diff options
| -rw-r--r-- | drivers/mtd/nand/raw/davinci_nand.c | 70 | ||||
| -rw-r--r-- | include/linux/platform_data/mtd-davinci-aemif.h | 36 | ||||
| -rw-r--r-- | include/linux/platform_data/mtd-davinci.h | 88 |
3 files changed, 65 insertions, 129 deletions
diff --git a/drivers/mtd/nand/raw/davinci_nand.c b/drivers/mtd/nand/raw/davinci_nand.c index 051deea768db..392678143a36 100644 --- a/drivers/mtd/nand/raw/davinci_nand.c +++ b/drivers/mtd/nand/raw/davinci_nand.c @@ -20,8 +20,71 @@ #include <linux/slab.h> #include <linux/of.h> -#include <linux/platform_data/mtd-davinci.h> -#include <linux/platform_data/mtd-davinci-aemif.h> +#define NRCSR_OFFSET 0x00 +#define NANDFCR_OFFSET 0x60 +#define NANDFSR_OFFSET 0x64 +#define NANDF1ECC_OFFSET 0x70 + +/* 4-bit ECC syndrome registers */ +#define NAND_4BIT_ECC_LOAD_OFFSET 0xbc +#define NAND_4BIT_ECC1_OFFSET 0xc0 +#define NAND_4BIT_ECC2_OFFSET 0xc4 +#define NAND_4BIT_ECC3_OFFSET 0xc8 +#define NAND_4BIT_ECC4_OFFSET 0xcc +#define NAND_ERR_ADD1_OFFSET 0xd0 +#define NAND_ERR_ADD2_OFFSET 0xd4 +#define NAND_ERR_ERRVAL1_OFFSET 0xd8 +#define NAND_ERR_ERRVAL2_OFFSET 0xdc + +/* NOTE: boards don't need to use these address bits + * for ALE/CLE unless they support booting from NAND. + * They're used unless platform data overrides them. + */ +#define MASK_ALE 0x08 +#define MASK_CLE 0x10 + +struct davinci_nand_pdata { + uint32_t mask_ale; + uint32_t mask_cle; + + /* + * 0-indexed chip-select number of the asynchronous + * interface to which the NAND device has been connected. + * + * So, if you have NAND connected to CS3 of DA850, you + * will pass '1' here. Since the asynchronous interface + * on DA850 starts from CS2. + */ + uint32_t core_chipsel; + + /* for packages using two chipselects */ + uint32_t mask_chipsel; + + /* board's default static partition info */ + struct mtd_partition *parts; + unsigned int nr_parts; + + /* none == NAND_ECC_ENGINE_TYPE_NONE (strongly *not* advised!!) + * soft == NAND_ECC_ENGINE_TYPE_SOFT + * else == NAND_ECC_ENGINE_TYPE_ON_HOST, according to ecc_bits + * + * All DaVinci-family chips support 1-bit hardware ECC. + * Newer ones also support 4-bit ECC, but are awkward + * using it with large page chips. + */ + enum nand_ecc_engine_type engine_type; + enum nand_ecc_placement ecc_placement; + u8 ecc_bits; + + /* e.g. NAND_BUSWIDTH_16 */ + unsigned int options; + /* e.g. NAND_BBT_USE_FLASH */ + unsigned int bbt_options; + + /* Main and mirror bbt descriptor overrides */ + struct nand_bbt_descr *bbt_td; + struct nand_bbt_descr *bbt_md; +}; /* * This is a device driver for the NAND flash controller found on the @@ -54,8 +117,6 @@ struct davinci_nand_info { uint32_t mask_cle; uint32_t core_chipsel; - - struct davinci_aemif_timing *timing; }; static DEFINE_SPINLOCK(davinci_nand_lock); @@ -775,7 +836,6 @@ static int nand_davinci_probe(struct platform_device *pdev) info->chip.options = pdata->options; info->chip.bbt_td = pdata->bbt_td; info->chip.bbt_md = pdata->bbt_md; - info->timing = pdata->timing; info->current_cs = info->vaddr; info->core_chipsel = pdata->core_chipsel; diff --git a/include/linux/platform_data/mtd-davinci-aemif.h b/include/linux/platform_data/mtd-davinci-aemif.h deleted file mode 100644 index a49826214a39..000000000000 --- a/include/linux/platform_data/mtd-davinci-aemif.h +++ /dev/null @@ -1,36 +0,0 @@ -/* - * TI DaVinci AEMIF support - * - * Copyright 2010 (C) Texas Instruments, Inc. https://www.ti.com/ - * - * This file is licensed under the terms of the GNU General Public License - * version 2. This program is licensed "as is" without any warranty of any - * kind, whether express or implied. - */ -#ifndef _MACH_DAVINCI_AEMIF_H -#define _MACH_DAVINCI_AEMIF_H - -#include <linux/platform_device.h> - -#define NRCSR_OFFSET 0x00 -#define AWCCR_OFFSET 0x04 -#define A1CR_OFFSET 0x10 - -#define ACR_ASIZE_MASK 0x3 -#define ACR_EW_MASK BIT(30) -#define ACR_SS_MASK BIT(31) - -/* All timings in nanoseconds */ -struct davinci_aemif_timing { - u8 wsetup; - u8 wstrobe; - u8 whold; - - u8 rsetup; - u8 rstrobe; - u8 rhold; - - u8 ta; -}; - -#endif diff --git a/include/linux/platform_data/mtd-davinci.h b/include/linux/platform_data/mtd-davinci.h deleted file mode 100644 index dd474dd44848..000000000000 --- a/include/linux/platform_data/mtd-davinci.h +++ /dev/null @@ -1,88 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0-or-later */ -/* - * mach-davinci/nand.h - * - * Copyright © 2006 Texas Instruments. - * - * Ported to 2.6.23 Copyright © 2008 by - * Sander Huijsen <Shuijsen@optelecom-nkf.com> - * Troy Kisky <troy.kisky@boundarydevices.com> - * Dirk Behme <Dirk.Behme@gmail.com> - * - * -------------------------------------------------------------------------- - */ - -#ifndef __ARCH_ARM_DAVINCI_NAND_H -#define __ARCH_ARM_DAVINCI_NAND_H - -#include <linux/mtd/rawnand.h> - -#define NANDFCR_OFFSET 0x60 -#define NANDFSR_OFFSET 0x64 -#define NANDF1ECC_OFFSET 0x70 - -/* 4-bit ECC syndrome registers */ -#define NAND_4BIT_ECC_LOAD_OFFSET 0xbc -#define NAND_4BIT_ECC1_OFFSET 0xc0 -#define NAND_4BIT_ECC2_OFFSET 0xc4 -#define NAND_4BIT_ECC3_OFFSET 0xc8 -#define NAND_4BIT_ECC4_OFFSET 0xcc -#define NAND_ERR_ADD1_OFFSET 0xd0 -#define NAND_ERR_ADD2_OFFSET 0xd4 -#define NAND_ERR_ERRVAL1_OFFSET 0xd8 -#define NAND_ERR_ERRVAL2_OFFSET 0xdc - -/* NOTE: boards don't need to use these address bits - * for ALE/CLE unless they support booting from NAND. - * They're used unless platform data overrides them. - */ -#define MASK_ALE 0x08 -#define MASK_CLE 0x10 - -struct davinci_nand_pdata { /* platform_data */ - uint32_t mask_ale; - uint32_t mask_cle; - - /* - * 0-indexed chip-select number of the asynchronous - * interface to which the NAND device has been connected. - * - * So, if you have NAND connected to CS3 of DA850, you - * will pass '1' here. Since the asynchronous interface - * on DA850 starts from CS2. - */ - uint32_t core_chipsel; - - /* for packages using two chipselects */ - uint32_t mask_chipsel; - - /* board's default static partition info */ - struct mtd_partition *parts; - unsigned nr_parts; - - /* none == NAND_ECC_ENGINE_TYPE_NONE (strongly *not* advised!!) - * soft == NAND_ECC_ENGINE_TYPE_SOFT - * else == NAND_ECC_ENGINE_TYPE_ON_HOST, according to ecc_bits - * - * All DaVinci-family chips support 1-bit hardware ECC. - * Newer ones also support 4-bit ECC, but are awkward - * using it with large page chips. - */ - enum nand_ecc_engine_type engine_type; - enum nand_ecc_placement ecc_placement; - u8 ecc_bits; - - /* e.g. NAND_BUSWIDTH_16 */ - unsigned options; - /* e.g. NAND_BBT_USE_FLASH */ - unsigned bbt_options; - - /* Main and mirror bbt descriptor overrides */ - struct nand_bbt_descr *bbt_td; - struct nand_bbt_descr *bbt_md; - - /* Access timings */ - struct davinci_aemif_timing *timing; -}; - -#endif /* __ARCH_ARM_DAVINCI_NAND_H */ |