diff options
Diffstat (limited to 'drivers/thermal/samsung/exynos_tmu.h')
| -rw-r--r-- | drivers/thermal/samsung/exynos_tmu.h | 77 |
1 files changed, 4 insertions, 73 deletions
diff --git a/drivers/thermal/samsung/exynos_tmu.h b/drivers/thermal/samsung/exynos_tmu.h index da3009bff6c4..4d71ec6c9aa0 100644 --- a/drivers/thermal/samsung/exynos_tmu.h +++ b/drivers/thermal/samsung/exynos_tmu.h @@ -23,16 +23,7 @@ #ifndef _EXYNOS_TMU_H #define _EXYNOS_TMU_H #include <linux/cpu_cooling.h> - -#include "exynos_thermal_common.h" - -enum calibration_type { - TYPE_ONE_POINT_TRIMMING, - TYPE_ONE_POINT_TRIMMING_25, - TYPE_ONE_POINT_TRIMMING_85, - TYPE_TWO_POINT_TRIMMING, - TYPE_NONE, -}; +#include <dt-bindings/thermal/thermal_exynos.h> enum soc_type { SOC_ARCH_EXYNOS3250 = 1, @@ -43,38 +34,11 @@ enum soc_type { SOC_ARCH_EXYNOS5420, SOC_ARCH_EXYNOS5420_TRIMINFO, SOC_ARCH_EXYNOS5440, + SOC_ARCH_EXYNOS7, }; /** * struct exynos_tmu_platform_data - * @threshold: basic temperature for generating interrupt - * 25 <= threshold <= 125 [unit: degree Celsius] - * @threshold_falling: differntial value for setting threshold - * of temperature falling interrupt. - * @trigger_levels: array for each interrupt levels - * [unit: degree Celsius] - * 0: temperature for trigger_level0 interrupt - * condition for trigger_level0 interrupt: - * current temperature > threshold + trigger_levels[0] - * 1: temperature for trigger_level1 interrupt - * condition for trigger_level1 interrupt: - * current temperature > threshold + trigger_levels[1] - * 2: temperature for trigger_level2 interrupt - * condition for trigger_level2 interrupt: - * current temperature > threshold + trigger_levels[2] - * 3: temperature for trigger_level3 interrupt - * condition for trigger_level3 interrupt: - * current temperature > threshold + trigger_levels[3] - * @trigger_type: defines the type of trigger. Possible values are, - * THROTTLE_ACTIVE trigger type - * THROTTLE_PASSIVE trigger type - * SW_TRIP trigger type - * HW_TRIP - * @trigger_enable[]: array to denote which trigger levels are enabled. - * 1 = enable trigger_level[] interrupt, - * 0 = disable trigger_level[] interrupt - * @max_trigger_level: max trigger level supported by the TMU - * @non_hw_trigger_levels: number of defined non-hardware trigger levels * @gain: gain of amplifier in the positive-TC generator block * 0 < gain <= 15 * @reference_voltage: reference voltage of amplifier @@ -86,24 +50,12 @@ enum soc_type { * @efuse_value: platform defined fuse value * @min_efuse_value: minimum valid trimming data * @max_efuse_value: maximum valid trimming data - * @first_point_trim: temp value of the first point trimming - * @second_point_trim: temp value of the second point trimming * @default_temp_offset: default temperature offset in case of no trimming * @cal_type: calibration type for temperature - * @freq_clip_table: Table representing frequency reduction percentage. - * @freq_tab_count: Count of the above table as frequency reduction may - * applicable to only some of the trigger levels. * * This structure is required for configuration of exynos_tmu driver. */ struct exynos_tmu_platform_data { - u8 threshold; - u8 threshold_falling; - u8 trigger_levels[MAX_TRIP_COUNT]; - enum trigger_type trigger_type[MAX_TRIP_COUNT]; - bool trigger_enable[MAX_TRIP_COUNT]; - u8 max_trigger_level; - u8 non_hw_trigger_levels; u8 gain; u8 reference_voltage; u8 noise_cancel_mode; @@ -115,30 +67,9 @@ struct exynos_tmu_platform_data { u8 second_point_trim; u8 default_temp_offset; - enum calibration_type cal_type; enum soc_type type; - struct freq_clip_table freq_tab[4]; - unsigned int freq_tab_count; -}; - -/** - * struct exynos_tmu_init_data - * @tmu_count: number of TMU instances. - * @tmu_data: platform data of all TMU instances. - * This structure is required to store data for multi-instance exynos tmu - * driver. - */ -struct exynos_tmu_init_data { - int tmu_count; - struct exynos_tmu_platform_data tmu_data[]; + u32 cal_type; + u32 cal_mode; }; -extern struct exynos_tmu_init_data const exynos3250_default_tmu_data; -extern struct exynos_tmu_init_data const exynos4210_default_tmu_data; -extern struct exynos_tmu_init_data const exynos4412_default_tmu_data; -extern struct exynos_tmu_init_data const exynos5250_default_tmu_data; -extern struct exynos_tmu_init_data const exynos5260_default_tmu_data; -extern struct exynos_tmu_init_data const exynos5420_default_tmu_data; -extern struct exynos_tmu_init_data const exynos5440_default_tmu_data; - #endif /* _EXYNOS_TMU_H */ |