diff options
Diffstat (limited to 'drivers/tty/serial/serial-tegra.c')
-rw-r--r-- | drivers/tty/serial/serial-tegra.c | 94 |
1 files changed, 39 insertions, 55 deletions
diff --git a/drivers/tty/serial/serial-tegra.c b/drivers/tty/serial/serial-tegra.c index 8de8bac9c6c7..b7170cb9a544 100644 --- a/drivers/tty/serial/serial-tegra.c +++ b/drivers/tty/serial/serial-tegra.c @@ -75,12 +75,17 @@ #define TEGRA_UART_FCR_IIR_FIFO_EN 0x40 /** - * tegra_uart_chip_data: SOC specific data. + * struct tegra_uart_chip_data: SOC specific data. * * @tx_fifo_full_status: Status flag available for checking tx fifo full. * @allow_txfifo_reset_fifo_mode: allow_tx fifo reset with fifo mode or not. * Tegra30 does not allow this. * @support_clk_src_div: Clock source support the clock divider. + * @fifo_mode_enable_status: Is FIFO mode enabled? + * @uart_max_port: Maximum number of UART ports + * @max_dma_burst_bytes: Maximum size of DMA bursts + * @error_tolerance_low_range: Lowest number in the error tolerance range + * @error_tolerance_high_range: Highest number in the error tolerance range */ struct tegra_uart_chip_data { bool tx_fifo_full_status; @@ -333,7 +338,7 @@ static void tegra_uart_fifo_reset(struct tegra_uart_port *tup, u8 fcr_bits) do { lsr = tegra_uart_read(tup, UART_LSR); - if ((lsr | UART_LSR_TEMT) && !(lsr & UART_LSR_DR)) + if ((lsr & UART_LSR_TEMT) && !(lsr & UART_LSR_DR)) break; udelay(1); } while (--tmout); @@ -436,19 +441,19 @@ static char tegra_uart_decode_rx_error(struct tegra_uart_port *tup, if (unlikely(lsr & TEGRA_UART_LSR_ANY)) { if (lsr & UART_LSR_OE) { - /* Overrrun error */ + /* Overrun error */ flag = TTY_OVERRUN; tup->uport.icount.overrun++; - dev_err(tup->uport.dev, "Got overrun errors\n"); + dev_dbg(tup->uport.dev, "Got overrun errors\n"); } else if (lsr & UART_LSR_PE) { /* Parity error */ flag = TTY_PARITY; tup->uport.icount.parity++; - dev_err(tup->uport.dev, "Got Parity errors\n"); + dev_dbg(tup->uport.dev, "Got Parity errors\n"); } else if (lsr & UART_LSR_FE) { flag = TTY_FRAME; tup->uport.icount.frame++; - dev_err(tup->uport.dev, "Got frame errors\n"); + dev_dbg(tup->uport.dev, "Got frame errors\n"); } else if (lsr & UART_LSR_BI) { /* * Break error @@ -520,7 +525,7 @@ static void tegra_uart_tx_dma_complete(void *args) count = tup->tx_bytes_requested - state.residue; async_tx_ack(tup->tx_dma_desc); spin_lock_irqsave(&tup->uport.lock, flags); - xmit->tail = (xmit->tail + count) & (UART_XMIT_SIZE - 1); + uart_xmit_advance(&tup->uport, count); tup->tx_in_progress = 0; if (uart_circ_chars_pending(xmit) < WAKEUP_CHARS) uart_write_wakeup(&tup->uport); @@ -608,7 +613,6 @@ static unsigned int tegra_uart_tx_empty(struct uart_port *u) static void tegra_uart_stop_tx(struct uart_port *u) { struct tegra_uart_port *tup = to_tegra_uport(u); - struct circ_buf *xmit = &tup->uport.state->xmit; struct dma_tx_state state; unsigned int count; @@ -619,7 +623,7 @@ static void tegra_uart_stop_tx(struct uart_port *u) dmaengine_tx_status(tup->tx_dma_chan, tup->tx_cookie, &state); count = tup->tx_bytes_requested - state.residue; async_tx_ack(tup->tx_dma_desc); - xmit->tail = (xmit->tail + count) & (UART_XMIT_SIZE - 1); + uart_xmit_advance(&tup->uport, count); tup->tx_in_progress = 0; } @@ -635,7 +639,7 @@ static void tegra_uart_handle_tx_pio(struct tegra_uart_port *tup) } static void tegra_uart_handle_rx_pio(struct tegra_uart_port *tup, - struct tty_port *tty) + struct tty_port *port) { do { char flag = TTY_NORMAL; @@ -653,16 +657,18 @@ static void tegra_uart_handle_rx_pio(struct tegra_uart_port *tup, ch = (unsigned char) tegra_uart_read(tup, UART_RX); tup->uport.icount.rx++; - if (!uart_handle_sysrq_char(&tup->uport, ch) && tty) - tty_insert_flip_char(tty, ch, flag); + if (uart_handle_sysrq_char(&tup->uport, ch)) + continue; if (tup->uport.ignore_status_mask & UART_LSR_DR) continue; + + tty_insert_flip_char(port, ch, flag); } while (1); } static void tegra_uart_copy_rx_to_tty(struct tegra_uart_port *tup, - struct tty_port *tty, + struct tty_port *port, unsigned int count) { int copied; @@ -672,17 +678,13 @@ static void tegra_uart_copy_rx_to_tty(struct tegra_uart_port *tup, return; tup->uport.icount.rx += count; - if (!tty) { - dev_err(tup->uport.dev, "No tty port\n"); - return; - } if (tup->uport.ignore_status_mask & UART_LSR_DR) return; dma_sync_single_for_cpu(tup->uport.dev, tup->rx_dma_buf_phys, count, DMA_FROM_DEVICE); - copied = tty_insert_flip_string(tty, + copied = tty_insert_flip_string(port, ((unsigned char *)(tup->rx_dma_buf_virt)), count); if (copied != count) { WARN_ON(1); @@ -878,7 +880,7 @@ static irqreturn_t tegra_uart_isr(int irq, void *data) tegra_uart_write(tup, ier, UART_IER); break; } - /* Fall through */ + fallthrough; case 2: /* Receive */ if (!tup->use_rx_pio) { is_rx_start = tup->rx_in_progress; @@ -1042,9 +1044,11 @@ static int tegra_uart_hw_init(struct tegra_uart_port *tup) if (tup->cdata->fifo_mode_enable_status) { ret = tegra_uart_wait_fifo_mode_enabled(tup); - dev_err(tup->uport.dev, "FIFO mode not enabled\n"); - if (ret < 0) + if (ret < 0) { + dev_err(tup->uport.dev, + "Failed to enable FIFO mode: %d\n", ret); return ret; + } } else { /* * For all tegra devices (up to t210), there is a hardware @@ -1075,7 +1079,7 @@ static int tegra_uart_hw_init(struct tegra_uart_port *tup) tup->rx_in_progress = 1; /* - * Enable IE_RXS for the receive status interrupts like line errros. + * Enable IE_RXS for the receive status interrupts like line errors. * Enable IE_RX_TIMEOUT to get the bytes which cannot be DMA'd. * * EORD is different interrupt than RX_TIMEOUT - RX_TIMEOUT occurs when @@ -1266,13 +1270,14 @@ static void tegra_uart_enable_ms(struct uart_port *u) } static void tegra_uart_set_termios(struct uart_port *u, - struct ktermios *termios, struct ktermios *oldtermios) + struct ktermios *termios, + const struct ktermios *oldtermios) { struct tegra_uart_port *tup = to_tegra_uport(u); unsigned int baud; unsigned long flags; unsigned int lcr; - int symb_bit = 1; + unsigned char char_bits; struct clk *parent_clk = clk_get_parent(tup->uart_clk); unsigned long parent_clk_rate = clk_get_rate(parent_clk); int max_divider = (tup->cdata->support_clk_src_div) ? 0x7FFF : 0xFFFF; @@ -1299,7 +1304,6 @@ static void tegra_uart_set_termios(struct uart_port *u, termios->c_cflag &= ~CMSPAR; if ((termios->c_cflag & PARENB) == PARENB) { - symb_bit++; if (termios->c_cflag & PARODD) { lcr |= UART_LCR_PARITY; lcr &= ~UART_LCR_EPAR; @@ -1311,38 +1315,19 @@ static void tegra_uart_set_termios(struct uart_port *u, } } + char_bits = tty_get_char_size(termios->c_cflag); lcr &= ~UART_LCR_WLEN8; - switch (termios->c_cflag & CSIZE) { - case CS5: - lcr |= UART_LCR_WLEN5; - symb_bit += 5; - break; - case CS6: - lcr |= UART_LCR_WLEN6; - symb_bit += 6; - break; - case CS7: - lcr |= UART_LCR_WLEN7; - symb_bit += 7; - break; - default: - lcr |= UART_LCR_WLEN8; - symb_bit += 8; - break; - } + lcr |= UART_LCR_WLEN(char_bits); /* Stop bits */ - if (termios->c_cflag & CSTOPB) { + if (termios->c_cflag & CSTOPB) lcr |= UART_LCR_STOP; - symb_bit += 2; - } else { + else lcr &= ~UART_LCR_STOP; - symb_bit++; - } tegra_uart_write(tup, lcr, UART_LCR); tup->lcr_shadow = lcr; - tup->symb_bit = symb_bit; + tup->symb_bit = tty_get_frame_size(termios->c_cflag); /* Baud rate. */ baud = uart_get_baud_rate(u, termios, oldtermios, @@ -1501,7 +1486,7 @@ static struct tegra_uart_chip_data tegra20_uart_chip_data = { .fifo_mode_enable_status = false, .uart_max_port = 5, .max_dma_burst_bytes = 4, - .error_tolerance_low_range = 0, + .error_tolerance_low_range = -4, .error_tolerance_high_range = 4, }; @@ -1512,7 +1497,7 @@ static struct tegra_uart_chip_data tegra30_uart_chip_data = { .fifo_mode_enable_status = false, .uart_max_port = 5, .max_dma_burst_bytes = 4, - .error_tolerance_low_range = 0, + .error_tolerance_low_range = -4, .error_tolerance_high_range = 4, }; @@ -1563,14 +1548,12 @@ static int tegra_uart_probe(struct platform_device *pdev) struct resource *resource; int ret; const struct tegra_uart_chip_data *cdata; - const struct of_device_id *match; - match = of_match_device(tegra_uart_of_match, &pdev->dev); - if (!match) { + cdata = of_device_get_match_data(&pdev->dev); + if (!cdata) { dev_err(&pdev->dev, "Error: No device match found\n"); return -ENODEV; } - cdata = match->data; tup = devm_kzalloc(&pdev->dev, sizeof(*tup), GFP_KERNEL); if (!tup) { @@ -1678,6 +1661,7 @@ static int __init tegra_uart_init(void) node = of_find_matching_node(NULL, tegra_uart_of_match); if (node) match = of_match_node(tegra_uart_of_match, node); + of_node_put(node); if (match) cdata = match->data; if (cdata) |