1 files changed, 296 insertions, 0 deletions
diff --git a/drivers/clocksource/timer-atmel-pit.c b/drivers/clocksource/timer-atmel-pit.c
new file mode 100644
index 000000000000..d5289098b3df
--- /dev/null
+++ b/drivers/clocksource/timer-atmel-pit.c
@@ -0,0 +1,296 @@
+/*
+ * at91sam926x_time.c - Periodic Interval Timer (PIT) for at91sam926x
+ *
+ * Copyright (C) 2005-2006 M. Amine SAYA, ATMEL Rousset, France
+ * Revision	 2005 M. Nicolas Diremdjian, ATMEL Rousset, France
+ * Converted to ClockSource/ClockEvents by David Brownell.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+#define pr_fmt(fmt)	"AT91: PIT: " fmt
+
+#include <linux/clk.h>
+#include <linux/clockchips.h>
+#include <linux/interrupt.h>
+#include <linux/irq.h>
+#include <linux/kernel.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/of_irq.h>
+#include <linux/slab.h>
+
+#define AT91_PIT_MR		0x00			/* Mode Register */
+#define AT91_PIT_PITIEN			BIT(25)			/* Timer Interrupt Enable */
+#define AT91_PIT_PITEN			BIT(24)			/* Timer Enabled */
+#define AT91_PIT_PIV			GENMASK(19, 0)		/* Periodic Interval Value */
+
+#define AT91_PIT_SR		0x04			/* Status Register */
+#define AT91_PIT_PITS			BIT(0)			/* Timer Status */
+
+#define AT91_PIT_PIVR		0x08			/* Periodic Interval Value Register */
+#define AT91_PIT_PIIR		0x0c			/* Periodic Interval Image Register */
+#define AT91_PIT_PICNT			GENMASK(31, 20)		/* Interval Counter */
+#define AT91_PIT_CPIV			GENMASK(19, 0)		/* Inverval Value */
+
+#define PIT_CPIV(x)	((x) & AT91_PIT_CPIV)
+#define PIT_PICNT(x)	(((x) & AT91_PIT_PICNT) >> 20)
+
+struct pit_data {
+	struct clock_event_device	clkevt;
+	struct clocksource		clksrc;
+
+	void __iomem	*base;
+	u32		cycle;
+	u32		cnt;
+	unsigned int	irq;
+	struct clk	*mck;
+};
+
+static inline struct pit_data *clksrc_to_pit_data(struct clocksource *clksrc)
+{
+	return container_of(clksrc, struct pit_data, clksrc);
+}
+
+static inline struct pit_data *clkevt_to_pit_data(struct clock_event_device *clkevt)
+{
+	return container_of(clkevt, struct pit_data, clkevt);
+}
+
+static inline unsigned int pit_read(void __iomem *base, unsigned int reg_offset)
+{
+	return __raw_readl(base + reg_offset);
+}
+
+static inline void pit_write(void __iomem *base, unsigned int reg_offset, unsigned long value)
+{
+	__raw_writel(value, base + reg_offset);
+}
+
+/*
+ * Clocksource:  just a monotonic counter of MCK/16 cycles.
+ * We don't care whether or not PIT irqs are enabled.
+ */
+static cycle_t read_pit_clk(struct clocksource *cs)
+{
+	struct pit_data *data = clksrc_to_pit_data(cs);
+	unsigned long flags;
+	u32 elapsed;
+	u32 t;
+
+	raw_local_irq_save(flags);
+	elapsed = data->cnt;
+	t = pit_read(data->base, AT91_PIT_PIIR);
+	raw_local_irq_restore(flags);
+
+	elapsed += PIT_PICNT(t) * data->cycle;
+	elapsed += PIT_CPIV(t);
+	return elapsed;
+}
+
+/*
+ * Clockevent device:  interrupts every 1/HZ (== pit_cycles * MCK/16)
+ */
+static void
+pit_clkevt_mode(enum clock_event_mode mode, struct clock_event_device *dev)
+{
+	struct pit_data *data = clkevt_to_pit_data(dev);
+
+	switch (mode) {
+	case CLOCK_EVT_MODE_PERIODIC:
+		/* update clocksource counter */
+		data->cnt += data->cycle * PIT_PICNT(pit_read(data->base, AT91_PIT_PIVR));
+		pit_write(data->base, AT91_PIT_MR,
+			  (data->cycle - 1) | AT91_PIT_PITEN | AT91_PIT_PITIEN);
+		break;
+	case CLOCK_EVT_MODE_ONESHOT:
+		BUG();
+		/* FALLTHROUGH */
+	case CLOCK_EVT_MODE_SHUTDOWN:
+	case CLOCK_EVT_MODE_UNUSED:
+		/* disable irq, leaving the clocksource active */
+		pit_write(data->base, AT91_PIT_MR,
+			  (data->cycle - 1) | AT91_PIT_PITEN);
+		break;
+	case CLOCK_EVT_MODE_RESUME:
+		break;
+	}
+}
+
+static void at91sam926x_pit_suspend(struct clock_event_device *cedev)
+{
+	struct pit_data *data = clkevt_to_pit_data(cedev);
+
+	/* Disable timer */
+	pit_write(data->base, AT91_PIT_MR, 0);
+}
+
+static void at91sam926x_pit_reset(struct pit_data *data)
+{
+	/* Disable timer and irqs */
+	pit_write(data->base, AT91_PIT_MR, 0);
+
+	/* Clear any pending interrupts, wait for PIT to stop counting */
+	while (PIT_CPIV(pit_read(data->base, AT91_PIT_PIVR)) != 0)
+		cpu_relax();
+
+	/* Start PIT but don't enable IRQ */
+	pit_write(data->base, AT91_PIT_MR,
+		  (data->cycle - 1) | AT91_PIT_PITEN);
+}
+
+static void at91sam926x_pit_resume(struct clock_event_device *cedev)
+{
+	struct pit_data *data = clkevt_to_pit_data(cedev);
+
+	at91sam926x_pit_reset(data);
+}
+
+/*
+ * IRQ handler for the timer.
+ */
+static irqreturn_t at91sam926x_pit_interrupt(int irq, void *dev_id)
+{
+	struct pit_data *data = dev_id;
+
+	/*
+	 * irqs should be disabled here, but as the irq is shared they are only
+	 * guaranteed to be off if the timer irq is registered first.
+	 */
+	WARN_ON_ONCE(!irqs_disabled());
+
+	/* The PIT interrupt may be disabled, and is shared */
+	if ((data->clkevt.mode == CLOCK_EVT_MODE_PERIODIC) &&
+	    (pit_read(data->base, AT91_PIT_SR) & AT91_PIT_PITS)) {
+		unsigned nr_ticks;
+
+		/* Get number of ticks performed before irq, and ack it */
+		nr_ticks = PIT_PICNT(pit_read(data->base, AT91_PIT_PIVR));
+		do {
+			data->cnt += data->cycle;
+			data->clkevt.event_handler(&data->clkevt);
+			nr_ticks--;
+		} while (nr_ticks);
+
+		return IRQ_HANDLED;
+	}
+
+	return IRQ_NONE;
+}
+
+/*
+ * Set up both clocksource and clockevent support.
+ */
+static void __init at91sam926x_pit_common_init(struct pit_data *data)
+{
+	unsigned long	pit_rate;
+	unsigned	bits;
+	int		ret;
+
+	/*
+	 * Use our actual MCK to figure out how many MCK/16 ticks per
+	 * 1/HZ period (instead of a compile-time constant LATCH).
+	 */
+	pit_rate = clk_get_rate(data->mck) / 16;
+	data->cycle = DIV_ROUND_CLOSEST(pit_rate, HZ);
+	WARN_ON(((data->cycle - 1) & ~AT91_PIT_PIV) != 0);
+
+	/* Initialize and enable the timer */
+	at91sam926x_pit_reset(data);
+
+	/*
+	 * Register clocksource.  The high order bits of PIV are unused,
+	 * so this isn't a 32-bit counter unless we get clockevent irqs.
+	 */
+	bits = 12 /* PICNT */ + ilog2(data->cycle) /* PIV */;
+	data->clksrc.mask = CLOCKSOURCE_MASK(bits);
+	data->clksrc.name = "pit";
+	data->clksrc.rating = 175;
+	data->clksrc.read = read_pit_clk,
+	data->clksrc.flags = CLOCK_SOURCE_IS_CONTINUOUS,
+	clocksource_register_hz(&data->clksrc, pit_rate);
+
+	/* Set up irq handler */
+	ret = request_irq(data->irq, at91sam926x_pit_interrupt,
+			  IRQF_SHARED | IRQF_TIMER | IRQF_IRQPOLL,
+			  "at91_tick", data);
+	if (ret)
+		panic(pr_fmt("Unable to setup IRQ\n"));
+
+	/* Set up and register clockevents */
+	data->clkevt.name = "pit";
+	data->clkevt.features = CLOCK_EVT_FEAT_PERIODIC;
+	data->clkevt.shift = 32;
+	data->clkevt.mult = div_sc(pit_rate, NSEC_PER_SEC, data->clkevt.shift);
+	data->clkevt.rating = 100;
+	data->clkevt.cpumask = cpumask_of(0);
+
+	data->clkevt.set_mode = pit_clkevt_mode;
+	data->clkevt.resume = at91sam926x_pit_resume;
+	data->clkevt.suspend = at91sam926x_pit_suspend;
+	clockevents_register_device(&data->clkevt);
+}
+
+static void __init at91sam926x_pit_dt_init(struct device_node *node)
+{
+	struct pit_data *data;
+
+	data = kzalloc(sizeof(*data), GFP_KERNEL);
+	if (!data)
+		panic(pr_fmt("Unable to allocate memory\n"));
+
+	data->base = of_iomap(node, 0);
+	if (!data->base)
+		panic(pr_fmt("Could not map PIT address\n"));
+
+	data->mck = of_clk_get(node, 0);
+	if (IS_ERR(data->mck))
+		/* Fallback on clkdev for !CCF-based boards */
+		data->mck = clk_get(NULL, "mck");
+
+	if (IS_ERR(data->mck))
+		panic(pr_fmt("Unable to get mck clk\n"));
+
+	/* Get the interrupts property */
+	data->irq = irq_of_parse_and_map(node, 0);
+	if (!data->irq)
+		panic(pr_fmt("Unable to get IRQ from DT\n"));
+
+	at91sam926x_pit_common_init(data);
+}
+CLOCKSOURCE_OF_DECLARE(at91sam926x_pit, "atmel,at91sam9260-pit",
+		       at91sam926x_pit_dt_init);
+
+static void __iomem *pit_base_addr;
+
+void __init at91sam926x_pit_init(int irq)
+{
+	struct pit_data *data;
+
+	data = kzalloc(sizeof(*data), GFP_KERNEL);
+	if (!data)
+		panic(pr_fmt("Unable to allocate memory\n"));
+
+	data->base = pit_base_addr;
+
+	data->mck = clk_get(NULL, "mck");
+	if (IS_ERR(data->mck))
+		panic(pr_fmt("Unable to get mck clk\n"));
+
+	data->irq = irq;
+
+	at91sam926x_pit_common_init(data);
+}
+
+void __init at91sam926x_ioremap_pit(u32 addr)
+{
+	if (of_have_populated_dt())
+		return;
+
+	pit_base_addr = ioremap(addr, 16);
+
+	if (!pit_base_addr)
+		panic(pr_fmt("Impossible to ioremap PIT\n"));
+}