diff options
Diffstat (limited to 'drivers/staging/rts5139/rts51x_chip.h')
| -rw-r--r-- | drivers/staging/rts5139/rts51x_chip.h | 95 |
1 files changed, 6 insertions, 89 deletions
diff --git a/drivers/staging/rts5139/rts51x_chip.h b/drivers/staging/rts5139/rts51x_chip.h index 13fc2a410d90..6d395b6533a8 100644 --- a/drivers/staging/rts5139/rts51x_chip.h +++ b/drivers/staging/rts5139/rts51x_chip.h @@ -39,12 +39,7 @@ #define SUPPORT_CPRM #define SUPPORT_MAGIC_GATE #define SUPPORT_MSXC -/* #define LED_AUTO_BLINK */ - -/* { wwang, 2010-07-26 - * Add support for SD lock/unlock */ -/* #define SUPPORT_SD_LOCK */ -/* } wwang, 2010-07-26 */ +#define USING_POLLING_CYCLE_DELINK #ifdef SUPPORT_MAGIC_GA /* Using NORMAL_WRITE instead of AUTO_WRITE to set ICVTE */ @@ -63,7 +58,6 @@ #define SUPPORT_OCP #define MS_SPEEDUP -/* #define XD_SPEEDUP */ #define SD_XD_IO_FOLLOW_PWR @@ -81,7 +75,6 @@ #define MAX_ALLOWED_LUN_CNT 8 #define CMD_BUF_LEN 1024 -#define RSP_BUF_LEN 1024 #define POLLING_INTERVAL 50 /* 50ms */ #define XD_FREE_TABLE_CNT 1200 @@ -128,8 +121,6 @@ #endif #define STATUS_FAIL 1 -#define STATUS_READ_FAIL 2 -#define STATUS_WRITE_FAIL 3 #define STATUS_TIMEDOUT 4 #define STATUS_NOMEM 5 #define STATUS_TRANS_SHORT 6 @@ -139,8 +130,6 @@ #define IDLE_MAX_COUNT 10 #define POLLING_WAIT_CNT 1 -#define DELINK_DELAY 100 -#define LED_TOGGLE_INTERVAL 6 #define LED_GPIO 0 /* package */ @@ -157,8 +146,6 @@ #define TRANSPORT_GOOD 0 /* Transport good, command failed */ #define TRANSPORT_FAILED 1 -/* Command failed, no auto-sense */ -#define TRANSPORT_NO_SENSE 2 /* Transport bad (i.e. device dead) */ #define TRANSPORT_ERROR 3 @@ -195,7 +182,6 @@ struct trace_msg_t { #define SENSE_TYPE_MEDIA_INVALID_CMD_FIELD 6 #define SENSE_TYPE_MEDIA_UNRECOVER_READ_ERR 7 #define SENSE_TYPE_MEDIA_WRITE_ERR 8 -#define SENSE_TYPE_FORMAT_IN_PROGRESS 9 #define SENSE_TYPE_FORMAT_CMD_FAILED 10 #ifdef SUPPORT_MAGIC_GATE /* COPY PROTECTION KEY EXCHANGE FAILURE - KEY NOT ESTABLISHED */ @@ -207,83 +193,27 @@ struct trace_msg_t { /* WRITE ERROR */ #define SENSE_TYPE_MG_WRITE_ERR 0x0e #endif -#ifdef SUPPORT_SD_LOCK -/* FOR Locked SD card */ -#define SENSE_TYPE_MEDIA_READ_FORBIDDEN 0x10 -#endif /*---- sense key ----*/ -#define ILI 0x20 /* ILI bit is on */ - -#define NO_SENSE 0x00 /* not exist sense key */ -#define RECOVER_ERR 0x01 /* Target/Logical unit is recoverd */ -#define NOT_READY 0x02 /* Logical unit is not ready */ -#define MEDIA_ERR 0x03 /* medium/data error */ -#define HARDWARE_ERR 0x04 /* hardware error */ #define ILGAL_REQ 0x05 /* CDB/parameter/identify msg error */ -#define UNIT_ATTENTION 0x06 /* unit attention condition occur */ -#define DAT_PRTCT 0x07 /* read/write is desable */ -#define BLNC_CHK 0x08 /* find blank/DOF in read */ - /* write to unblank area */ -#define CPY_ABRT 0x0a /* Copy/Compare/Copy&Verify illgal */ -#define ABRT_CMD 0x0b /* Target make the command in error */ -#define EQUAL 0x0c /* Search Data end with Equal */ -#define VLM_OVRFLW 0x0d /* Some data are left in buffer */ -#define MISCMP 0x0e /* find inequality */ /*----------------------------------- SENSE_DATA -----------------------------------*/ -/*---- valid ----*/ -#define SENSE_VALID 0x80 /* Sense data is valid as SCSI2 */ -#define SENSE_INVALID 0x00 /* Sense data is invalid as SCSI2 */ /*---- error code ----*/ #define CUR_ERR 0x70 /* current error */ -#define DEF_ERR 0x71 /* specific command error */ /*---- sense key Infomation ----*/ -#define SNSKEYINFO_LEN 3 /* length of sense key infomation */ #define SKSV 0x80 #define CDB_ILLEGAL 0x40 -#define DAT_ILLEGAL 0x00 -#define BPV 0x08 -#define BIT_ILLEGAL0 0 /* bit0 is illegal */ -#define BIT_ILLEGAL1 1 /* bit1 is illegal */ -#define BIT_ILLEGAL2 2 /* bit2 is illegal */ -#define BIT_ILLEGAL3 3 /* bit3 is illegal */ -#define BIT_ILLEGAL4 4 /* bit4 is illegal */ -#define BIT_ILLEGAL5 5 /* bit5 is illegal */ -#define BIT_ILLEGAL6 6 /* bit6 is illegal */ -#define BIT_ILLEGAL7 7 /* bit7 is illegal */ /*---- ASC ----*/ -#define ASC_NO_INFO 0x00 -#define ASC_MISCMP 0x1d #define ASC_INVLD_CDB 0x24 -#define ASC_INVLD_PARA 0x26 -#define ASC_LU_NOT_READY 0x04 -#define ASC_WRITE_ERR 0x0c -#define ASC_READ_ERR 0x11 -#define ASC_LOAD_EJCT_ERR 0x53 -#define ASC_MEDIA_NOT_PRESENT 0x3A -#define ASC_MEDIA_CHANGED 0x28 -#define ASC_MEDIA_IN_PROCESS 0x04 -#define ASC_WRITE_PROTECT 0x27 -#define ASC_LUN_NOT_SUPPORTED 0x25 /*---- ASQC ----*/ -#define ASCQ_NO_INFO 0x00 -#define ASCQ_MEDIA_IN_PROCESS 0x01 -#define ASCQ_MISCMP 0x00 #define ASCQ_INVLD_CDB 0x00 -#define ASCQ_INVLD_PARA 0x02 -#define ASCQ_LU_NOT_READY 0x02 -#define ASCQ_WRITE_ERR 0x02 -#define ASCQ_READ_ERR 0x00 -#define ASCQ_LOAD_EJCT_ERR 0x00 -#define ASCQ_WRITE_PROTECT 0x00 struct sense_data_t { unsigned char err_code; /* error code */ @@ -296,13 +226,13 @@ struct sense_data_t { unsigned char seg_no; /* segment No. */ unsigned char sense_key; /* byte5 : ILI */ /* bit3-0 : sense key */ - unsigned char info[4]; /* infomation */ + unsigned char info[4]; /* information */ unsigned char ad_sense_len; /* additional sense data length */ - unsigned char cmd_info[4]; /* command specific infomation */ + unsigned char cmd_info[4]; /* command specific information */ unsigned char asc; /* ASC */ unsigned char ascq; /* ASCQ */ unsigned char rfu; /* FRU */ - unsigned char sns_key_info[3]; /* sense key specific infomation */ + unsigned char sns_key_info[3]; /* sense key specific information */ }; /* sd_ctl bit map */ @@ -323,8 +253,6 @@ struct sense_data_t { #define SUPPORT_UHS50_MMC44 0x40 struct rts51x_option { - u8 led_blink_speed; - int mspro_formatter_enable; /* card clock expected by user for fpga platform */ @@ -368,8 +296,6 @@ struct rts51x_option { int ss_en; /* Interval to enter SS from IDLE state (second) */ int ss_delay; - int needs_remote_wakeup; - u8 ww_enable; /* sangdy2010-08-03:add for remote wakeup */ /* Enable SSC clock */ int ssc_en; @@ -392,10 +318,7 @@ struct rts51x_option { /*if reset or rw fail,then set SD20 pad drive again */ u8 reset_or_rw_fail_set_pad_drive; - u8 rcc_fail_flag; /* add to indicate whether rcc bug happen */ - u8 rcc_bug_fix_en; /* if set,then support fixing rcc bug */ u8 debounce_num; /* debounce number */ - int polling_time; /* polling delay time */ u8 led_toggle_interval; /* used to control led toggle speed */ int xd_rwn_step; u8 sd_send_status_en; @@ -405,7 +328,7 @@ struct rts51x_option { u8 ddr50_rx_phase; u8 sdr50_tx_phase; u8 sdr50_rx_phase; - /* used to enable select sdr50 tx phase according to proportion. */ + /* used to enable select sdr50 tx phase according to proportion. */ u8 sdr50_phase_sel; u8 ms_errreg_fix; u8 reset_mmc_first; @@ -614,11 +537,6 @@ struct sd_info { u8 sd_reset_fail; /* sangdy2010-07-01 */ u8 sd_send_status_en; -#ifdef SUPPORT_SD_LOCK - u8 sd_lock_status; - u8 sd_erase_status; - u8 sd_lock_notify; -#endif }; #define MODE_512_SEQ 0x01 @@ -720,9 +638,8 @@ struct rts51x_chip { struct scsi_cmnd *srb; struct sense_data_t sense_buffer[MAX_ALLOWED_LUN_CNT]; -#ifndef LED_AUTO_BLINK int led_toggle_counter; -#endif + int ss_counter; int idle_counter; int auto_delink_counter; |