diff options
Diffstat (limited to 'drivers/mtd/nand/Kconfig')
| -rw-r--r-- | drivers/mtd/nand/Kconfig | 49 |
1 files changed, 26 insertions, 23 deletions
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig index 4883139460be..5819eb575210 100644 --- a/drivers/mtd/nand/Kconfig +++ b/drivers/mtd/nand/Kconfig @@ -49,24 +49,31 @@ config MTD_NAND_MUSEUM_IDS NAND chips (page size 256 byte, erase size 4-8KiB). The IDs of these chips were reused by later, larger chips. -config MTD_NAND_AUTCPU12 - tristate "SmartMediaCard on autronix autcpu12 board" - depends on ARCH_AUTCPU12 - help - This enables the driver for the autronix autcpu12 board to - access the SmartMediaCard. - config MTD_NAND_DENALI - depends on PCI + tristate "Support Denali NAND controller" + help + Enable support for the Denali NAND controller. This should be + combined with either the PCI or platform drivers to provide device + registration. + +config MTD_NAND_DENALI_PCI tristate "Support Denali NAND controller on Intel Moorestown" + depends on PCI && MTD_NAND_DENALI help Enable the driver for NAND flash on Intel Moorestown, using the Denali NAND controller core. - + +config MTD_NAND_DENALI_DT + tristate "Support Denali NAND controller as a DT device" + depends on HAVE_CLK && MTD_NAND_DENALI + help + Enable the driver for NAND flash on platforms using a Denali NAND + controller as a DT device. + config MTD_NAND_DENALI_SCRATCH_REG_ADDR hex "Denali NAND size scratch register address" default "0xFF108018" - depends on MTD_NAND_DENALI + depends on MTD_NAND_DENALI_PCI help Some platforms place the NAND chip size in a scratch register because (some versions of) the driver aren't able to automatically @@ -86,12 +93,6 @@ config MTD_NAND_GPIO help This enables a GPIO based NAND flash driver. -config MTD_NAND_SPIA - tristate "NAND Flash device on SPIA board" - depends on ARCH_P720T - help - If you had to ask, you don't have one. Say 'N'. - config MTD_NAND_AMS_DELTA tristate "NAND Flash device on Amstrad E3" depends on MACH_AMS_DELTA @@ -446,6 +447,14 @@ config MTD_NAND_GPMI_NAND block, such as SD card. So pay attention to it when you enable the GPMI. +config MTD_NAND_BCM47XXNFLASH + tristate "Support for NAND flash on BCM4706 BCMA bus" + depends on BCMA_NFLASH + help + BCMA bus can have various flash memories attached, they are + registered by bcma as platform devices. This enables driver for + NAND flash memories. For now only BCM4706 is supported. + config MTD_NAND_PLATFORM tristate "Support for generic platform NAND driver" depends on HAS_IOMEM @@ -512,12 +521,6 @@ config MTD_NAND_MXC This enables the driver for the NAND flash controller on the MXC processors. -config MTD_NAND_NOMADIK - tristate "ST Nomadik 8815 NAND support" - depends on ARCH_NOMADIK - help - Driver for the NAND flash controller on the Nomadik, with ECC. - config MTD_NAND_SH_FLCTL tristate "Support for NAND on Renesas SuperH FLCTL" depends on SUPERH || ARCH_SHMOBILE @@ -559,7 +562,7 @@ config MTD_NAND_JZ4740 config MTD_NAND_FSMC tristate "Support for NAND on ST Micros FSMC" - depends on PLAT_SPEAR || PLAT_NOMADIK || MACH_U300 + depends on PLAT_SPEAR || ARCH_NOMADIK || ARCH_U8500 || MACH_U300 help Enables support for NAND Flash chips on the ST Microelectronics Flexible Static Memory Controller (FSMC) |