| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
We need to configure the interconnect target module based on the
device three configuration.
Let's also add a new quirk for SYSC_QUIRK_RESET_STATUS to indicate
that the SYSCONFIG reset bit changes after the reset is done.
Signed-off-by: Tony Lindgren <tony@atomide.com>
|
|
Let's configure few module quirks via device tree using the
properties for "ti,no-idle-on-init", "ti,no-reset-on-init"
and "ti,sysc-delay-us".
Let's also reorder the probe a bit so we have pdata available
earlier, and move the PM runtime calls to sysc_init_module()
from sysc_read_revision().
Signed-off-by: Tony Lindgren <tony@atomide.com>
|
|
We can easily detect i2c based on it's non-standard module registers that
consist of two 32-bit registers accessed in 16-bit mode.
So far we don't have other 16-bit modules, so there's currently no need
to add a custom property for 16-bit register access.
Signed-off-by: Tony Lindgren <tony@atomide.com>
|
|
Let's add data for the known interconnect target module types by mapping
their register bits.
Note that we can handle many quirks for the older omap2 type1 modules
directly in the driver without a need for adding custom properties.
Signed-off-by: Tony Lindgren <tony@atomide.com>
|
|
We want to be able to configure hwmod sysc data from ti-sysc driver using
platform data callbacks. So let's make struct omap_hwmod_sysc_fields into
struct sysc_data and have it available for both ti-sysc driver and hwmod
code.
Note that we can make it use s8 instead of u8 as the hwmod code uses the
feature flags to check for this field. However, for ti-sysc we can use
-ENODEV to indicate a feature is not supported in the hardware and can
simplify the code that way.
And let's add also emufree_shift as the dts files will be describing the
hardware for the SYSCONFIG register capbilities mask.
Cc: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
|
Tony Lindgren