diff options
Diffstat (limited to 'arch/x86/kvm/vmx/vmenter.S')
| -rw-r--r-- | arch/x86/kvm/vmx/vmenter.S | 222 |
1 files changed, 122 insertions, 100 deletions
diff --git a/arch/x86/kvm/vmx/vmenter.S b/arch/x86/kvm/vmx/vmenter.S index 3a6461694fc2..0b5db4de4d09 100644 --- a/arch/x86/kvm/vmx/vmenter.S +++ b/arch/x86/kvm/vmx/vmenter.S @@ -4,7 +4,10 @@ #include <asm/bitsperlong.h> #include <asm/kvm_vcpu_regs.h> #include <asm/nospec-branch.h> +#include <asm/percpu.h> #include <asm/segment.h> +#include "kvm-asm-offsets.h" +#include "run_flags.h" #define WORD_SIZE (BITS_PER_LONG / 8) @@ -31,72 +34,11 @@ .section .noinstr.text, "ax" /** - * vmx_vmenter - VM-Enter the current loaded VMCS - * - * %RFLAGS.ZF: !VMCS.LAUNCHED, i.e. controls VMLAUNCH vs. VMRESUME - * - * Returns: - * %RFLAGS.CF is set on VM-Fail Invalid - * %RFLAGS.ZF is set on VM-Fail Valid - * %RFLAGS.{CF,ZF} are cleared on VM-Success, i.e. VM-Exit - * - * Note that VMRESUME/VMLAUNCH fall-through and return directly if - * they VM-Fail, whereas a successful VM-Enter + VM-Exit will jump - * to vmx_vmexit. - */ -SYM_FUNC_START_LOCAL(vmx_vmenter) - /* EFLAGS.ZF is set if VMCS.LAUNCHED == 0 */ - je 2f - -1: vmresume - ret - -2: vmlaunch - ret - -3: cmpb $0, kvm_rebooting - je 4f - ret -4: ud2 - - _ASM_EXTABLE(1b, 3b) - _ASM_EXTABLE(2b, 3b) - -SYM_FUNC_END(vmx_vmenter) - -/** - * vmx_vmexit - Handle a VMX VM-Exit - * - * Returns: - * %RFLAGS.{CF,ZF} are cleared on VM-Success, i.e. VM-Exit - * - * This is vmx_vmenter's partner in crime. On a VM-Exit, control will jump - * here after hardware loads the host's state, i.e. this is the destination - * referred to by VMCS.HOST_RIP. - */ -SYM_FUNC_START(vmx_vmexit) -#ifdef CONFIG_RETPOLINE - ALTERNATIVE "jmp .Lvmexit_skip_rsb", "", X86_FEATURE_RETPOLINE - /* Preserve guest's RAX, it's used to stuff the RSB. */ - push %_ASM_AX - - /* IMPORTANT: Stuff the RSB immediately after VM-Exit, before RET! */ - FILL_RETURN_BUFFER %_ASM_AX, RSB_CLEAR_LOOPS, X86_FEATURE_RETPOLINE - - /* Clear RFLAGS.CF and RFLAGS.ZF to preserve VM-Exit, i.e. !VM-Fail. */ - or $1, %_ASM_AX - - pop %_ASM_AX -.Lvmexit_skip_rsb: -#endif - ret -SYM_FUNC_END(vmx_vmexit) - -/** * __vmx_vcpu_run - Run a vCPU via a transition to VMX guest mode - * @vmx: struct vcpu_vmx * (forwarded to vmx_update_host_rsp) + * @vmx: struct vcpu_vmx * * @regs: unsigned long * (to guest registers) - * @launched: %true if the VMCS has been launched + * @flags: VMX_RUN_VMRESUME: use VMRESUME instead of VMLAUNCH + * VMX_RUN_SAVE_SPEC_CTRL: save guest SPEC_CTRL into vmx->spec_ctrl * * Returns: * 0 on VM-Exit, 1 on VM-Fail @@ -115,24 +57,56 @@ SYM_FUNC_START(__vmx_vcpu_run) #endif push %_ASM_BX + /* Save @vmx for SPEC_CTRL handling */ + push %_ASM_ARG1 + + /* Save @flags for SPEC_CTRL handling */ + push %_ASM_ARG3 + /* * Save @regs, _ASM_ARG2 may be modified by vmx_update_host_rsp() and * @regs is needed after VM-Exit to save the guest's register values. */ push %_ASM_ARG2 - /* Copy @launched to BL, _ASM_ARG3 is volatile. */ + /* Copy @flags to BL, _ASM_ARG3 is volatile. */ mov %_ASM_ARG3B, %bl - /* Adjust RSP to account for the CALL to vmx_vmenter(). */ - lea -WORD_SIZE(%_ASM_SP), %_ASM_ARG2 + lea (%_ASM_SP), %_ASM_ARG2 call vmx_update_host_rsp + ALTERNATIVE "jmp .Lspec_ctrl_done", "", X86_FEATURE_MSR_SPEC_CTRL + + /* + * SPEC_CTRL handling: if the guest's SPEC_CTRL value differs from the + * host's, write the MSR. + * + * IMPORTANT: To avoid RSB underflow attacks and any other nastiness, + * there must not be any returns or indirect branches between this code + * and vmentry. + */ + mov 2*WORD_SIZE(%_ASM_SP), %_ASM_DI + movl VMX_spec_ctrl(%_ASM_DI), %edi + movl PER_CPU_VAR(x86_spec_ctrl_current), %esi + cmp %edi, %esi + je .Lspec_ctrl_done + mov $MSR_IA32_SPEC_CTRL, %ecx + xor %edx, %edx + mov %edi, %eax + wrmsr + +.Lspec_ctrl_done: + + /* + * Since vmentry is serializing on affected CPUs, there's no need for + * an LFENCE to stop speculation from skipping the wrmsr. + */ + /* Load @regs to RAX. */ mov (%_ASM_SP), %_ASM_AX /* Check if vmlaunch or vmresume is needed */ - testb %bl, %bl + testb $VMX_RUN_VMRESUME, %bl /* Load guest registers. Don't clobber flags. */ mov VCPU_RCX(%_ASM_AX), %_ASM_CX @@ -154,11 +128,37 @@ SYM_FUNC_START(__vmx_vcpu_run) /* Load guest RAX. This kills the @regs pointer! */ mov VCPU_RAX(%_ASM_AX), %_ASM_AX - /* Enter guest mode */ - call vmx_vmenter + /* Check EFLAGS.ZF from 'testb' above */ + jz .Lvmlaunch + + /* + * After a successful VMRESUME/VMLAUNCH, control flow "magically" + * resumes below at 'vmx_vmexit' due to the VMCS HOST_RIP setting. + * So this isn't a typical function and objtool needs to be told to + * save the unwind state here and restore it below. + */ + UNWIND_HINT_SAVE + +/* + * If VMRESUME/VMLAUNCH and corresponding vmexit succeed, execution resumes at + * the 'vmx_vmexit' label below. + */ +.Lvmresume: + vmresume + jmp .Lvmfail + +.Lvmlaunch: + vmlaunch + jmp .Lvmfail + + _ASM_EXTABLE(.Lvmresume, .Lfixup) + _ASM_EXTABLE(.Lvmlaunch, .Lfixup) - /* Jump on VM-Fail. */ - jbe 2f +SYM_INNER_LABEL(vmx_vmexit, SYM_L_GLOBAL) + + /* Restore unwind state from before the VMRESUME/VMLAUNCH. */ + UNWIND_HINT_RESTORE + ENDBR /* Temporarily save guest's RAX. */ push %_ASM_AX @@ -185,21 +185,26 @@ SYM_FUNC_START(__vmx_vcpu_run) mov %r15, VCPU_R15(%_ASM_AX) #endif - /* Clear RAX to indicate VM-Exit (as opposed to VM-Fail). */ - xor %eax, %eax + /* Clear return value to indicate VM-Exit (as opposed to VM-Fail). */ + xor %ebx, %ebx + +.Lclear_regs: + /* Discard @regs. The register is irrelevant, it just can't be RBX. */ + pop %_ASM_AX /* - * Clear all general purpose registers except RSP and RAX to prevent + * Clear all general purpose registers except RSP and RBX to prevent * speculative use of the guest's values, even those that are reloaded * via the stack. In theory, an L1 cache miss when restoring registers * could lead to speculative execution with the guest's values. * Zeroing XORs are dirt cheap, i.e. the extra paranoia is essentially - * free. RSP and RAX are exempt as RSP is restored by hardware during - * VM-Exit and RAX is explicitly loaded with 0 or 1 to return VM-Fail. + * free. RSP and RBX are exempt as RSP is restored by hardware during + * VM-Exit and RBX is explicitly loaded with 0 or 1 to hold the return + * value. */ -1: xor %ecx, %ecx + xor %eax, %eax + xor %ecx, %ecx xor %edx, %edx - xor %ebx, %ebx xor %ebp, %ebp xor %esi, %esi xor %edi, %edi @@ -214,10 +219,30 @@ SYM_FUNC_START(__vmx_vcpu_run) xor %r15d, %r15d #endif - /* "POP" @regs. */ - add $WORD_SIZE, %_ASM_SP - pop %_ASM_BX + /* + * IMPORTANT: RSB filling and SPEC_CTRL handling must be done before + * the first unbalanced RET after vmexit! + * + * For retpoline or IBRS, RSB filling is needed to prevent poisoned RSB + * entries and (in some cases) RSB underflow. + * + * eIBRS has its own protection against poisoned RSB, so it doesn't + * need the RSB filling sequence. But it does need to be enabled, and a + * single call to retire, before the first unbalanced RET. + */ + + FILL_RETURN_BUFFER %_ASM_CX, RSB_CLEAR_LOOPS, X86_FEATURE_RSB_VMEXIT,\ + X86_FEATURE_RSB_VMEXIT_LITE + pop %_ASM_ARG2 /* @flags */ + pop %_ASM_ARG1 /* @vmx */ + + call vmx_spec_ctrl_restore_host + + /* Put return value in AX */ + mov %_ASM_BX, %_ASM_AX + + pop %_ASM_BX #ifdef CONFIG_X86_64 pop %r12 pop %r13 @@ -228,11 +253,17 @@ SYM_FUNC_START(__vmx_vcpu_run) pop %edi #endif pop %_ASM_BP - ret + RET + +.Lfixup: + cmpb $0, kvm_rebooting + jne .Lvmfail + ud2 +.Lvmfail: + /* VM-Fail: set return value to 1 */ + mov $1, %_ASM_BX + jmp .Lclear_regs - /* VM-Fail. Out-of-line to avoid a taken Jcc after VM-Exit. */ -2: mov $1, %eax - jmp 1b SYM_FUNC_END(__vmx_vcpu_run) @@ -261,22 +292,13 @@ SYM_FUNC_START(vmread_error_trampoline) push %r10 push %r11 #endif -#ifdef CONFIG_X86_64 + /* Load @field and @fault to arg1 and arg2 respectively. */ - mov 3*WORD_SIZE(%rbp), %_ASM_ARG2 - mov 2*WORD_SIZE(%rbp), %_ASM_ARG1 -#else - /* Parameters are passed on the stack for 32-bit (see asmlinkage). */ - push 3*WORD_SIZE(%ebp) - push 2*WORD_SIZE(%ebp) -#endif + mov 3*WORD_SIZE(%_ASM_BP), %_ASM_ARG2 + mov 2*WORD_SIZE(%_ASM_BP), %_ASM_ARG1 call vmread_error -#ifndef CONFIG_X86_64 - add $8, %esp -#endif - /* Zero out @fault, which will be popped into the result register. */ _ASM_MOV $0, 3*WORD_SIZE(%_ASM_BP) @@ -293,7 +315,7 @@ SYM_FUNC_START(vmread_error_trampoline) pop %_ASM_AX pop %_ASM_BP - ret + RET SYM_FUNC_END(vmread_error_trampoline) SYM_FUNC_START(vmx_do_interrupt_nmi_irqoff) @@ -326,5 +348,5 @@ SYM_FUNC_START(vmx_do_interrupt_nmi_irqoff) */ mov %_ASM_BP, %_ASM_SP pop %_ASM_BP - ret + RET SYM_FUNC_END(vmx_do_interrupt_nmi_irqoff) |