diff options
Diffstat (limited to 'include/linux/qcom-geni-se.h')
| -rw-r--r-- | include/linux/qcom-geni-se.h | 65 |
1 files changed, 62 insertions, 3 deletions
diff --git a/include/linux/qcom-geni-se.h b/include/linux/qcom-geni-se.h index dd464943f717..f5672785c0c4 100644 --- a/include/linux/qcom-geni-se.h +++ b/include/linux/qcom-geni-se.h @@ -6,11 +6,26 @@ #ifndef _LINUX_QCOM_GENI_SE #define _LINUX_QCOM_GENI_SE -/* Transfer mode supported by GENI Serial Engines */ +#include <linux/interconnect.h> + +/** + * enum geni_se_xfer_mode: Transfer modes supported by Serial Engines + * + * @GENI_SE_INVALID: Invalid mode + * @GENI_SE_FIFO: FIFO mode. Data is transferred with SE FIFO + * by programmed IO method + * @GENI_SE_DMA: Serial Engine DMA mode. Data is transferred + * with SE by DMAengine internal to SE + * @GENI_GPI_DMA: GPI DMA mode. Data is transferred using a DMAengine + * configured by a firmware residing on a GSI engine. This DMA name is + * interchangeably used as GSI or GPI which seem to imply the same DMAengine + */ + enum geni_se_xfer_mode { GENI_SE_INVALID, GENI_SE_FIFO, GENI_SE_DMA, + GENI_GPI_DMA, }; /* Protocols supported by GENI Serial Engines */ @@ -25,6 +40,17 @@ enum geni_se_protocol_type { struct geni_wrapper; struct clk; +enum geni_icc_path_index { + GENI_TO_CORE, + CPU_TO_GENI, + GENI_TO_DDR +}; + +struct geni_icc_path { + struct icc_path *path; + unsigned int avg_bw; +}; + /** * struct geni_se - GENI Serial Engine * @base: Base Address of the Serial Engine's register block @@ -33,6 +59,7 @@ struct clk; * @clk: Handle to the core serial engine clock * @num_clk_levels: Number of valid clock levels in clk_perf_tbl * @clk_perf_tbl: Table of clock frequency input to serial engine clock + * @icc_paths: Array of ICC paths for SE */ struct geni_se { void __iomem *base; @@ -41,6 +68,7 @@ struct geni_se { struct clk *clk; unsigned int num_clk_levels; unsigned long *clk_perf_tbl; + struct geni_icc_path icc_paths[3]; }; /* Common SE registers */ @@ -48,6 +76,7 @@ struct geni_se { #define SE_GENI_STATUS 0x40 #define GENI_SER_M_CLK_CFG 0x48 #define GENI_SER_S_CLK_CFG 0x4c +#define GENI_IF_DISABLE_RO 0x64 #define GENI_FW_REVISION_RO 0x68 #define SE_GENI_CLK_SEL 0x7c #define SE_GENI_DMA_MODE_EN 0x258 @@ -90,6 +119,9 @@ struct geni_se { #define CLK_DIV_MSK GENMASK(15, 4) #define CLK_DIV_SHFT 4 +/* GENI_IF_DISABLE_RO fields */ +#define FIFO_IF_DISABLE (BIT(0)) + /* GENI_FW_REVISION_RO fields */ #define FW_REV_PROTOCOL_MSK GENMASK(15, 8) #define FW_REV_PROTOCOL_SHFT 8 @@ -229,6 +261,24 @@ struct geni_se { #define GENI_SE_VERSION_MINOR(ver) ((ver & HW_VER_MINOR_MASK) >> HW_VER_MINOR_SHFT) #define GENI_SE_VERSION_STEP(ver) (ver & HW_VER_STEP_MASK) +/* QUP SE VERSION value for major number 2 and minor number 5 */ +#define QUP_SE_VERSION_2_5 0x20050000 + +/* + * Define bandwidth thresholds that cause the underlying Core 2X interconnect + * clock to run at the named frequency. These baseline values are recommended + * by the hardware team, and are not dynamically scaled with GENI bandwidth + * beyond basic on/off. + */ +#define CORE_2X_19_2_MHZ 960 +#define CORE_2X_50_MHZ 2500 +#define CORE_2X_100_MHZ 5000 +#define CORE_2X_150_MHZ 7500 +#define CORE_2X_200_MHZ 10000 +#define CORE_2X_236_MHZ 16383 + +#define GENI_DEFAULT_BW Bps_to_icc(1000) + #if IS_ENABLED(CONFIG_QCOM_GENI_SE) u32 geni_se_get_qup_hw_version(struct geni_se *se); @@ -262,7 +312,7 @@ static inline void geni_se_setup_m_cmd(struct geni_se *se, u32 cmd, u32 params) u32 m_cmd; m_cmd = (cmd << M_OPCODE_SHFT) | (params & M_PARAMS_MSK); - writel_relaxed(m_cmd, se->base + SE_GENI_M_CMD0); + writel(m_cmd, se->base + SE_GENI_M_CMD0); } /** @@ -282,7 +332,7 @@ static inline void geni_se_setup_s_cmd(struct geni_se *se, u32 cmd, u32 params) s_cmd &= ~(S_OPCODE_MSK | S_PARAMS_MSK); s_cmd |= (cmd << S_OPCODE_SHFT); s_cmd |= (params & S_PARAMS_MSK); - writel_relaxed(s_cmd, se->base + SE_GENI_S_CMD0); + writel(s_cmd, se->base + SE_GENI_S_CMD0); } /** @@ -416,5 +466,14 @@ int geni_se_rx_dma_prep(struct geni_se *se, void *buf, size_t len, void geni_se_tx_dma_unprep(struct geni_se *se, dma_addr_t iova, size_t len); void geni_se_rx_dma_unprep(struct geni_se *se, dma_addr_t iova, size_t len); + +int geni_icc_get(struct geni_se *se, const char *icc_ddr); + +int geni_icc_set_bw(struct geni_se *se); +void geni_icc_set_tag(struct geni_se *se, u32 tag); + +int geni_icc_enable(struct geni_se *se); + +int geni_icc_disable(struct geni_se *se); #endif #endif |