blob: 04e234e9acc9bcc040390d05ab866fd87de28995 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
|
Devlink configuration parameters
================================
Following is the list of configuration parameters via devlink interface.
Each parameter can be generic or driver specific and are device level
parameters.
Note that the driver-specific files should contain the generic params
they support to, with supported config modes.
Each parameter can be set in different configuration modes:
runtime - set while driver is running, no reset required.
driverinit - applied while driver initializes, requires restart
driver by devlink reload command.
permanent - written to device's non-volatile memory, hard reset
required.
Following is the list of parameters:
====================================
enable_sriov [DEVICE, GENERIC]
Enable Single Root I/O Virtualisation (SRIOV) in
the device.
Type: Boolean
ignore_ari [DEVICE, GENERIC]
Ignore Alternative Routing-ID Interpretation (ARI)
capability. If enabled, adapter will ignore ARI
capability even when platforms has the support
enabled and creates same number of partitions when
platform does not support ARI.
Type: Boolean
msix_vec_per_pf_max [DEVICE, GENERIC]
Provides the maximum number of MSIX interrupts that
a device can create. Value is same across all
physical functions (PFs) in the device.
Type: u32
msix_vec_per_pf_min [DEVICE, GENERIC]
Provides the minimum number of MSIX interrupts required
for the device initialization. Value is same across all
physical functions (PFs) in the device.
Type: u32
fw_load_policy [DEVICE, GENERIC]
Controls the device's firmware loading policy.
Valid values:
* DEVLINK_PARAM_FW_LOAD_POLICY_VALUE_DRIVER (0)
Load firmware version preferred by the driver.
* DEVLINK_PARAM_FW_LOAD_POLICY_VALUE_FLASH (1)
Load firmware currently stored in flash.
* DEVLINK_PARAM_FW_LOAD_POLICY_VALUE_DISK (2)
Load firmware currently available on host's disk.
Type: u8
reset_dev_on_drv_probe [DEVICE, GENERIC]
Controls the device's reset policy on driver probe.
Valid values:
* DEVLINK_PARAM_RESET_DEV_ON_DRV_PROBE_VALUE_UNKNOWN (0)
Unknown or invalid value.
* DEVLINK_PARAM_RESET_DEV_ON_DRV_PROBE_VALUE_ALWAYS (1)
Always reset device on driver probe.
* DEVLINK_PARAM_RESET_DEV_ON_DRV_PROBE_VALUE_NEVER (2)
Never reset device on driver probe.
* DEVLINK_PARAM_RESET_DEV_ON_DRV_PROBE_VALUE_DISK (3)
Reset only if device firmware can be found in the
filesystem.
Type: u8
enable_roce [DEVICE, GENERIC]
Enable handling of RoCE traffic in the device.
Type: Boolean
|
