diff options
Diffstat (limited to 'arch/x86/kernel/setup.c')
| -rw-r--r-- | arch/x86/kernel/setup.c | 76 |
1 files changed, 13 insertions, 63 deletions
diff --git a/arch/x86/kernel/setup.c b/arch/x86/kernel/setup.c index 0957dd73d127..4c616be28506 100644 --- a/arch/x86/kernel/setup.c +++ b/arch/x86/kernel/setup.c @@ -114,7 +114,6 @@ #include <asm/alternative.h> #include <asm/prom.h> #include <asm/microcode.h> -#include <asm/mmu_context.h> #include <asm/kaslr.h> #include <asm/unwind.h> @@ -136,18 +135,6 @@ RESERVE_BRK(dmi_alloc, 65536); static __initdata unsigned long _brk_start = (unsigned long)__brk_base; unsigned long _brk_end = (unsigned long)__brk_base; -#ifdef CONFIG_X86_64 -int default_cpu_present_to_apicid(int mps_cpu) -{ - return __default_cpu_present_to_apicid(mps_cpu); -} - -int default_check_phys_apicid_present(int phys_apicid) -{ - return __default_check_phys_apicid_present(phys_apicid); -} -#endif - struct boot_params boot_params; /* @@ -376,14 +363,6 @@ static void __init reserve_initrd(void) !ramdisk_image || !ramdisk_size) return; /* No initrd provided by bootloader */ - /* - * If SME is active, this memory will be marked encrypted by the - * kernel when it is accessed (including relocation). However, the - * ramdisk image was loaded decrypted by the bootloader, so make - * sure that it is encrypted before accessing it. - */ - sme_early_encrypt(ramdisk_image, ramdisk_end - ramdisk_image); - initrd_start = 0; mapped_size = memblock_mem_size(max_pfn_mapped); @@ -822,26 +801,6 @@ dump_kernel_offset(struct notifier_block *self, unsigned long v, void *p) return 0; } -static void __init simple_udelay_calibration(void) -{ - unsigned int tsc_khz, cpu_khz; - unsigned long lpj; - - if (!boot_cpu_has(X86_FEATURE_TSC)) - return; - - cpu_khz = x86_platform.calibrate_cpu(); - tsc_khz = x86_platform.calibrate_tsc(); - - tsc_khz = tsc_khz ? : cpu_khz; - if (!tsc_khz) - return; - - lpj = tsc_khz * 1000; - do_div(lpj, HZ); - loops_per_jiffy = lpj; -} - /* * Determine if we were loaded by an EFI loader. If so, then we have also been * passed the efi memmap, systab, etc., so we should use these data structures @@ -936,9 +895,6 @@ void __init setup_arch(char **cmdline_p) set_bit(EFI_BOOT, &efi.flags); set_bit(EFI_64BIT, &efi.flags); } - - if (efi_enabled(EFI_BOOT)) - efi_memblock_x86_reserve_range(); #endif x86_init.oem.arch_setup(); @@ -992,6 +948,8 @@ void __init setup_arch(char **cmdline_p) parse_early_param(); + if (efi_enabled(EFI_BOOT)) + efi_memblock_x86_reserve_range(); #ifdef CONFIG_MEMORY_HOTPLUG /* * Memory used by the kernel cannot be hot-removed because Linux @@ -1045,12 +1003,10 @@ void __init setup_arch(char **cmdline_p) /* * VMware detection requires dmi to be available, so this - * needs to be done after dmi_scan_machine, for the BP. + * needs to be done after dmi_scan_machine(), for the boot CPU. */ init_hypervisor_platform(); - simple_udelay_calibration(); - x86_init.resources.probe_roms(); /* after parse_early_param, so could debug it */ @@ -1135,9 +1091,6 @@ void __init setup_arch(char **cmdline_p) memblock_set_current_limit(ISA_END_ADDRESS); e820__memblock_setup(); - if (!early_xdbc_setup_hardware()) - early_xdbc_register_console(); - reserve_bios_regions(); if (efi_enabled(EFI_MEMMAP)) { @@ -1243,24 +1196,21 @@ void __init setup_arch(char **cmdline_p) kvmclock_init(); #endif + tsc_early_delay_calibrate(); + if (!early_xdbc_setup_hardware()) + early_xdbc_register_console(); + x86_init.paging.pagetable_init(); kasan_init(); -#ifdef CONFIG_X86_32 - /* sync back kernel address range */ - clone_pgd_range(initial_page_table + KERNEL_PGD_BOUNDARY, - swapper_pg_dir + KERNEL_PGD_BOUNDARY, - KERNEL_PGD_PTRS); - /* - * sync back low identity map too. It is used for example - * in the 32-bit EFI stub. + * Sync back kernel address range. + * + * FIXME: Can the later sync in setup_cpu_entry_areas() replace + * this call? */ - clone_pgd_range(initial_page_table, - swapper_pg_dir + KERNEL_PGD_BOUNDARY, - min(KERNEL_PGD_PTRS, KERNEL_PGD_BOUNDARY)); -#endif + sync_initial_page_table(); tboot_probe(); @@ -1294,7 +1244,7 @@ void __init setup_arch(char **cmdline_p) io_apic_init_mappings(); - kvm_guest_init(); + x86_init.hyper.guest_late_init(); e820__reserve_resources(); e820__register_nosave_regions(max_low_pfn); |