diff options
Diffstat (limited to 'arch/x86/kernel/head_64.S')
| -rw-r--r-- | arch/x86/kernel/head_64.S | 181 |
1 files changed, 144 insertions, 37 deletions
diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S index 16da4ac01597..3c417734790f 100644 --- a/arch/x86/kernel/head_64.S +++ b/arch/x86/kernel/head_64.S @@ -73,6 +73,20 @@ SYM_CODE_START_NOALIGN(startup_64) /* Set up the stack for verify_cpu(), similar to initial_stack below */ leaq (__end_init_task - SIZEOF_PTREGS)(%rip), %rsp + leaq _text(%rip), %rdi + pushq %rsi + call startup_64_setup_env + popq %rsi + + /* Now switch to __KERNEL_CS so IRET works reliably */ + pushq $__KERNEL_CS + leaq .Lon_kernel_cs(%rip), %rax + pushq %rax + lretq + +.Lon_kernel_cs: + UNWIND_HINT_EMPTY + /* Sanitize CPU configuration */ call verify_cpu @@ -112,6 +126,18 @@ SYM_CODE_START(secondary_startup_64) call verify_cpu /* + * The secondary_startup_64_no_verify entry point is only used by + * SEV-ES guests. In those guests the call to verify_cpu() would cause + * #VC exceptions which can not be handled at this stage of secondary + * CPU bringup. + * + * All non SEV-ES systems, especially Intel systems, need to execute + * verify_cpu() above to make sure NX is enabled. + */ +SYM_INNER_LABEL(secondary_startup_64_no_verify, SYM_L_GLOBAL) + UNWIND_HINT_EMPTY + + /* * Retrieve the modifier (SME encryption mask if SME is active) to be * added to the initial pgdir entry that will be programmed into CR3. */ @@ -135,6 +161,21 @@ SYM_CODE_START(secondary_startup_64) /* Setup early boot stage 4-/5-level pagetables. */ addq phys_base(%rip), %rax + + /* + * For SEV guests: Verify that the C-bit is correct. A malicious + * hypervisor could lie about the C-bit position to perform a ROP + * attack on the guest by writing to the unencrypted stack and wait for + * the next RET instruction. + * %rsi carries pointer to realmode data and is callee-clobbered. Save + * and restore it. + */ + pushq %rsi + movq %rax, %rdi + call sev_verify_cbit + popq %rsi + + /* Switch to new page-table */ movq %rax, %cr3 /* Ensure I am executing from virtual addresses */ @@ -144,33 +185,6 @@ SYM_CODE_START(secondary_startup_64) 1: UNWIND_HINT_EMPTY - /* Check if nx is implemented */ - movl $0x80000001, %eax - cpuid - movl %edx,%edi - - /* Setup EFER (Extended Feature Enable Register) */ - movl $MSR_EFER, %ecx - rdmsr - btsl $_EFER_SCE, %eax /* Enable System Call */ - btl $20,%edi /* No Execute supported? */ - jnc 1f - btsl $_EFER_NX, %eax - btsq $_PAGE_BIT_NX,early_pmd_flags(%rip) -1: wrmsr /* Make changes effective */ - - /* Setup cr0 */ - movl $CR0_STATE, %eax - /* Make changes effective */ - movq %rax, %cr0 - - /* Setup a boot time stack */ - movq initial_stack(%rip), %rsp - - /* zero EFLAGS after setting rsp */ - pushq $0 - popfq - /* * We must switch to a new descriptor in kernel space for the GDT * because soon the kernel won't have access anymore to the userspace @@ -205,6 +219,41 @@ SYM_CODE_START(secondary_startup_64) movl initial_gs+4(%rip),%edx wrmsr + /* + * Setup a boot time stack - Any secondary CPU will have lost its stack + * by now because the cr3-switch above unmaps the real-mode stack + */ + movq initial_stack(%rip), %rsp + + /* Setup and Load IDT */ + pushq %rsi + call early_setup_idt + popq %rsi + + /* Check if nx is implemented */ + movl $0x80000001, %eax + cpuid + movl %edx,%edi + + /* Setup EFER (Extended Feature Enable Register) */ + movl $MSR_EFER, %ecx + rdmsr + btsl $_EFER_SCE, %eax /* Enable System Call */ + btl $20,%edi /* No Execute supported? */ + jnc 1f + btsl $_EFER_NX, %eax + btsq $_PAGE_BIT_NX,early_pmd_flags(%rip) +1: wrmsr /* Make changes effective */ + + /* Setup cr0 */ + movl $CR0_STATE, %eax + /* Make changes effective */ + movq %rax, %cr0 + + /* zero EFLAGS after setting rsp */ + pushq $0 + popfq + /* rsi is pointer to real mode structure with interesting info. pass it to C */ movq %rsi, %rdi @@ -245,6 +294,7 @@ SYM_CODE_START(secondary_startup_64) SYM_CODE_END(secondary_startup_64) #include "verify_cpu.S" +#include "sev_verify_cbit.S" #ifdef CONFIG_HOTPLUG_CPU /* @@ -259,11 +309,47 @@ SYM_CODE_START(start_cpu0) SYM_CODE_END(start_cpu0) #endif +#ifdef CONFIG_AMD_MEM_ENCRYPT +/* + * VC Exception handler used during early boot when running on kernel + * addresses, but before the switch to the idt_table can be made. + * The early_idt_handler_array can't be used here because it calls into a lot + * of __init code and this handler is also used during CPU offlining/onlining. + * Therefore this handler ends up in the .text section so that it stays around + * when .init.text is freed. + */ +SYM_CODE_START_NOALIGN(vc_boot_ghcb) + UNWIND_HINT_IRET_REGS offset=8 + + /* Build pt_regs */ + PUSH_AND_CLEAR_REGS + + /* Call C handler */ + movq %rsp, %rdi + movq ORIG_RAX(%rsp), %rsi + movq initial_vc_handler(%rip), %rax + ANNOTATE_RETPOLINE_SAFE + call *%rax + + /* Unwind pt_regs */ + POP_REGS + + /* Remove Error Code */ + addq $8, %rsp + + /* Pure iret required here - don't use INTERRUPT_RETURN */ + iretq +SYM_CODE_END(vc_boot_ghcb) +#endif + /* Both SMP bootup and ACPI suspend change these variables */ __REFDATA .balign 8 SYM_DATA(initial_code, .quad x86_64_start_kernel) SYM_DATA(initial_gs, .quad INIT_PER_CPU_VAR(fixed_percpu_data)) +#ifdef CONFIG_AMD_MEM_ENCRYPT +SYM_DATA(initial_vc_handler, .quad handle_vc_boot_ghcb) +#endif /* * The SIZEOF_PTREGS gap is a convention which helps the in-kernel unwinder @@ -319,22 +405,43 @@ SYM_CODE_START_LOCAL(early_idt_handler_common) pushq %r15 /* pt_regs->r15 */ UNWIND_HINT_REGS - cmpq $14,%rsi /* Page fault? */ - jnz 10f - GET_CR2_INTO(%rdi) /* can clobber %rax if pv */ - call early_make_pgtable - andl %eax,%eax - jz 20f /* All good */ - -10: movq %rsp,%rdi /* RDI = pt_regs; RSI is already trapnr */ - call early_fixup_exception + call do_early_exception -20: decl early_recursion_flag(%rip) jmp restore_regs_and_return_to_kernel SYM_CODE_END(early_idt_handler_common) +#ifdef CONFIG_AMD_MEM_ENCRYPT +/* + * VC Exception handler used during very early boot. The + * early_idt_handler_array can't be used because it returns via the + * paravirtualized INTERRUPT_RETURN and pv-ops don't work that early. + * + * This handler will end up in the .init.text section and not be + * available to boot secondary CPUs. + */ +SYM_CODE_START_NOALIGN(vc_no_ghcb) + UNWIND_HINT_IRET_REGS offset=8 + + /* Build pt_regs */ + PUSH_AND_CLEAR_REGS + + /* Call C handler */ + movq %rsp, %rdi + movq ORIG_RAX(%rsp), %rsi + call do_vc_no_ghcb + + /* Unwind pt_regs */ + POP_REGS + + /* Remove Error Code */ + addq $8, %rsp + + /* Pure iret required here - don't use INTERRUPT_RETURN */ + iretq +SYM_CODE_END(vc_no_ghcb) +#endif #define SYM_DATA_START_PAGE_ALIGNED(name) \ SYM_START(name, SYM_L_GLOBAL, .balign PAGE_SIZE) |