diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-5000.c')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-5000.c | 72 |
1 files changed, 64 insertions, 8 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-5000.c b/drivers/net/wireless/iwlwifi/iwl-5000.c index 878d6193b232..cbc01a00eaf4 100644 --- a/drivers/net/wireless/iwlwifi/iwl-5000.c +++ b/drivers/net/wireless/iwlwifi/iwl-5000.c @@ -25,7 +25,6 @@ #include <linux/kernel.h> #include <linux/module.h> -#include <linux/version.h> #include <linux/init.h> #include <linux/pci.h> #include <linux/dma-mapping.h> @@ -93,6 +92,13 @@ static int iwl5000_apm_init(struct iwl_priv *priv) iwl_set_bit(priv, CSR_GIO_CHICKEN_BITS, CSR_GIO_CHICKEN_BITS_REG_BIT_L1A_NO_L0S_RX); + /* Set FH wait treshold to maximum (HW error during stress W/A) */ + iwl_set_bit(priv, CSR_DBG_HPET_MEM_REG, CSR_DBG_HPET_MEM_REG_VAL); + + /* enable HAP INTA to move device L1a -> L0s */ + iwl_set_bit(priv, CSR_HW_IF_CONFIG_REG, + CSR_HW_IF_CONFIG_REG_BIT_HAP_WAKE_L1A); + iwl_set_bit(priv, CSR_ANA_PLL_CFG, CSR50_ANA_PLL_CFG_VAL); /* set "initialization complete" bit to move adapter @@ -230,6 +236,16 @@ static void iwl5000_nic_config(struct iwl_priv *priv) CSR_HW_IF_CONFIG_REG_BIT_RADIO_SI | CSR_HW_IF_CONFIG_REG_BIT_MAC_SI); + /* W/A : NIC is stuck in a reset state after Early PCIe power off + * (PCIe power is lost before PERST# is asserted), + * causing ME FW to lose ownership and not being able to obtain it back. + */ + iwl_grab_nic_access(priv); + iwl_set_bits_mask_prph(priv, APMG_PS_CTRL_REG, + APMG_PS_CTRL_EARLY_PWR_OFF_RESET_DIS, + ~APMG_PS_CTRL_EARLY_PWR_OFF_RESET_DIS); + iwl_release_nic_access(priv); + spin_unlock_irqrestore(&priv->lock, flags); } @@ -924,8 +940,8 @@ static void iwl5000_txq_update_byte_cnt_tbl(struct iwl_priv *priv, len = byte_cnt + IWL_TX_CRC_SIZE + IWL_TX_DELIMITER_SIZE; if (txq_id != IWL_CMD_QUEUE_NUM) { - sta = txq->cmd[txq->q.write_ptr].cmd.tx.sta_id; - sec_ctl = txq->cmd[txq->q.write_ptr].cmd.tx.sec_ctl; + sta = txq->cmd[txq->q.write_ptr]->cmd.tx.sta_id; + sec_ctl = txq->cmd[txq->q.write_ptr]->cmd.tx.sec_ctl; switch (sec_ctl & TX_CMD_SEC_MSK) { case TX_CMD_SEC_CCM: @@ -964,7 +980,7 @@ static void iwl5000_txq_inval_byte_cnt_tbl(struct iwl_priv *priv, u8 sta = 0; if (txq_id != IWL_CMD_QUEUE_NUM) - sta = txq->cmd[txq->q.read_ptr].cmd.tx.sta_id; + sta = txq->cmd[txq->q.read_ptr]->cmd.tx.sta_id; shared_data->queues_byte_cnt_tbls[txq_id].tfd_offset[txq->q.read_ptr]. val = cpu_to_le16(1 | (sta << 12)); @@ -1131,7 +1147,7 @@ static void iwl5000_txq_set_sched(struct iwl_priv *priv, u32 mask) static inline u32 iwl5000_get_scd_ssn(struct iwl5000_tx_resp *tx_resp) { - return le32_to_cpup((__le32*)&tx_resp->status + + return le32_to_cpup((__le32 *)&tx_resp->status + tx_resp->frame_count) & MAX_SN; } @@ -1228,9 +1244,9 @@ static int iwl5000_tx_status_reply_tx(struct iwl_priv *priv, bitmap = bitmap << sh; sh = 0; } - bitmap |= (1 << sh); - IWL_DEBUG_TX_REPLY("start=%d bitmap=0x%x\n", - start, (u32)(bitmap & 0xFFFFFFFF)); + bitmap |= 1ULL << sh; + IWL_DEBUG_TX_REPLY("start=%d bitmap=0x%llx\n", + start, (unsigned long long)bitmap); } agg->bitmap = bitmap; @@ -1444,6 +1460,44 @@ static void iwl5000_temperature(struct iwl_priv *priv) priv->temperature = le32_to_cpu(priv->statistics.general.temperature); } +/* Calc max signal level (dBm) among 3 possible receivers */ +static int iwl5000_calc_rssi(struct iwl_priv *priv, + struct iwl_rx_phy_res *rx_resp) +{ + /* data from PHY/DSP regarding signal strength, etc., + * contents are always there, not configurable by host + */ + struct iwl5000_non_cfg_phy *ncphy = + (struct iwl5000_non_cfg_phy *)rx_resp->non_cfg_phy_buf; + u32 val, rssi_a, rssi_b, rssi_c, max_rssi; + u8 agc; + + val = le32_to_cpu(ncphy->non_cfg_phy[IWL50_RX_RES_AGC_IDX]); + agc = (val & IWL50_OFDM_AGC_MSK) >> IWL50_OFDM_AGC_BIT_POS; + + /* Find max rssi among 3 possible receivers. + * These values are measured by the digital signal processor (DSP). + * They should stay fairly constant even as the signal strength varies, + * if the radio's automatic gain control (AGC) is working right. + * AGC value (see below) will provide the "interesting" info. + */ + val = le32_to_cpu(ncphy->non_cfg_phy[IWL50_RX_RES_RSSI_AB_IDX]); + rssi_a = (val & IWL50_OFDM_RSSI_A_MSK) >> IWL50_OFDM_RSSI_A_BIT_POS; + rssi_b = (val & IWL50_OFDM_RSSI_B_MSK) >> IWL50_OFDM_RSSI_B_BIT_POS; + val = le32_to_cpu(ncphy->non_cfg_phy[IWL50_RX_RES_RSSI_C_IDX]); + rssi_c = (val & IWL50_OFDM_RSSI_C_MSK) >> IWL50_OFDM_RSSI_C_BIT_POS; + + max_rssi = max_t(u32, rssi_a, rssi_b); + max_rssi = max_t(u32, max_rssi, rssi_c); + + IWL_DEBUG_STATS("Rssi In A %d B %d C %d Max %d AGC dB %d\n", + rssi_a, rssi_b, rssi_c, max_rssi, agc); + + /* dBm = max_rssi dB - agc dB - constant. + * Higher AGC (higher radio gain) means lower signal. */ + return max_rssi - agc - IWL_RSSI_OFFSET; +} + static struct iwl_hcmd_ops iwl5000_hcmd = { .rxon_assoc = iwl5000_send_rxon_assoc, }; @@ -1454,6 +1508,7 @@ static struct iwl_hcmd_utils_ops iwl5000_hcmd_utils = { .gain_computation = iwl5000_gain_computation, .chain_noise_reset = iwl5000_chain_noise_reset, .rts_tx_cmd_flag = iwl5000_rts_tx_cmd_flag, + .calc_rssi = iwl5000_calc_rssi, }; static struct iwl_lib_ops iwl5000_lib = { @@ -1474,6 +1529,7 @@ static struct iwl_lib_ops iwl5000_lib = { .alive_notify = iwl5000_alive_notify, .send_tx_power = iwl5000_send_tx_power, .temperature = iwl5000_temperature, + .update_chain_flags = iwl4965_update_chain_flags, .apm_ops = { .init = iwl5000_apm_init, .reset = iwl5000_apm_reset, |