diff options
Diffstat (limited to 'drivers/spi/spi-pxa2xx.c')
| -rw-r--r-- | drivers/spi/spi-pxa2xx.c | 38 |
1 files changed, 26 insertions, 12 deletions
diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c index b6ddba833d02..e59c8b27b155 100644 --- a/drivers/spi/spi-pxa2xx.c +++ b/drivers/spi/spi-pxa2xx.c @@ -884,10 +884,14 @@ static unsigned int ssp_get_clk_div(struct driver_data *drv_data, int rate) rate = min_t(int, ssp_clk, rate); + /* + * Calculate the divisor for the SCR (Serial Clock Rate), avoiding + * that the SSP transmission rate can be greater than the device rate + */ if (ssp->type == PXA25x_SSP || ssp->type == CE4100_SSP) - return (ssp_clk / (2 * rate) - 1) & 0xff; + return (DIV_ROUND_UP(ssp_clk, 2 * rate) - 1) & 0xff; else - return (ssp_clk / rate - 1) & 0xfff; + return (DIV_ROUND_UP(ssp_clk, rate) - 1) & 0xfff; } static unsigned int pxa2xx_ssp_get_clk_div(struct driver_data *drv_data, @@ -925,7 +929,7 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, { struct driver_data *drv_data = spi_controller_get_devdata(controller); struct spi_message *message = controller->cur_msg; - struct chip_data *chip = spi_get_ctldata(message->spi); + struct chip_data *chip = spi_get_ctldata(spi); u32 dma_thresh = chip->dma_threshold; u32 dma_burst = chip->dma_burst_size; u32 change_mask = pxa2xx_spi_get_ssrc1_change_mask(drv_data); @@ -943,21 +947,21 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, /* reject already-mapped transfers; PIO won't always work */ if (message->is_dma_mapped || transfer->rx_dma || transfer->tx_dma) { - dev_err(&drv_data->pdev->dev, + dev_err(&spi->dev, "Mapped transfer length of %u is greater than %d\n", transfer->len, MAX_DMA_LEN); return -EINVAL; } /* warn ... we force this to PIO mode */ - dev_warn_ratelimited(&message->spi->dev, + dev_warn_ratelimited(&spi->dev, "DMA disabled for transfer length %ld greater than %d\n", (long)transfer->len, MAX_DMA_LEN); } /* Setup the transfer state based on the type of transfer */ if (pxa2xx_spi_flush(drv_data) == 0) { - dev_err(&drv_data->pdev->dev, "Flush failed\n"); + dev_err(&spi->dev, "Flush failed\n"); return -EIO; } drv_data->n_bytes = chip->n_bytes; @@ -999,15 +1003,15 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, */ if (chip->enable_dma) { if (pxa2xx_spi_set_dma_burst_and_threshold(chip, - message->spi, + spi, bits, &dma_burst, &dma_thresh)) - dev_warn_ratelimited(&message->spi->dev, + dev_warn_ratelimited(&spi->dev, "DMA burst size reduced to match bits_per_word\n"); } dma_mapped = controller->can_dma && - controller->can_dma(controller, message->spi, transfer) && + controller->can_dma(controller, spi, transfer) && controller->cur_msg_mapped; if (dma_mapped) { @@ -1035,12 +1039,12 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, /* NOTE: PXA25x_SSP _could_ use external clocking ... */ cr0 = pxa2xx_configure_sscr0(drv_data, clk_div, bits); if (!pxa25x_ssp_comp(drv_data)) - dev_dbg(&message->spi->dev, "%u Hz actual, %s\n", + dev_dbg(&spi->dev, "%u Hz actual, %s\n", controller->max_speed_hz / (1 + ((cr0 & SSCR0_SCR(0xfff)) >> 8)), dma_mapped ? "DMA" : "PIO"); else - dev_dbg(&message->spi->dev, "%u Hz actual, %s\n", + dev_dbg(&spi->dev, "%u Hz actual, %s\n", controller->max_speed_hz / 2 / (1 + ((cr0 & SSCR0_SCR(0x0ff)) >> 8)), dma_mapped ? "DMA" : "PIO"); @@ -1333,6 +1337,9 @@ static int setup(struct spi_device *spi) dev_warn(&spi->dev, "in setup: DMA burst size reduced to match bits_per_word\n"); } + dev_dbg(&spi->dev, + "in setup: DMA burst size set to %u\n", + chip->dma_burst_size); } switch (drv_data->ssp_type) { @@ -1451,6 +1458,10 @@ static const struct pci_device_id pxa2xx_spi_pci_compound_match[] = { { PCI_VDEVICE(INTEL, 0xa32a), LPSS_CNL_SSP }, { PCI_VDEVICE(INTEL, 0xa32b), LPSS_CNL_SSP }, { PCI_VDEVICE(INTEL, 0xa37b), LPSS_CNL_SSP }, + /* CML-LP */ + { PCI_VDEVICE(INTEL, 0x02aa), LPSS_CNL_SSP }, + { PCI_VDEVICE(INTEL, 0x02ab), LPSS_CNL_SSP }, + { PCI_VDEVICE(INTEL, 0x02fb), LPSS_CNL_SSP }, { }, }; @@ -1564,6 +1575,7 @@ pxa2xx_spi_init_pdata(struct platform_device *pdev) pdata->is_slave = of_property_read_bool(pdev->dev.of_node, "spi-slave"); pdata->num_chipselect = 1; pdata->enable_dma = true; + pdata->dma_burst_size = 1; return pdata; } @@ -1692,7 +1704,7 @@ static int pxa2xx_spi_probe(struct platform_device *pdev) if (platform_info->enable_dma) { status = pxa2xx_spi_dma_setup(drv_data); if (status) { - dev_dbg(dev, "no DMA channels available, using PIO\n"); + dev_warn(dev, "no DMA channels available, using PIO\n"); platform_info->enable_dma = false; } else { controller->can_dma = pxa2xx_spi_can_dma; @@ -1953,3 +1965,5 @@ static void __exit pxa2xx_spi_exit(void) platform_driver_unregister(&driver); } module_exit(pxa2xx_spi_exit); + +MODULE_SOFTDEP("pre: dw_dmac"); |