diff options
Diffstat (limited to 'drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c')
| -rw-r--r-- | drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c | 118 |
1 files changed, 64 insertions, 54 deletions
diff --git a/drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c b/drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c index 1db1ca19411d..8c5045711264 100644 --- a/drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c +++ b/drivers/gpu/drm/amd/display/dc/dcn30/dcn30_hwseq.c @@ -48,6 +48,8 @@ #include "dc_dmub_srv.h" #include "link_hwss.h" #include "dpcd_defs.h" +#include "../dcn20/dcn20_hwseq.h" +#include "dcn30_resource.h" #include "inc/dc_link_dp.h" #include "inc/link_dpcd.h" @@ -344,17 +346,6 @@ void dcn30_enable_writeback( dwb->funcs->enable(dwb, &wb_info->dwb_params); } -void dcn30_prepare_bandwidth(struct dc *dc, - struct dc_state *context) -{ - if (dc->clk_mgr->dc_mode_softmax_enabled) - if (dc->clk_mgr->clks.dramclk_khz <= dc->clk_mgr->bw_params->dc_mode_softmax_memclk * 1000 && - context->bw_ctx.bw.dcn.clk.dramclk_khz > dc->clk_mgr->bw_params->dc_mode_softmax_memclk * 1000) - dc->clk_mgr->funcs->set_max_memclk(dc->clk_mgr, dc->clk_mgr->bw_params->clk_table.entries[dc->clk_mgr->bw_params->clk_table.num_entries - 1].memclk_mhz); - - dcn20_prepare_bandwidth(dc, context); -} - void dcn30_disable_writeback( struct dc *dc, unsigned int dwb_pipe_inst) @@ -535,8 +526,12 @@ void dcn30_init_hw(struct dc *dc) /* Check for enabled DIG to identify enabled display */ if (link->link_enc->funcs->is_dig_enabled && - link->link_enc->funcs->is_dig_enabled(link->link_enc)) + link->link_enc->funcs->is_dig_enabled(link->link_enc)) { link->link_status.link_active = true; + if (link->link_enc->funcs->fec_is_active && + link->link_enc->funcs->fec_is_active(link->link_enc)) + link->fec_state = dc_link_fec_enabled; + } } /* Power gate DSCs */ @@ -545,8 +540,10 @@ void dcn30_init_hw(struct dc *dc) hws->funcs.dsc_pg_control(hws, res_pool->dscs[i]->inst, false); /* we want to turn off all dp displays before doing detection */ - if (dc->config.power_down_display_on_boot) - dc_link_blank_all_dp_displays(dc); + dc_link_blank_all_dp_displays(dc); + + if (hws->funcs.enable_power_gating_plane) + hws->funcs.enable_power_gating_plane(dc->hwseq, true); /* If taking control over from VBIOS, we may want to optimize our first * mode set, so we need to skip powering down pipes until we know which @@ -554,7 +551,7 @@ void dcn30_init_hw(struct dc *dc) * Otherwise, if taking control is not possible, we need to power * everything down. */ - if (dcb->funcs->is_accelerated_mode(dcb) || dc->config.power_down_display_on_boot) { + if (dcb->funcs->is_accelerated_mode(dcb) || !dc->config.seamless_boot_edp_requested) { hws->funcs.init_pipes(dc, dc->current_state); if (dc->res_pool->hubbub->funcs->allow_self_refresh_control) dc->res_pool->hubbub->funcs->allow_self_refresh_control(dc->res_pool->hubbub, @@ -566,7 +563,7 @@ void dcn30_init_hw(struct dc *dc) * To avoid this, power down hardware on boot * if DIG is turned on and seamless boot not enabled */ - if (dc->config.power_down_display_on_boot) { + if (!dc->config.seamless_boot_edp_requested) { struct dc_link *edp_links[MAX_NUM_EDP]; struct dc_link *edp_link = NULL; @@ -625,8 +622,6 @@ void dcn30_init_hw(struct dc *dc) REG_UPDATE(DCFCLK_CNTL, DCFCLK_GATE_DIS, 0); } - if (hws->funcs.enable_power_gating_plane) - hws->funcs.enable_power_gating_plane(dc->hwseq, true); if (!dcb->funcs->is_accelerated_mode(dcb) && dc->res_pool->hubbub->funcs->init_watermarks) dc->res_pool->hubbub->funcs->init_watermarks(dc->res_pool->hubbub); @@ -643,6 +638,10 @@ void dcn30_init_hw(struct dc *dc) if (dc->res_pool->hubbub->funcs->init_crb) dc->res_pool->hubbub->funcs->init_crb(dc->res_pool->hubbub); + // Get DMCUB capabilities + dc_dmub_srv_query_caps_cmd(dc->ctx->dmub_srv->dmub); + dc->caps.dmub_caps.psr = dc->ctx->dmub_srv->dmub->feature_caps.psr; + dc->caps.dmub_caps.mclk_sw = dc->ctx->dmub_srv->dmub->feature_caps.fw_assisted_mclk_switch; } void dcn30_set_avmute(struct pipe_ctx *pipe_ctx, bool enable) @@ -940,11 +939,36 @@ bool dcn30_does_plane_fit_in_mall(struct dc *dc, struct dc_plane_state *plane, s void dcn30_hardware_release(struct dc *dc) { - /* if pstate unsupported, force it supported */ - if (!dc->clk_mgr->clks.p_state_change_support && - dc->res_pool->hubbub->funcs->force_pstate_change_control) - dc->res_pool->hubbub->funcs->force_pstate_change_control( - dc->res_pool->hubbub, true, true); + bool subvp_in_use = false; + uint32_t i; + + dc_dmub_srv_p_state_delegate(dc, false, NULL); + dc_dmub_setup_subvp_dmub_command(dc, dc->current_state, false); + + /* SubVP treated the same way as FPO. If driver disable and + * we are using a SubVP config, disable and force on DCN side + * to prevent P-State hang on driver enable. + */ + for (i = 0; i < dc->res_pool->pipe_count; i++) { + struct pipe_ctx *pipe = &dc->current_state->res_ctx.pipe_ctx[i]; + + if (!pipe->stream) + continue; + + if (pipe->stream->mall_stream_config.type == SUBVP_MAIN) { + subvp_in_use = true; + break; + } + } + /* If pstate unsupported, or still supported + * by firmware, force it supported by dcn + */ + if (dc->current_state) + if ((!dc->clk_mgr->clks.p_state_change_support || subvp_in_use || + dc->current_state->bw_ctx.bw.dcn.clk.fw_based_mclk_switching) && + dc->res_pool->hubbub->funcs->force_pstate_change_control) + dc->res_pool->hubbub->funcs->force_pstate_change_control( + dc->res_pool->hubbub, true, true); } void dcn30_set_disp_pattern_generator(const struct dc *dc, @@ -955,35 +979,21 @@ void dcn30_set_disp_pattern_generator(const struct dc *dc, const struct tg_color *solid_color, int width, int height, int offset) { - struct stream_resource *stream_res = &pipe_ctx->stream_res; - struct pipe_ctx *mpcc_pipe; - - if (test_pattern != CONTROLLER_DP_TEST_PATTERN_VIDEOMODE) { - pipe_ctx->vtp_locked = false; - /* turning on DPG */ - stream_res->opp->funcs->opp_set_disp_pattern_generator(stream_res->opp, test_pattern, color_space, - color_depth, solid_color, width, height, offset); - - /* Defer hubp blank if tg is locked */ - if (stream_res->tg->funcs->is_tg_enabled(stream_res->tg)) { - if (stream_res->tg->funcs->is_locked(stream_res->tg)) - pipe_ctx->vtp_locked = true; - else { - /* Blank HUBP to allow p-state during blank on all timings */ - pipe_ctx->plane_res.hubp->funcs->set_blank(pipe_ctx->plane_res.hubp, true); - - for (mpcc_pipe = pipe_ctx->bottom_pipe; mpcc_pipe; mpcc_pipe = mpcc_pipe->bottom_pipe) - mpcc_pipe->plane_res.hubp->funcs->set_blank(mpcc_pipe->plane_res.hubp, true); - } - } - } else { - /* turning off DPG */ - pipe_ctx->plane_res.hubp->funcs->set_blank(pipe_ctx->plane_res.hubp, false); - for (mpcc_pipe = pipe_ctx->bottom_pipe; mpcc_pipe; mpcc_pipe = mpcc_pipe->bottom_pipe) - if (mpcc_pipe->plane_res.hubp) - mpcc_pipe->plane_res.hubp->funcs->set_blank(mpcc_pipe->plane_res.hubp, false); - - stream_res->opp->funcs->opp_set_disp_pattern_generator(stream_res->opp, test_pattern, color_space, - color_depth, solid_color, width, height, offset); - } + pipe_ctx->stream_res.opp->funcs->opp_set_disp_pattern_generator(pipe_ctx->stream_res.opp, test_pattern, + color_space, color_depth, solid_color, width, height, offset); } + +void dcn30_prepare_bandwidth(struct dc *dc, + struct dc_state *context) +{ + if (dc->clk_mgr->dc_mode_softmax_enabled) + if (dc->clk_mgr->clks.dramclk_khz <= dc->clk_mgr->bw_params->dc_mode_softmax_memclk * 1000 && + context->bw_ctx.bw.dcn.clk.dramclk_khz > dc->clk_mgr->bw_params->dc_mode_softmax_memclk * 1000) + dc->clk_mgr->funcs->set_max_memclk(dc->clk_mgr, dc->clk_mgr->bw_params->clk_table.entries[dc->clk_mgr->bw_params->clk_table.num_entries - 1].memclk_mhz); + + dcn20_prepare_bandwidth(dc, context); + + dc_dmub_srv_p_state_delegate(dc, + context->bw_ctx.bw.dcn.clk.fw_based_mclk_switching, context); +} + |