diff options
Diffstat (limited to 'include/linux/usb.h')
| -rw-r--r-- | include/linux/usb.h | 72 |
1 files changed, 39 insertions, 33 deletions
diff --git a/include/linux/usb.h b/include/linux/usb.h index e656e7b4b1e4..9ff1ad4dfad1 100644 --- a/include/linux/usb.h +++ b/include/linux/usb.h @@ -325,7 +325,7 @@ struct usb_interface_cache { /* variable-length array of alternate settings for this interface, * stored in no particular order */ - struct usb_host_interface altsetting[0]; + struct usb_host_interface altsetting[]; }; #define ref_to_usb_interface_cache(r) \ container_of(r, struct usb_interface_cache, ref) @@ -341,7 +341,7 @@ struct usb_interface_cache { * @interface: array of pointers to usb_interface structures, one for each * interface in the configuration. The number of interfaces is stored * in desc.bNumInterfaces. These pointers are valid only while the - * the configuration is active. + * configuration is active. * @intf_cache: array of pointers to usb_interface_cache structures, one * for each interface in the configuration. These structures exist * for the entire life of the device. @@ -422,7 +422,7 @@ struct usb_devmap { * Allocated per bus (tree of devices) we have: */ struct usb_bus { - struct device *controller; /* host/master side hardware */ + struct device *controller; /* host side hardware */ struct device *sysdev; /* as seen from firmware or bus */ int busnum; /* Bus number (in order of reg) */ const char *bus_name; /* stable id (PCI slot_name etc) */ @@ -473,12 +473,6 @@ struct usb_dev_state; struct usb_tt; -enum usb_device_removable { - USB_DEVICE_REMOVABLE_UNKNOWN = 0, - USB_DEVICE_REMOVABLE, - USB_DEVICE_FIXED, -}; - enum usb_port_connect_type { USB_PORT_CONNECT_TYPE_UNKNOWN = 0, USB_PORT_CONNECT_TYPE_HOT_PLUG, @@ -560,6 +554,7 @@ struct usb3_lpm_parameters { * @speed: device speed: high/full/low (or error) * @rx_lanes: number of rx lanes in use, USB 3.2 adds dual-lane support * @tx_lanes: number of tx lanes in use, USB 3.2 adds dual-lane support + * @ssp_rate: SuperSpeed Plus phy signaling rate and lane count * @tt: Transaction Translator info; used with low/full speed dev, highspeed hub * @ttport: device port on that tt hub * @toggle: one bit for each endpoint, with ([0] = IN, [1] = OUT) endpoints @@ -580,6 +575,7 @@ struct usb3_lpm_parameters { * @devaddr: device address, XHCI: assigned by HW, others: same as devnum * @can_submit: URBs may be submitted * @persist_enabled: USB_PERSIST enabled for this device + * @reset_in_progress: the device is being reset * @have_langid: whether string_langid is valid * @authorized: policy has said we can use it; * (user space) policy determines if we authorize this device to be @@ -589,6 +585,7 @@ struct usb3_lpm_parameters { * @authenticated: Crypto authentication passed * @wusb: device is Wireless USB * @lpm_capable: device supports LPM + * @lpm_devinit_allow: Allow USB3 device initiated LPM, exit latency is in range * @usb2_hw_lpm_capable: device can perform USB2 hardware LPM * @usb2_hw_lpm_besl_capable: device can perform USB2 hardware BESL LPM * @usb2_hw_lpm_enabled: USB2 hardware LPM is enabled @@ -620,9 +617,9 @@ struct usb3_lpm_parameters { * Management to be disabled for this usb_device. This count should only * be manipulated by those functions, with the bandwidth_mutex is held. * @hub_delay: cached value consisting of: - * parent->hub_delay + wHubDelay + tTPTransmissionDelay (40ns) - * + * parent->hub_delay + wHubDelay + tTPTransmissionDelay (40ns) * Will be used as wValue for SetIsochDelay requests. + * @use_generic_driver: ask driver core to reprobe using the generic driver. * * Notes: * Usbcore drivers should not set usbdev->state directly. Instead use @@ -636,6 +633,7 @@ struct usb_device { enum usb_device_speed speed; unsigned int rx_lanes; unsigned int tx_lanes; + enum usb_ssp_rate ssp_rate; struct usb_tt *tt; int ttport; @@ -665,11 +663,13 @@ struct usb_device { unsigned can_submit:1; unsigned persist_enabled:1; + unsigned reset_in_progress:1; unsigned have_langid:1; unsigned authorized:1; unsigned authenticated:1; unsigned wusb:1; unsigned lpm_capable:1; + unsigned lpm_devinit_allow:1; unsigned usb2_hw_lpm_capable:1; unsigned usb2_hw_lpm_besl_capable:1; unsigned usb2_hw_lpm_enabled:1; @@ -701,13 +701,13 @@ struct usb_device { #endif struct wusb_dev *wusb_dev; int slot_id; - enum usb_device_removable removable; struct usb2_lpm_parameters l1_params; struct usb3_lpm_parameters u1_params; struct usb3_lpm_parameters u2_params; unsigned lpm_disable_count; u16 hub_delay; + unsigned use_generic_driver:1; }; #define to_usb_device(d) container_of(d, struct usb_device, dev) @@ -745,6 +745,8 @@ extern int usb_lock_device_for_reset(struct usb_device *udev, extern int usb_reset_device(struct usb_device *dev); extern void usb_queue_reset_device(struct usb_interface *dev); +extern struct device *usb_intf_get_dma_device(struct usb_interface *intf); + #ifdef CONFIG_ACPI extern int usb_acpi_set_power_state(struct usb_device *hdev, int index, bool enable); @@ -838,7 +840,7 @@ extern int usb_free_streams(struct usb_interface *interface, /* used these for multi-interface device registration */ extern int usb_driver_claim_interface(struct usb_driver *driver, - struct usb_interface *iface, void *priv); + struct usb_interface *iface, void *data); /** * usb_interface_claimed - returns true iff an interface is claimed @@ -1214,6 +1216,7 @@ struct usb_driver { * struct usb_device_driver - identifies USB device driver to usbcore * @name: The driver name should be unique among USB drivers, * and should normally be the same as the module name. + * @match: If set, used for better device/driver matching. * @probe: Called to see if the driver is willing to manage a particular * device. If it is, probe returns zero and uses dev_set_drvdata() * to associate driver-specific data with the device. If unwilling @@ -1226,14 +1229,21 @@ struct usb_driver { * @dev_groups: Attributes attached to the device that will be created once it * is bound to the driver. * @drvwrap: Driver-model core structure wrapper. + * @id_table: used with @match() to select better matching driver at + * probe() time. * @supports_autosuspend: if set to 0, the USB core will not allow autosuspend * for devices bound to this driver. + * @generic_subclass: if set to 1, the generic USB driver's probe, disconnect, + * resume and suspend functions will be called in addition to the driver's + * own, so this part of the setup does not need to be replicated. * - * USB drivers must provide all the fields listed above except drvwrap. + * USB drivers must provide all the fields listed above except drvwrap, + * match, and id_table. */ struct usb_device_driver { const char *name; + bool (*match) (struct usb_device *udev); int (*probe) (struct usb_device *udev); void (*disconnect) (struct usb_device *udev); @@ -1241,13 +1251,13 @@ struct usb_device_driver { int (*resume) (struct usb_device *udev, pm_message_t message); const struct attribute_group **dev_groups; struct usbdrv_wrap drvwrap; + const struct usb_device_id *id_table; unsigned int supports_autosuspend:1; + unsigned int generic_subclass:1; }; #define to_usb_device_driver(d) container_of(d, struct usb_device_driver, \ drvwrap.driver) -extern struct bus_type usb_bus_type; - /** * struct usb_class_driver - identifies a USB driver that wants to use the USB major number * @name: the usb class device name for this driver. Will show up in sysfs. @@ -1463,7 +1473,7 @@ typedef void (*usb_complete_t)(struct urb *); * * Note that transfer_buffer must still be set if the controller * does not support DMA (as indicated by hcd_uses_dma()) and when talking - * to root hub. If you have to trasfer between highmem zone and the device + * to root hub. If you have to transfer between highmem zone and the device * on such controller, create a bounce buffer or bail out with an error. * If transfer_buffer cannot be set (is in highmem) and the controller is DMA * capable, assign NULL to it, so that usbmon knows not to use the value. @@ -1582,7 +1592,7 @@ struct urb { int error_count; /* (return) number of ISO errors */ void *context; /* (in) context for completion */ usb_complete_t complete; /* (in) completion routine */ - struct usb_iso_packet_descriptor iso_frame_desc[0]; + struct usb_iso_packet_descriptor iso_frame_desc[]; /* (in) ISO ONLY */ }; @@ -1753,6 +1763,7 @@ static inline int usb_urb_dir_out(struct urb *urb) return (urb->transfer_flags & URB_DIR_MASK) == URB_DIR_OUT; } +int usb_pipe_type_check(struct usb_device *dev, unsigned int pipe); int usb_urb_ep_type_check(const struct urb *urb); void *usb_alloc_coherent(struct usb_device *dev, size_t size, @@ -1790,6 +1801,14 @@ extern int usb_bulk_msg(struct usb_device *usb_dev, unsigned int pipe, int timeout); /* wrappers around usb_control_msg() for the most common standard requests */ +int usb_control_msg_send(struct usb_device *dev, __u8 endpoint, __u8 request, + __u8 requesttype, __u16 value, __u16 index, + const void *data, __u16 size, int timeout, + gfp_t memflags); +int usb_control_msg_recv(struct usb_device *dev, __u8 endpoint, __u8 request, + __u8 requesttype, __u16 value, __u16 index, + void *data, __u16 size, int timeout, + gfp_t memflags); extern int usb_get_descriptor(struct usb_device *dev, unsigned char desctype, unsigned char descindex, void *buf, int size); extern int usb_get_status(struct usb_device *dev, @@ -1954,21 +1973,10 @@ usb_pipe_endpoint(struct usb_device *dev, unsigned int pipe) return eps[usb_pipeendpoint(pipe)]; } -/*-------------------------------------------------------------------------*/ - -static inline __u16 -usb_maxpacket(struct usb_device *udev, int pipe, int is_out) +static inline u16 usb_maxpacket(struct usb_device *udev, int pipe) { - struct usb_host_endpoint *ep; - unsigned epnum = usb_pipeendpoint(pipe); + struct usb_host_endpoint *ep = usb_pipe_endpoint(udev, pipe); - if (is_out) { - WARN_ON(usb_pipein(pipe)); - ep = udev->ep_out[epnum]; - } else { - WARN_ON(usb_pipeout(pipe)); - ep = udev->ep_in[epnum]; - } if (!ep) return 0; @@ -1976,8 +1984,6 @@ usb_maxpacket(struct usb_device *udev, int pipe, int is_out) return usb_endpoint_maxp(&ep->desc); } -/* ----------------------------------------------------------------------- */ - /* translate USB error codes to codes user space understands */ static inline int usb_translate_errors(int error_code) { |