && (PCI_SLOT(devfn) == ARCADIA_2ND_BRIDGE_IDSEL)) return PCIBIOS_DEVICE_NOT_FOUND; else return PCIBIOS_SUCCESSFUL; } + +void __init +mpc85xx_cds_enable_via(struct pci_controller *hose) +{ + u32 pci_class; + u16 vid, did; + + early_read_config_dword(hose, 0, 0x88, PCI_CLASS_REVISION, &pci_class); + if ((pci_class >> 16) != PCI_CLASS_BRIDGE_PCI) + return; + + /* Configure P2P so that we can reach bus 1 */ + early_write_config_byte(hose, 0, 0x88, PCI_PRIMARY_BUS, 0); + early_write_config_byte(hose, 0, 0x88, PCI_SECONDARY_BUS, 1); + early_write_config_byte(hose, 0, 0x88, PCI_SUBORDINATE_BUS, 0xff); + + early_read_config_word(hose, 1, 0x10, PCI_VENDOR_ID, &vid); + early_read_config_word(hose, 1, 0x10, PCI_DEVICE_ID, &did); + + if ((vid != PCI_VENDOR_ID_VIA) || + (did != PCI_DEVICE_ID_VIA_82C686)) + return; + + /* Enable USB and IDE functions */ + early_write_config_byte(hose, 1, 0x10, 0x48, 0x08); +} + +void __init +mpc85xx_cds_fixup_via(struct pci_controller *hose) +{ + u32 pci_class; + u16 vid, did; + + early_read_config_dword(hose, 0, 0x88, PCI_CLASS_REVISION, &pci_class); + if ((pci_class >> 16) != PCI_CLASS_BRIDGE_PCI) + return; + + /* + * Force the backplane P2P bridge to have a window + * open from 0x00000000-0x00001fff in PCI I/O space. + * This allows legacy I/O (i8259, etc) on the VIA + * southbridge to be accessed. + */ + early_write_config_byte(hose, 0, 0x88, PCI_IO_BASE, 0x00); + early_write_config_word(hose, 0, 0x88, PCI_IO_BASE_UPPER16, 0x0000); + early_write_config_byte(hose, 0, 0x88, PCI_IO_LIMIT, 0x10); + early_write_config_word(hose, 0, 0x88, PCI_IO_LIMIT_UPPER16, 0x0000); + + early_read_config_word(hose, 1, 0x10, PCI_VENDOR_ID, &vid); + early_read_config_word(hose, 1, 0x10, PCI_DEVICE_ID, &did); + if ((vid != PCI_VENDOR_ID_VIA) || + (did != PCI_DEVICE_ID_VIA_82C686)) + return; + + /* + * Since the P2P window was forced to cover the fixed + * legacy I/O addresses, it is necessary to manually + * place the base addresses for the IDE and USB functions + * within this window. + */ + /* Function 1, IDE */ + early_write_config_dword(hose, 1, 0x11, PCI_BASE_ADDRESS_0, 0x1ff8); + early_write_config_dword(hose, 1, 0x11, PCI_BASE_ADDRESS_1, 0x1ff4); + early_write_config_dword(hose, 1, 0x11, PCI_BASE_ADDRESS_2, 0x1fe8); + early_write_config_dword(hose, 1, 0x11, PCI_BASE_ADDRESS_3, 0x1fe4); + early_write_config_dword(hose, 1, 0x11, PCI_BASE_ADDRESS_4, 0x1fd0); + + /* Function 2, USB ports 0-1 */ + early_write_config_dword(hose, 1, 0x12, PCI_BASE_ADDRESS_4, 0x1fa0); + + /* Function 3, USB ports 2-3 */ + early_write_config_dword(hose, 1, 0x13, PCI_BASE_ADDRESS_4, 0x1f80); + + /* Function 5, Power Management */ + early_write_config_dword(hose, 1, 0x15, PCI_BASE_ADDRESS_0, 0x1e00); + early_write_config_dword(hose, 1, 0x15, PCI_BASE_ADDRESS_1, 0x1dfc); + early_write_config_dword(hose, 1, 0x15, PCI_BASE_ADDRESS_2, 0x1df8); + + /* Function 6, AC97 Interface */ + early_write_config_dword(hose, 1, 0x16, PCI_BASE_ADDRESS_0, 0x1c00); +} + +void __init +mpc85xx_cds_pcibios_fixup(void) +{ + struct pci_dev *dev = NULL; + u_char c; + + if ((dev = pci_find_device(PCI_VENDOR_ID_VIA, + PCI_DEVICE_ID_VIA_82C586_1, NULL))) { + /* + * U-Boot does not set the enable bits + * for the IDE device. Force them on here. + */ + pci_read_config_byte(dev, 0x40, &c); + c |= 0x03; /* IDE: Chip Enable Bits */ + pci_write_config_byte(dev, 0x40, c); + + /* + * Since only primary interface works, force the + * IDE function to standard primary IDE interrupt + * w/ 8259 offset + */ + dev->irq = 14; + pci_write_config_byte(dev, PCI_INTERRUPT_LINE, dev->irq); + } + + /* + * Force legacy USB interrupt routing + */ + if ((dev = pci_find_device(PCI_VENDOR_ID_VIA, + PCI_DEVICE_ID_VIA_82C586_2, NULL))) { + dev->irq = 10; + pci_write_config_byte(dev, PCI_INTERRUPT_LINE, 10); + } + + if ((dev = pci_find_device(PCI_VENDOR_ID_VIA, + PCI_DEVICE_ID_VIA_82C586_2, dev))) { + dev->irq = 11; + pci_write_config_byte(dev, PCI_INTERRUPT_LINE, 11); + } +} #endif /* CONFIG_PCI */ TODC_ALLOC(); @@ -328,6 +461,9 @@ mpc85xx_cds_setup_arch(void) loops_per_jiffy = freq / HZ; #ifdef CONFIG_PCI + /* VIA IDE configuration */ + ppc_md.pcibios_fixup = mpc85xx_cds_pcibios_fixup; + /* setup PCI host bridges */ mpc85xx_setup_hose(); #endif @@ -459,6 +595,9 @@ platform_init(unsigned long r3, unsigned long r4, unsigned long r5, #if defined(CONFIG_SERIAL_8250) && defined(CONFIG_SERIAL_TEXT_DEBUG) ppc_md.progress = gen550_progress; #endif /* CONFIG_SERIAL_8250 && CONFIG_SERIAL_TEXT_DEBUG */ +#if defined(CONFIG_SERIAL_8250) && defined(CONFIG_KGDB) + ppc_md.early_serial_map = mpc85xx_early_serial_map; +#endif /* CONFIG_SERIAL_8250 && CONFIG_KGDB */ if (ppc_md.progress) ppc_md.progress("mpc85xx_cds_init(): exit", 0); |